P.S. Free & New SD-WAN-Engineer dumps are available on Google Drive shared by ITExamSimulator: https://drive.google.com/open?id=1hcAxMw5N7KsaHUcKLw_jtkXw1Xgjk57Y
Therefore, make the most of this opportunity of getting these superb exam questions for the Palo Alto Networks SD-WAN Engineer certification exam. We guarantee you that our top-rated Palo Alto Networks SD-WAN-Engineer Practice Exam (PDF, desktop practice test software, and web-based practice exam) will enable you to pass the SD-WAN-Engineer certification exam on the very first go.
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
>> New Palo Alto Networks SD-WAN-Engineer Dumps Questions <<
They work together and strive hard to design and maintain the top standard of Palo Alto Networks SD-WAN-Engineer exam questions. So you rest assured that the SD-WAN-Engineer exam questions you will not only ace your Palo Alto Networks SD-WAN Engineer certification exam preparation but also be ready to perform well in the final SD-WAN-Engineer Certification Exam. The SD-WAN-Engineer exam are the real SD-WAN-Engineer exam practice questions that will surely repeat in the upcoming Palo Alto Networks SD-WAN Engineer (SD-WAN-Engineer) exam and you can easily pass the exam.
NEW QUESTION # 62
When troubleshooting an issue at a site that is running on two cellular links from two carriers, the operations team shared some evidence shown in the graph below:
(SNR Graph showing Carrier-1 in blue dropping to near 0 dB and Carrier-2 in green staying relatively stable between 4.5 dB and 6.5 dB)
For the time duration shown in the graph, what are two inferences about the site's traffic that can be made?
(Choose two.)
Answer: A,D
Explanation:
In Prisma SD-WAN, the Signal-to-Noise Ratio (SNR) is a critical metric used to monitor the health and performance of cellular WAN interfaces. SNR measures the strength of the desired signal relative to the background noise level; higher values indicate a cleaner signal, while lower values suggest that noise is overwhelming the signal, typically leading to increased packet loss, high latency, and reduced throughput.
Analyzing the provided graph, Carrier-1 (blue line) shows a severe drop in SNR, plummeting from approximately 4.5 dB to nearly 0.3 dB between 15:00 and 23:00. An SNR value this low is indicative of a failing or highly unstable link that cannot reliably sustain data traffic, directly supporting Inference A-that Carrier-1 experienced significant performance degradation. In contrast, Carrier-2 (green line) maintains a much higher and more consistent SNR throughout the same period.
Prisma SD-WAN's AppFabric uses application-based path selection and SLA monitoring to ensure the best possible user experience. When the system detects that a primary path (like Carrier-1) has degraded below acceptable thresholds-often triggered by high loss or latency resulting from poor signal quality-it will dynamically steer application flows to an alternative healthy path. Therefore, Inference D is correct: because Carrier-1's quality became untenable while Carrier-2 remained stable, the ION device would have likely initiated a path switchover to move traffic from the degraded Carrier-1 to the healthier Carrier-2.
NEW QUESTION # 63
In the Prisma SD-WAN portal, an administrator is viewing the "Media" analytics for a branch site to troubleshoot complaints about poor voice quality.
When calculating the Mean Opinion Score (MOS) for voice traffic, which two metrics does the system prioritize active monitoring for, even when no user voice traffic is present on the link? (Choose two.)
Answer: A,C
Explanation:
Comprehensive and Detailed Explanation
Prisma SD-WAN calculates the Mean Opinion Score (MOS) to provide a standardized metric (1-5) for voice quality. To ensure the system always knows the "voice readiness" of a path-even before a call starts-it uses Active Probes (synthetic UDP packets).
While latency is measured, the MOS calculation algorithm is most heavily penalized by Packet Loss (D) and Jitter (B).
Packet Loss: Even a small amount of loss (e.g., >1%) dramatically reduces voice clarity, causing dropouts.
Jitter: High variance in packet arrival time (jitter) causes the "robotic" voice effect and buffer underruns.
The system continuously measures these specific metrics on all WAN links using synthetic probes. If the packet loss or jitter exceeds the threshold defined in the "Path Quality Profile" (e.g., Voice Profile), the path is marked as non-compliant, and the MOS score drops, triggering a policy action to move the flow. Throughput (C) is less critical for voice as calls consume very little bandwidth (e.g., 64-100 Kbps), making congestion (loss/jitter) the primary enemy, not raw speed.
NEW QUESTION # 64
A site has two internet circuits: Circuit A with 500 Mbps capacity and Circuit B with 100 Mbps capacity.
Which path policy configuration will ensure traffic is automatically shifted from a saturated circuit to the circuit with available bandwidth?
