참고: ITDumpsKR에서 Google Drive로 공유하는 무료, 최신 FCSS_NST_SE-7.6 시험 문제집이 있습니다: https://drive.google.com/open?id=1xQMDaMbYBFQ2dyvlgtzkSVQ_A_yuZpm8
ITDumpsKR의 Fortinet FCSS_NST_SE-7.6덤프는 Fortinet FCSS_NST_SE-7.6시험문제변경에 따라 주기적으로 업데이트를 진행하여 덤프가 항상 가장 최신버전이도록 업데이트를 진행하고 있습니다.구매한 Fortinet FCSS_NST_SE-7.6덤프가 업데이트되면 저희측에서 자동으로 구매시 사용한 메일주소에 업데이트된 최신버전을 발송해드리는데 해당 덤프의 구매시간이 1년미만인 분들은 업데이트서비스를 받을수 있습니다.
| 주제 | 소개 |
|---|---|
| 주제 1 |
|
| 주제 2 |
|
| 주제 3 |
|
| 주제 4 |
|
| 주제 5 |
|
>> FCSS_NST_SE-7.6인증시험 덤프자료 <<
ITDumpsKR의Fortinet인증 FCSS_NST_SE-7.6시험대비 덤프는 가격이 착한데 비하면 품질이 너무 좋은 시험전 공부자료입니다. 시험문제적중율이 높아 패스율이 100%에 이르고 있습니다.다른 IT자격증에 관심이 있는 분들은 온라인서비스에 문의하여 덤프유무와 적중율등을 확인할수 있습니다. Fortinet인증 FCSS_NST_SE-7.6덤프로 어려운 시험을 정복하여 IT업계 정상에 오릅시다.
질문 # 85
Which Iwo actions does FortiGate take after an administrator enables the auxiliary session selling? (Choose two.)
정답：B,C
설명：
When the "auxiliary session" setting is enabled (typically via config system npu or implicitly for ECMP on NP6/NP7 processors), the FortiGate alters how it manages sessions to support hardware offloading for traffic that might switch interfaces (like ECMP or SD-WAN).
B). FortiGate accelerates all ECMP traffic to the NP6 processor:
The primary purpose of enabling auxiliary sessions is to ensure that ECMP traffic can be fully offloaded (accelerated) by the NPU. Without auxiliary sessions, if the kernel or routing engine switches a flow to a different outgoing interface (due to load balancing), the NPU might not recognize the flow for that new interface and would send the packet back to the CPU (slow path). Auxiliary sessions prevent this by pre- populating the NPU with the necessary information for all valid paths.
D). FortiGate creates two sessions in case of a routing change:
Technically, the FortiGate creates the primary session (for the currently selected path) and an auxiliary session (for the alternative path). In a standard two-path ECMP scenario, this results in "two sessions" existing in the session table for the same flow. This ensures that if a routing change occurs (e.g., the flow shifts to the second path), the traffic continues to be processed by the NPU without interruption or re- evaluation by the CPU.
질문 # 86
Refer to the exhibit, which shows the output of a debug command.
Which two statements about the output are true? (Choose two.)
정답：A,D
질문 # 87
What are two reasons you might see iprope_in check () check failed, drop when using the debug How?
(Choose two.)
정답：B,D
설명：
The debug flow message iprope_in_check() check failed, drop specifically indicates a failure in the Local-In Policy check. The "iprope" (IP ROouting Policy Enforcement) engine handles policy lookups. The _in_check suffix confirms that the decision is regarding traffic destined to the FortiGate itself (Local-In traffic), rather than traffic passing through it.
D). The packet was dropped because the requested service is not enabled on FortiGate:
This is the most common cause. When a packet arrives destined for the FortiGate's interface IP (e.g., an HTTPS or SSH request), the kernel checks if that specific service is enabled in the interface settings (set allowaccess). If the service is not enabled (e.g., trying to Ping an interface where PING access is disabled), the iprope_in_check function fails and drops the packet immediately.
C). The packet was dropped because the trusted host list is misconfigured:
Even if the service (e.g., HTTPS) is enabled on the interface, the FortiGate checks the Administrator settings.
