我們Fast2test免費更新我們研究的培訓材料，這意味著你將隨時得到最新的更新的M2考試認證培訓資料，只要M2考試的目標有了變化，我們Fast2test提供的學習材料也會跟著變化，我們Fast2test知道每個考生的需求，我們將幫助你通過你的M2考試認證，以最優惠最實在的價格和最高超的品質來幫助每位考生，讓你們順利獲得認證。
| Section | Weight | Objectives |
|---|---|---|
| Topic 1: General Administration | 18% | - Manufacturer's instructions and listings - Permits and inspections - Code authority and enforcement - Plan review and documentation |
| Topic 2: Duct Systems | 12% | - Dampers and access doors - Insulation and sealing - Duct installation and supports - Duct construction and materials |
| Topic 3: Fuel Supply Systems | 10% | - Piping testing and inspection - Pressure regulation and overpressure protection - Fuel gas piping materials and installation - Gas appliances and connections |
| Topic 4: Heating, Cooling & Water Heaters | 18% | - Heat pumps and cooling equipment - Boilers and hydronic systems - Solar thermal systems - Water heaters and storage tanks - HVAC equipment installation and clearance |
| Topic 5: Chimneys & Vents | 14% | - Clearances and termination requirements - Chimney construction and materials - Factory-built chimneys and vents - Vent systems and connections |
| Topic 6: Combustion Air | 8% | - Air supply and venting - Confined spaces and equipment rooms - Combustion air requirements |
| Topic 7: Exhaust & Ventilation Systems | 20% | - Hazardous and special exhaust systems - Commercial kitchen exhaust systems - Ventilation rates and outdoor air requirements - Makeup air systems |
我們Fast2test提供下載的International Code Council的M2的問題範例，使你購買無風險的過程，這是一個使用版的練習題，讓你看得到介面的友好，問題的品質，以及在你決定購買之前的價值，我們有信心，我們Fast2test International Code Council的M2的樣品足以定性，成為讓你滿意的產品。為了保證你的權益，Fast2test承諾一次不過，將退還購買費用。我們的目的是不僅僅使你通過IT考試，更希望你能成為一名真正的IT認證專家，為你的求職增加砝碼，獲得與自身技術水準相符的技術崗位，輕鬆的跨入IT白領階層獲取高薪。
問題 #19
When testing dampers located in corridors, the dampers shall demonstrate acceptable closure performance when subjected to _____ fpm velocity across the face of the damper using the UL 555 fire exposure test.
答案：A
解題說明：
Corridor damper testing under the referenced standard requires acceptable closure performance at 150 fpm across the face of the damper. Therefore Option C is correct.
問題 #20
Given: a six-story, sprinklered, multifamily building with a continuously ventilated shaft extending vertically from the first floor to the roof and used for exhaust.
Which of the following requirements must also be met?
答案：B
解題說明：
For this type of continuously ventilated exhaust shaft serving a multifamily building, the code requires the kitchen exhaust connection to penetrate the shaft and extend vertically not less than 22 inches without a fire damper. That matches Option D .
問題 #21
Supports for hazardous exhaust duct shall be constructed of:
答案：D
解題說明：
Hazardous exhaust systems are regulated under the IMC provisions for special exhaust because they handle potentially dangerous fumes, vapors, dusts, or other contaminants. The code requires the duct system and its support components to be suitable for that hazard level, and supports for hazardous exhaust duct must be constructed of noncombustible material . That is why Option C is correct. Plastic and fibrous supports would not satisfy the required fire and safety performance, and UL 181 applies to certain factory-made air ducts and connectors, not as the governing support-material rule for hazardous exhaust duct supports.
問題 #22
Unless listed for a greater or smaller dimension, mechanical draft venting systems shall terminate a minimum of _____ feet below an openable window.
答案：B
解題說明：
For mechanical draft venting systems, unless the appliance is listed for a different clearance, the vent terminal must be located not less than 4 feet below , 4 feet horizontally from , or 1 foot above any door, operable window, or gravity air inlet into a building. Therefore, the required minimum distance below an openable window is 4 feet , so Option B is correct.
問題 #23
Shutoff valves in plastic pipe ground-source heat pump loop systems shall be installed on both sides of which one of the following?
答案：A
解題說明：
In the IMC hydronic piping provisions for ground-source heat pump loop systems, shutoff valves are required on both sides of a pressure-reducing valve . That matches D . Heat-fusion joints and change-in-material joints do not trigger this two-sided shutoff-valve requirement.
問題 #24
......
Fast2test是個為International Code Council M2認證考試提供短期有效培訓的網站。International Code Council M2 是個能對生活有改變的認證考試。拿到International Code Council M2 認證證書的IT人士肯定比沒有拿人員工資高，職位上升空間也很大，在IT行業中職業發展前景也更廣。
M2題庫資料: https://tw.fast2test.com/M2-premium-file.html