Answer: D
Explanation:
Comprehensive and Detailed Explanation
In Prisma SD-WAN (CloudGenix), Path Policies control how application traffic is steered across WAN links. To ensure that traffic is automatically shifted from a saturated circuit to another circuit with available bandwidth, both circuits must be configured as Active Paths within the policy rule.
When multiple paths are designated as "Active," the ION device treats them as a shared pool of available resources. The system continuously monitors the bandwidth utilization (capacity) and health (latency, jitter, loss) of all active links. If "Circuit A" (500 Mbps) becomes saturated or approaches its defined bandwidth limit, the ION's intelligent scheduler will automatically direct new application flows to "Circuit B" (100 Mbps) because it is a valid, healthy Active path with available capacity. This achieves effective load balancing and bandwidth aggregation.
In contrast, configuring "Circuit B" as a Backup Path (Option A or B) creates a strict priority relationship. Traffic would only move to the Backup path if the Active path completely failed or violated its configured SLA (Path Quality Profile) significantly enough to be considered "down." Mere bandwidth saturation might not trigger an SLA failure immediately, potentially leading to dropped packets on the saturated link while the backup link remains idle. Therefore, placing Both circuits under active path is the correct configuration for dynamic capacity management.
NEW QUESTION # 65
What is the default action for real-time media applications if link performance is poor?
Answer: A
Explanation:
Comprehensive and Detailed Explanation
According to the Prisma SD-WAN Performance Policy Default Behavior documentation, the default action configured for applications (including real-time media) when a path experiences poor performance (violates the SLA thresholds for latency, jitter, or packet loss) is to Move Flows.
The Prisma SD-WAN ION device continuously monitors the health of all available paths. If the active path for a media application degrades and fails to meet the specified SLA, the default policy dictates that the traffic should be steered (moved) to an alternate, compliant path that meets the performance criteria.
While Forward Error Correction (FEC) is a powerful feature available in Prisma SD-WAN to mitigate packet loss for real-time applications, it is an optional action that must be explicitly enabled or configured within the performance policy rules. It is not the default action in the base system configuration; the primary default mechanism for handling performance issues is to leverage the multi-path fabric to switch to a better link.
NEW QUESTION # 66
Which component of Prisma SD-WAN is responsible for distributing User-IP and user-group mappings to branch devices that match the corresponding source IPs?
Answer: C
Explanation:
In the Prisma SD-WAN architecture, the Controller serves as the centralized management and control plane for the entire fabric. While the Cloud Identity Engine (CIE) is the component responsible for collecting and consolidating user-to-IP mappings from various identity providers (such as Active Directory, Okta, or Azure AD), it does not directly manage the distribution of this operational data to the individual ION devices at the branch level.
Instead, the Prisma SD-WAN Controller integrates with the Cloud Identity Engine to ingest these identity mappings. Once the Controller has synchronized the User-IP and user-group information, it acts as the primary orchestrator. It is responsible for distributing these mappings down to the ION devices across all sites. This distribution ensures that when an ION device sees traffic from a specific source IP, it can accurately associate that traffic with a specific user or group based on the metadata provided by the Controller.
By centralizing this distribution through the Controller, Prisma SD-WAN ensures consistency across the network. Branch ION devices can then apply Application-Based Path Selection and security policies based on user identity rather than just IP addresses. This architectural design offloads the processing requirements of maintaining direct connections to identity providers from the branch hardware, allowing the Controller to handle the heavy lifting of orchestration and global synchronization of identity data.
NEW QUESTION # 67
......
ITExamSimulator has designed Palo Alto Networks SD-WAN Engineer (SD-WAN-Engineer) pdf dumps format that is easy to use. Anyone can download the Palo Alto Networks SD-WAN-Engineer pdf questions file and use it from any location or at any time. Palo Alto Networks PDF Questions files can be used on laptops, tablets, and smartphones. Moreover, you will get actual Palo Alto Networks SD-WAN Engineer (SD-WAN-Engineer) exam questions in this Palo Alto Networks SD-WAN-Engineer pdf dumps file. These Palo Alto Networks SD-WAN-Engineer exam questions have a high chance of coming in the actual SD-WAN-Engineer test. You have to memorize these SD-WAN-Engineer questions and you will pass the Palo Alto Networks SD-WAN Engineer (SD-WAN-Engineer) test with brilliant results.
New SD-WAN-Engineer Exam Format: https://www.itexamsimulator.com/SD-WAN-Engineer-brain-dumps.html
P.S. Free & New SD-WAN-Engineer dumps are available on Google Drive shared by ITExamSimulator: https://drive.google.com/open?id=1hcAxMw5N7KsaHUcKLw_jtkXw1Xgjk57Y