JPTestKing製品の3つのバージョンを使用して、93-Tall-Mass-Timber-Buildings学習の質問は、PDFとソフトウェアとAPPバージョンの異なる用途を持つ顧客の異なる好みと好みを満たすことができますInternational Code Council。 質問の曖昧な点があなたを混乱させることなく、私たちの練習資料はあなたの試験に適した内容の本質を伝えることができます。 最も科学的な内容と専門的な資料93-Tall-Mass-Timber-Buildings準備資料は、成功に不可欠です。 リーズナブルな価格でこのような価値ある買収があなたの目の前で提供され、あなたは十分に活用することを確信することができます。
| Section | Objectives |
|---|---|
| Mass Timber Materials | - CLT, Glulam, NLT, SCL and Engineered Wood Products |
| General & Construction Types | - Construction Classification — Type IV-A, IV-B, IV-C
|
| Fire-Resistance & Protection | - Concealed Spaces Protection - Noncombustible Protection & Encapsulation - Fire-Resistance-Rated Assemblies |
| Construction Fire Safety | |
| Structural & Connection Inspection | - Connection Design and Protection - Framing and Structural Elements |
| Inspection Duties & Documentation | - Inspection Reporting and Compliance Verification - Statement of Special Inspections |
>> 93-Tall-Mass-Timber-Buildings日本語版参考資料 <<
大量の時間と金銭をかかるのに比べて、正しい仕方は肝心なことです。もしあなたはInternational Code Council 93-Tall-Mass-Timber-Buildings試験に準備しているなら、あんたのための整理される備考資料はあなたにとって最善のオプションです。我々の目標はあなたに試験にうまく合格させることです。弊社の誠意を信じてもらいたいし、International Code Council 93-Tall-Mass-Timber-Buildings試験2成功するのを祈って願います。
質問 # 56
The fire-resistance of a protected mass timber assembly is equivalent to the fire resistance time of the:
正解：D
解説：
IBC Section 722.7 establishes the governing calculation principle for protected mass timber. The required fire resistance consists of the inherent fire resistance of the unprotected mass timber element plus the protection time contributed by the noncombustible protection . Therefore, option D is correct.
This approach recognizes two sequential protective mechanisms. First, the noncombustible covering delays heating and charring of the timber. After the credited protection period, the remaining mass timber cross section provides structural fire resistance through predictable charring behavior and residual section capacity.
Section 722.7.1 further requires the contribution of the covering material to comply with the prescribed protection times or to be established under Section 703.6.
Option A ignores the contribution of the protective membrane. Option B ignores the inherent structural fire resistance of the timber. Option C incorrectly substitutes a finish rating for the code-recognized protection contribution. A finish rating is a separate temperature-based performance concept and is not automatically additive as the protection time used by Section 722.7.
References/Topics: 2021 IBC Sections 602.4, 703.6, 722.7 and 722.7.1; calculation of protected mass timber fire resistance.
質問 # 57
The maximum allowable height for a Group E building of Type IV-A construction with an automatic sprinkler system in accordance with Section 903.3.1.1 is _____ stories.
正解：A
解説：
The controlling provision is 2021 IBC Section 504.4 and Table 504.4, which establish the allowable number of stories above grade plane according to occupancy classification, construction type, and sprinkler protection.
The question identifies three controlling variables: Group E occupancy, Type IV-A construction, and an NFPA 13 automatic sprinkler system installed in accordance with Section 903.3.1.1.
In the Group E row, the sprinklered "S" value for Type IV-A construction is nine stories above grade plane.
Therefore, option D is correct. The three-story value applies to the nonsprinklered Type IV-A condition and must not be used because the question expressly states that the building is sprinklered. The six-story value corresponds to Type IV-B construction under the same sprinklered Group E condition, while the four-story value-although not listed as an answer-would apply to Type IV-C.
The special inspector should distinguish the story limitation in Table 504.4 from the separate building-height- in-feet limitation in Table 504.3. Both requirements apply concurrently; compliance with one does not permit the other to be exceeded.
References/Topics: 2021 IBC Section 504.4; Table 504.4, Group E, sprinklered Type IV-A construction; Section 903.3.1.1.
