The web-based NSE7_FSN_AR-7.6 practice test can be taken via any operating system without the need to install additional software. Also, this NSE7_FSN_AR-7.6 web-based practice exam is compatible with all browsers. Both Fortinet NSE7_FSN_AR-7.6 Practice Tests of TestSimulate keep result of your attempts and assist you in fixing errors. Moreover, you can alter settings of these NSE7_FSN_AR-7.6 practice exams to suit your learning requirements.
| Section | Objectives |
|---|---|
| SD-WAN | - Centralized management
|
| Enterprise Firewall | - Authentication and Access Control
|
>> New Soft NSE7_FSN_AR-7.6 Simulations <<
For the purposes of covering all the current events into our NSE7_FSN_AR-7.6 study guide, our company will continuously update our training materials. And after payment, you will automatically become the VIP of our company, therefore you will get the privilege to enjoy free renewal of our NSE7_FSN_AR-7.6 practice test during the whole year. No matter when we have compiled a new version of our NSE7_FSN_AR-7.6 Training Materials our operation system will automatically send the latest version of the NSE7_FSN_AR-7.6 preparation materials for the exam to your email, all you need to do is just check your email then download it.
NEW QUESTION # 68
An administrator wants to capture encrypted phase 2 traffic between two FotiGate devices using the built-in sniffer.
If the administrator knows that there Is no NAT device located between both FortiGate devices, which command should the administrator run?
Answer: A
Explanation:
To capture encrypted IPsec phase 2 (ESP) traffic between two FortiGate devices, the correct protocol filter to use is ip proto 50. According to the Fortinet official sniffing and debugging documentation, ESP (Encapsulating Security Payload) is used for encrypted phase 2 payload transfer and always uses IP protocol number 50. Running the command diagnose sniffer packet any ' ip proto 50 ' captures only ESP packets, which represent the encrypted traffic-whether originating or transiting the device.
If there is no NAT device between FortiGates, ESP is not encapsulated in UDP (thus not on UDP port 4500; if NAT-T were required, packets would be UDP-encapsulated, but the scenario explicitly says NAT is not in use). UDP port 500 is for IKE control (negotiation) traffic, and AH (Authentication Header, ip proto 51) is not used for encryption in standard IPsec phase 2 with ESP.
This matches the official CLI reference from Fortinet for VPN and traffic analysis.
**
References:
FortiOS CLI Reference: diagnose sniffer packet, ESP, IP Protocol Numbers FortiGate VPN Administration Guide: Traffic Capture and Analysis of IPsec Traffic
NEW QUESTION # 69
Which two statements about Security Fabric communications are true? (Choose two.)
Answer: C,D
Explanation:
Comprehensive and Detailed Explanation From Exact Extract of Network Security Support Engineer Study Guide (FortiOS 7.6) topics:
The correct answers are A and B . Security Fabric communication uses Fortinet-proprietary protocols, mainly FortiTelemetry and Neighbor Discovery . The study guide states that FortiTelemetry uses TCP port 8013
, and that the connection is always established by the downstream FortiGate toward the upstream FortiGate
. This validates option A . The same section also states that FortiTelemetry must be manually enabled .
More precisely, the upstream FortiGate interface must have Security Fabric Connection enabled under administrative access so it can accept incoming Security Fabric connection requests. This validates option B .
Option C is wrong because only the FortiTelemetry TCP port 8013 can be changed; Neighbor Discovery uses UDP port 8014 and cannot be changed. Option D is also wrong because Security Fabric communication is not enabled automatically among all Fortinet devices. It requires the correct Security Fabric settings, interface administrative access, and downstream authorization. The study guide's troubleshooting section confirms that when FortiTelemetry is disabled, the upstream FortiGate receives TCP 8013 SYN packets but does not complete the Security Fabric connection.
NEW QUESTION # 70
Refer to the exhibit showing a debug output.
An administrator deployed FSSO in DC Agent Mode but FSSO is failing on FortiGate. Pinging FortiGate from where the collector agent is deployed is successful.
The administrator then produces the debug output shown in the exhibit.
What could be causing this error message?
Answer: B
NEW QUESTION # 71
You are checking an enterprise network and see a suspicious packet with the MAC address 00:09:0f:09:18:81.
Which two statements about the suspicious packet are correct? (Choose two.)
Answer: A,B
Explanation:
Comprehensive and Detailed 100 to 150 words of Explanation From Secure Networking Architect Study Guides topics:
The MAC prefix 00:09:0f:09 identifies FortiGate ' s logic-2 HA virtual-MAC construction. The Enterprise Firewall 7.6 guide states that logic 2 applies when the virtual-cluster ID is 0 or 1, the HA group ID is below
256, and the physical-interface index is below 128.
In 00:09:0f:09:18:81, hexadecimal 18 represents HA group ID 24, confirming that the group ID is below 255 and making D correct. The high bit in the final octet indicates virtual-cluster ID 1; this means virtual clustering
/VDOM functionality is involved, making C correct. The remaining physical-index bits identify index 1, not
2, eliminating A. This virtual-MAC construction belongs to FortiGate Clustering Protocol HA operation and does not establish that the device uses standalone FGSP session synchronization, eliminating B.
NEW QUESTION # 72
Refer to the exhibits.
Which two statements are true about the health and performance of SD-WAN members 3 and 4? (Choose two.)
Answer: B,C
Explanation:
The exhibit configures the health check in passive mode and enables passive measurement for an SD-WAN rule that identifies Facebook and YouTube applications. Passive WAN health measurement derives latency, jitter, and packet-loss information from live TCP session information rather than generating conventional active probes. Therefore, A is correct.
Because application-specific identifiers are configured in the SD-WAN rule, FortiGate can maintain passive performance information for the relevant Facebook and YouTube traffic and calculate the member metrics from those observations. This makes B correct. Fortinet ' s FortiOS 7.6 passive-measurement documentation confirms this behavior.
A lack of matching application traffic does not automatically declare the member dead, eliminating C.
Encryption also does not inherently prevent passive measurement because the mechanism relies on TCP
/session performance information rather than decrypted application payloads, eliminating D.
NEW QUESTION # 73
......
A Fortinet NSE 7 - Secure Networking 7.6 Architect will not only expand your knowledge but it will polish your abilities as well to advance successfully in the world of Fortinet. Real Fortinet NSE7_FSN_AR-7.6 Exam QUESTIONS certification increases your commitment and professionalism by giving you all the knowledge necessary to work in a professional setting. We have heard from thousands of people who say that using the authentic and Reliable NSE7_FSN_AR-7.6 Exam Dumps was the only way they were able to pass the NSE7_FSN_AR-7.6.
Guaranteed NSE7_FSN_AR-7.6 Success: https://www.testsimulate.com/NSE7_FSN_AR-7.6-study-materials.html