2026 Die neuesten ZertSoft JN0-364 PDF-Versionen Prüfungsfragen und JN0-364 Fragen und Antworten sind kostenlos verfügbar: https://drive.google.com/open?id=1LFVj0_GqkOTEqXuxmgZL7Jbd6X2Z_xxp
Nach dem Entstehen der Dumps zur Juniper JN0-364 Zertifizierungsprüfung ist es kein Traum der IT-Fachleuten mehr, die Juniper JN0-364 Zertifizierungsprüfung zu bestehen. Die Qualität der Prüfungsfragen und Antworten zur Juniper JN0-364 Zertifizierungsprüfung von ZertSoft ist hoch. Die Ähnlichkeit mit den realen Fragen beträgt 95%. ZertSoft ist Ihnen doch besitzenswert. Wenn Sie die Produkte von ZertSoft wählen, heißt das, dass Sie sich gut auf die Juniper JN0-364 Zertifizierungsprüfung vorbereitet haben. Ohne Zweifel können Sie die Juniper JN0-364 Prüfung sicher bestehen.
| Section | Objectives |
|---|---|
| Protocol-Independent Routing | - Demonstrate knowledge of how to configure, monitor, or troubleshoot various protocol-independent routing components
|
| Spanning Tree Protocols | - Identify the concepts, operation, or functionality of STP
|
| Intermediate System to Intermediate System (IS-IS) | - Identify the concepts, operation, or functionality of IS-IS
|
| Layer 2 Bridging or VLANs | - Identify the concepts, operation, or functionality of Layer 2 bridging for the Junos OS
|
| Border Gateway Protocol (BGP) | - Demonstrate knowledge of how to configure, monitor, or troubleshoot BGP
|
| Open Shortest Path First (OSPF) | - Identify the concepts, operation, or functionality of OSPF
|
| Multiprotocol Label Switching (MPLS) | - Demonstrate knowledge of how to configure, monitor, or troubleshoot MPLS
|
| IPv6 | - Identify the concepts, operation, or functionality of IPv6
|
ZertSoft ist eine Website, die Fragenkataloge zur JN0-364 -Zertifizierungsprüfung bietet. Seine Erfolgsquote beträgt 100%. Das ist der Grund dafür, warum viele Kandiadaten ZertSoft glauben. ZertSoft kümmert sich immer um die Bedürfnisse der Kandidaten unf versuchen, ihre Bedürfnisse abzudecken. Mit ZertSoft werden Sie sicher eine glänzende Zukunft haben.
22. Frage
You are asked to configure the OSPF environment to prevent the DRother routers from participating in DR/BDR election.
Referring to the exhibit, which command will accomplish this task?
Antwort: B
Begründung:
To prevent a router from participating in the OSPF designated router (DR) and backup designated router (BDR) election process, you set the OSPF priority to 0 on the interfaces of that router. This tells OSPF that the router on those interfaces is not to be considered for election as either DR or BDR, effectively making them DRother routers. The exhibit indicates that this is the desired configuration, and therefore the correct command to issue on the Juniper device would be to set the priority to 0 on the relevant interfaces.
23. Frage
When would you use the qualified-next-hop statement with a static route?
Antwort: A
Begründung:
Qualified next hops allow you to associate one or more properties with a particular next-hop address. You can set an overall preference for a particular static route and then specify a different preference for the qualified next hop. For example, suppose two next-hop addresses (10.10.10.10 and 10.10.10.7) are associated with the static route 192.168.47.5/32. A general preference is assigned to the entire static route, and then a different preference is assigned to only the qualified next-hop address 10.10.10.7. For example:
The qualified-next-hop statement with a static route is used to specify multiple next hops for a static route with different preferences (priorities). This allows for more granular control over the path selection process in the event that the primary next hop becomes unreachable.
24. Frage
Which two statements regarding GRE and IP-IP tunnels are correct? (Choose two.)
Antwort: A,B
Begründung:
GRE and IP-IP tunnels encapsulate the original packet inside a new IP header, which increases the packet size and therefore adds additional overhead to the transmitted packets.
These tunneling mechanisms do not provide encryption. They only encapsulate packets for transport across another network, so separate technologies such as IPsec are required if encryption is needed.
25. Frage
Referring to the exhibit. Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)
Antwort: B,D
Begründung:
In MPLS, multiple paths can be merged if they share the same egress router. In the given scenario, traffic from Network 1 to Network 3 and Network 4 can be engineered to follow the same label- switched path (LSP) within the MPLS network until they reach the last common point before diverging to their respective destinations.
As for R3 performing label operations, in a typical MPLS network, intermediate routers (like R3) perform label swapping. They replace the incoming label with a new label before forwarding the packet along the LSP. A label pop operation is typically performed by the egress router in the case of an ultimate hop pop (UHP), where it removes the MPLS label before delivering the packet to the final destination outside the MPLS domain.
26. Frage
Which IS-IS packet type will establish and maintain neighbor relationships?
Antwort: C
Begründung:
In theIS-IS (Intermediate System to Intermediate System)protocol, communication between routers is performed usingProtocol Data Units (PDUs). To discover neighbors and maintain adjacencies, IS-IS relies on theHello PDU (IIH - IS-IS Hello).
According to Juniper Networks technical documentation, when IS-IS is enabled on an interface, the router begins transmitting Hello PDUs to a multi-destination address (multicast). These PDUs contain essential information such as the router'sSystem ID, its configuredArea Addresses, and itsLevel capability(Level 1, Level 2, or both). For two routers to become neighbors, they must exchange these Hello PDUs and agree on specific parameters, such as the MTU of the link and the hello/hold timers.
Once an adjacency is established, the Hello PDU serves as a "keepalive" mechanism. If a router stops receiving Hello PDUs from a neighbor for a duration exceeding theHolding Time, it assumes the neighbor is down and flushes the associated Link-State PDUs (LSPs) from its database.
To clarify the other options:
* Link-State PDU (Option A):These are used to distribute actual topology and reachability information, not to form adjacencies.
* Partial Sequence Number PDU (Option C):PSNPs are used on point-to-point links to acknowledge the receipt of LSPs or to request missing LSPs.
* Update PDU (Option D):This is not a standard IS-IS term; in IS-IS, updates are handled via the flooding of LSPs.
27. Frage
......
Um die Juniper JN0-364 Zertifizierungsprüfung zu bestehen, wählen Sie doch unseren ZertSoft. Sie werden sicher nicht bereuen, dass Sie mit so wenigem Geld die Prüfung bestehen können. Unser ZertSoft wird Ihnen helfen, sich auf die Prüfung gut vorzubereiten und die Juniper JN0-364 Zertifizierungsprüfung (Service Provider Routing and Switching, Specialist (JNCIS-SP)) erfolgreich zu bestehen. Außerdem bieten wir Ihnen kostenlos einen einjährigen Update-Service.
JN0-364 Dumps Deutsch: https://www.zertsoft.com/JN0-364-pruefungsfragen.html
P.S. Kostenlose und neue JN0-364 Prüfungsfragen sind auf Google Drive freigegeben von ZertSoft verfügbar: https://drive.google.com/open?id=1LFVj0_GqkOTEqXuxmgZL7Jbd6X2Z_xxp