If Trusted Hosts are configured, the source IP of the incoming packet is compared against the allowed list. If the IP is not on the list, the Local-In policy check (iprope_in_check) fails, and the packet is dropped to secure the management plane.
Why other options are incorrect:
A: If traffic is dropped by a standard Firewall Policy (traffic passing through the device from one interface to another), the debug message will typically state denied by policy x or no matching policy. It would generally be a forward check (iprope_fwd_check or similar), not an _in_check.
B: If there is no route to the source, the error is a Reverse Path Forwarding (RPF) failure. The debug flow logs this explicitly as reverse path check fail, drop.
Reference:
FortiGate Troubleshooting Guide (Debug Flow): "The message iprope_in_check() check failed indicates the packet was denied by the Local-In policy. This occurs when traffic destined to the FortiGate is not allowed by the allowaccess configuration or is blocked by Trusted Host settings."
질문 # 88
Refer to the exhibit, which shows the output o! the BGP database.
Which two statements are correct? (Choose two.)
정답：A,D
설명：
* For Option A:In Fortinet BGP (and standard BGP), when a prefix is displayed with an "i" (lowercase i) in the Path column, it represents an internal prefix that originated from the local router, typically configured via the BGP "network" command. In the exhibit, the prefix 10.20.30.0/24 is listed with a Path value of i, indicating it was injected into BGP by the local router using the network statement, not via redistribution from another routing protocol. The same logic applies to i as documented: "Origin code 'i' means the route was injected via the network command."
* For Option D:The get router info bgp network output is a summary table displaying both local and received BGP routes. It lists all known routes to the BGP process, whether received from peers or originated locally. The exhibit shows all BGP prefixes known to the local router, matching the official admin guide's description of this command's output.
* Explanation for B and C:
* The phrase "legacy route advertisement" is not formalized in BGP documentation or Fortinet's admin guide; the output uses standard BGP mechanics.
* If a route was redistributed into BGP from another routing protocol, the Path field would display a "?" (question mark) for incomplete (redistributed) origin. Here the /24 route has "i" so it is NOT a redistribution.
References:
FortiOS Administration Guide: BGP Configuration and Route Table Interpretation Official BGP Command Reference: Show BGP Network, Path Codes, Route Origination Indicators
질문 # 89
In which two slates is a given session categorized as ephemeral? (Choose two.)
정답：B,D
설명：
The study guide states:
"FortiGate categorizes an entry in the session table as an ephemeral session when it is a TCP session that is not fully established (three-way handshake not completed), or when it is a UDP session with only one packet received." This directly proves:
* A is correct because a UDP session with only one packet received is ephemeral.
* C is correct because a TCP session waiting for the SYN/ACK is not fully established , so it is ephemeral. The study guide's TCP state table shows that the handshake is only completed when the session reaches ESTABLISHED Why the other options are wrong:
* B is wrong because once UDP traffic has been seen in both directions , it is no longer the "single packet received" condition described for ephemeral sessions. The study guide says for UDP: 00 = one way , 01 = both ways
* D is wrong because a TCP session waiting for FIN/ACK is already in the closing stage after establishment, not in the "not fully established" stage. The study guide explains that after both sides close the session, FortiGate can keep it briefly in the table in state value 5 for out-of-order packets after FIN/ACK
질문 # 90
......
ITDumpsKR 의 학습가이드에는Fortinet FCSS_NST_SE-7.6인증시험의 예상문제, 시험문제와 답입니다. 그리고 중요한 건 시험과 매우 유사한 시험문제와 답도 제공해드립니다. ITDumpsKR 을 선택하면 ITDumpsKR 는 여러분을 빠른시일내에 시험관련지식을 터득하게 할 것이고Fortinet FCSS_NST_SE-7.6인증시험도 고득점으로 패스하게 해드릴 것입니다.
FCSS_NST_SE-7.6시험준비자료: https://www.itdumpskr.com/FCSS_NST_SE-7.6-exam.html
그 외, ITDumpsKR FCSS_NST_SE-7.6 시험 문제집 일부가 지금은 무료입니다: https://drive.google.com/open?id=1xQMDaMbYBFQ2dyvlgtzkSVQ_A_yuZpm8