Huawei H35-580_V2.0인증시험인기덤프문제 & H35-580_V2.0덤프최신자료

인터넷에는Huawei인증 H35-580_V2.0시험대비공부자료가 헤아릴수 없을 정도로 많습니다.이렇게 많은Huawei인증 H35-580_V2.0공부자료중 대부분 분들께서 저희Fast2test를 선택하는 이유는 덤프 업데이트가 다른 사이트보다 빠르다는 것이 제일 큰 이유가 아닐가 싶습니다. Fast2test의 Huawei인증 H35-580_V2.0덤프를 구매하시면 덤프가 업데이트되면 무료로 업데이트된 버전을 제공받을수 있습니다.

Huawei H35-580_V2.0 시험은 네트워크 슬라이싱, 엣지 컴퓨팅 및 대규모 MIMO를 비롯한 최신 5G 기술을 기반으로 합니다. 이 시험은 5G 네트워크 아키텍처, 무선 접속 기술, 네트워크 계획 및 최적화, 네트워크 성능 분석 및 문제 해결 등 다양한 주제를 다룹니다. 시험은 또한 3GPP, NGMN 및 ITU와 같은 5G 표준 및 프로토콜을 이해하는 지원자의 이해도를 검증합니다.

>> Huawei H35-580_V2.0인증시험 인기 덤프문제 <<

시험패스에 유효한 최신버전 H35-580_V2.0인증시험 인기 덤프문제 최신 덤프모음집

Huawei H35-580_V2.0인증시험덤프는 적중율이 높아 100% Huawei H35-580_V2.0Huawei H35-580_V2.0시험에서 패스할수 있게 만들어져 있습니다. 덤프는 IT전문가들이 최신 실러버스에 따라 몇년간의 노하우와 경험을 충분히 활용하여 연구제작해낸 시험대비자료입니다. 저희 Huawei H35-580_V2.0덤프는 모든 시험유형을 포함하고 있는 퍼펙트한 자료기에 한방에 시험패스 가능합니다.

HCIA-5G-RNP & RNO v2.0 인증은 5G 기술, 네트워크 계획 및 최적화, 라디오 리소스 관리, 간섭 관리, 네트워크 성능 관리 및 문제 해결을 포함한 다양한 주제를 다룹니다. 이 시험은 5G RNP & RNO의 주요 개념과 원칙에 대한 후보자의 이해를 평가하는 객관식 질문으로 구성됩니다. 시험에 합격 한 응시자는 HCIA-5G-RNP & RNO v2.0 인증을 받게됩니다. 이는 5G 라디오 네트워크 계획 및 최적화에 대한 전문 지식을 보여주는 귀중한 자격 증명입니다.

최신 HCIA-5G H35-580_V2.0 무료샘플문제 (Q62-Q67):

질문 # 62
Which of the following protocols/data belong to Layer 3 of the Uu interface?(Select All that Apply)

A. RLC protocol
B. IP data
C. RRC protocol
D. MAC protocol

정답：C

설명：
Explanation
According to the LTE user plane protocol stack, the Layer 3 of the Uu interface consists of the RRC protocol and the IP data. The RRC protocol is responsible for radio resource management, access control, handover and mobility, and encryption and integrity protection. The IP data is the payload of the user plane that is transmitted over the PDCP layer.

질문 # 63
In a Huawei base station, which of the following bearers can only be configured as an MCG bearer?

A. QCI2
B. QCI6
C. QQ1
D. QCI9

정답：A

설명：
Explanation
According to the LTE-NR tight-interworking and the first steps to 5G, in a Huawei base station, QCI2 can only be configured as an MCG (Master Cell Group) bearer. QCI2 is a voice bearer that requires low latency and high reliability. Therefore, it cannot be configured as an SCG (Secondary Cell Group) bearer or a split bearer that may introduce additional delay or packet loss. QCI6, QCI9, and QQ1 can be configured as either MCG bearers, SCG bearers, or split bearers depending on the service requirements and network conditions.

질문 # 64
Which of the following statements about the space principles for 5G BBU installation are correct?(Select All that Apply)

A. If the installation space is insufficient, install 5G boards directly into the existing 4G B8U.
B. If the remaining space of an existing cabinet is greater than 4 U, the BBU can be installed directly.
C. If the installation space is insufficient, the BBU can be installed on a wall. Ensure that the wall meets the load bearing requirements.
D. If the space is greater than 600 mm, a cabinet can be added to install the BBU.

정답：B,C,D

설명：
Explanation
According to the Hardware Description: Bbu5900 V100r013c10, these statements are correct about the space principles for 5G BBU installation:
If the installation space is insufficient, the BBU can be installed on a wall. Ensure that the wall meets the load bearing requirements: The BBU can be installed on a wall using wall-mounted brackets. The wall must be able to bear at least four times the weight of the BBU and must be flat and vertical. The installation height of the BBU must not exceed 2 m.
If the space is greater than 600 mm, a cabinet can be added to install the BBU: The BBU can be installed in a cabinet that meets the requirements of Huawei base stations. The cabinet must have a width of 19 inches and a depth of at least 600 mm. The cabinet must also provide sufficient ventilation, grounding, and lightning protection for the BBU.
If the remaining space of an existing cabinet is greater than 4 U, the BBU can be installed directly: The BBU can be installed in an existing cabinet that has enough space for it. The BBU has a height of 2 U, so it requires at least 4 U of space in a cabinet. The existing cabinet must also meet the requirements of Huawei base stations.
The other statement is incorrect about the space principles for 5G BBU installation:
If the installation space is insufficient, install 5G boards directly into the existing 4G B8U: This statement is not supported by Huawei base stations. The 5G boards cannot be installed directly into the existing 4G B8U because they have different slot distributions and board types. The 5G boards can only be installed in a BBU5900 subrack that supports both LTE and NR modes.

질문 # 65
Among the A3 event parameters for intra-frequency handover, which of the following parameters cannot be configured individually based on QCI?

A. A3 bias
B. A3 Time-to-Trigger
C. Neighborhood Offset (CIO)
D. A3 Amplitude Hysteresis

정답：C

설명：
CIO is configured per neighbor relation and is not typically differentiated according to QCI.

질문 # 66
In NSA networking, if the external cell and neighbor relationship between eNodeB and gNodeB is not configured, which of the following problems will occur?

A. gNodeB rejects the add request
B. UE cannot report 5G measurement results
C. eNodeB cannot send NR measurement configuration
D. eNodeB does not trigger gNodeB addition request

정답：D

설명：
Without the external cell and neighbor relationship configuration, the eNodeB cannot map NR measurement results to a valid target gNodeB and therefore cannot initiate the SgNB addition procedure.

질문 # 67
......

H35-580_V2.0덤프최신자료: https://kr.fast2test.com/H35-580_V2.0-premium-file.html