質問 # 58
Where Type X gypsum board serves as noncombustible protection for interior surfaces of wall and ceiling assemblies, all of the following code provisions are correct except:
正解：D
解説：
Option D is the incorrect statement. IBC Section 722.7.2.1 requires the panel edges of the face layer , rather than the base layer, to be taped and finished with joint compound. Fastener heads on the face layer must also be covered with joint compound.
The other three provisions accurately reproduce the code. Each gypsum-board layer must be secured with Type S drywall screws long enough to penetrate the mass timber at least 1 inch when driven flush. Screws for the base layer are installed at 12 inches on center in both directions . Subsequent layers use the same general spacing but are offset from screws in the preceding layer. In addition, the panel edges of each succeeding layer must be offset 18 inches from the panel edges of the previous layer.
These details are not merely workmanship recommendations. They form part of the installation conditions under which the protection contributions in Table 722.7.1(2) can be credited.
References/Topics: 2021 IBC Section 722.7.2.1, Items 1-9; fastening, panel-edge offset, and finishing of Type X gypsum protection.
質問 # 59
Buildings of Types IV-A, IV-B, and IV-C construction designed to be greater than six stories above grade plane shall meet which of the following requirements for fire safety practices during construction?
正解：A
解説：
The 2021 IFC specifically requires standpipes to be provided in accordance with Section 3313 for Type IV-A, IV-B, and IV-C buildings designed to exceed six stories above grade plane. Therefore, option A is correct.
The code also requires a water supply for fire department operations, but it must be approved by the fire code official and fire chief; it is not described as a mandatory "portable water supply." This makes option B inaccurate. Where noncombustible protection is required, at least one layer-not two layers-must be installed on applicable building elements more than four levels below active mass timber construction before additional levels are erected. Option D therefore overstates the number of layers.
Required exterior wall coverings must similarly be installed more than four levels below active mass timber construction. Option C incorrectly substitutes two levels for the prescribed four-level threshold.
These provisions limit the amount of unprotected combustible construction exposed at one time and provide the fire department with usable suppression infrastructure as erection progresses. Inspection coordination should verify standpipe extension, hose-connection accessibility, water availability, the progression of passive protection, and exterior-wall covering installation.
References/Topics: 2021 IFC Section 3308.4 and Section 3313; fire safety during construction of tall mass timber buildings.
質問 # 60
A proprietary field-glued mass timber beam splice will require which of the following:
正解：D
解説：
A proprietary field-glued mass timber beam splice requires special inspection because the connection relies on a field-applied adhesive process that is not covered as a routine prescriptive mass timber connection in Table
1705.5.3. The controlling mechanism is IBC Section 1705.1.1, which authorizes the building official to require special inspection for unusual materials, systems, or installation procedures, particularly where compliance depends on additional manufacturer installation instructions.
The ICC code-development rationale for the tall mass timber provisions specifically identifies field-glued mass timber beam or panel splices as an example of work for which special inspection can be required.
Inspection must address the approved evaluation report and manufacturer's instructions, including substrate preparation, moisture and temperature limits, adhesive storage and expiration, mixing or proportioning, application quantity, open time, member alignment, clamping or pressure, and curing conditions.
Approval by the permit applicant has no regulatory significance. Verification by the registered design professional may supplement the inspection program but does not replace the approved special inspector. A building official may observe the work, but routine field verification by that official is not the prescribed quality-control procedure.
References/Topics: 2021 IBC Sections 1704.2, 1704.3 and 1705.1.1; special cases; proprietary field-glued mass timber splices.
質問 # 61
......
International Code Council 93-Tall-Mass-Timber-Buildings学習教材を選んだら、93-Tall-Mass-Timber-Buildings試験に落ちた人は少ないです。何故というと、93-Tall-Mass-Timber-Buildings学習教材の合格率が高いからです。93-Tall-Mass-Timber-Buildings学習教材は多くの人から好評をもらいました。そのほかに、93-Tall-Mass-Timber-Buildings学習教材は三種類があります。自分の好みによって選択できます。とても便利で、使い安いです。
93-Tall-Mass-Timber-Buildings問題集無料: https://www.jptestking.com/93-Tall-Mass-Timber-Buildings-exam.html