International Code CouncilのM2認定試験の対応性問題集

CertShikenのInternational Code CouncilのM2の試験問題と解答は実践されて、当面の市場で最も徹底的な正確的な最新的な模擬テストです。CertShikenは広い研究と実際を基づいている経験及び正確的な学習教材を提供できます。私たちは君の最も早い時間でInternational Code CouncilのM2試験に合格するように頑張ります。もし私たちのInternational Code CouncilのM2問題集を購入したら、CertShikenは一年間無料で更新サービスを提供することができます。

International Code Council M2 Exam Syllabus Topics:

SectionObjectives
Combustion Air and Fuel Supply- Combustion Air
  • 1. Combustion Air Openings
  • 2. Indoor and Outdoor Air Requirements
- Fuel Supply Systems
  • 1. Fuel Gas Piping
  • 2. Fuel Oil Systems
Ventilation and Exhaust Systems- Commercial Kitchens
  • 1. Grease Ducts
  • 2. Kitchen Exhaust Hoods
- Ventilation
  • 1. Mechanical Ventilation
  • 2. Exhaust Air Systems
Materials and Specifications- Approved Materials
  • 1. Equipment Labeling
  • 2. Installation Standards
Duct Systems- Duct Construction
  • 1. Materials and Installation
  • 2. Dampers and Protection
- Air Distribution
  • 1. Plenums
  • 2. Duct Insulation
Hydronic Piping and Refrigeration- Hydronic Systems
  • 1. Pressure Testing
  • 2. Piping Installation
- Refrigeration
  • 1. Refrigerant Piping
  • 2. Safety Controls
Chimneys and Vents- Connectors and Terminations
  • 1. Termination Requirements
  • 2. Vent Connectors
- Vent Systems
  • 1. Vent Sizing
  • 2. Chimney Clearances
General Administration- Code Scope and Administration
  • 1. Referenced Standards
  • 2. Definitions
  • 3. Permits and Inspections
Heating and Cooling Systems- Cooling Systems
  • 1. Refrigeration Equipment
  • 2. Cooling Appliances
- Heating Appliances
  • 1. Boilers
  • 2. Water Heaters
  • 3. Furnaces

>> M2クラムメディア <<

M2試験準備 & M2認証資格

CertShikenが提供した教育資料は真実のテストに非常に近くて、あなたが弊社の短期の特殊訓練問題を通じてすぐにInternational Code Council専門の知識を身につけられます。弊社は君のM2試験の１００％合格率を保証いたします。

International Code Council Commercial Mechanical Inspector 認定 M2 試験問題 (Q21-Q26):

質問 # 21
Which of the following is not a required mechanical inspection?

正解：D

解説：
The ICC mechanical administrative inspection sequence includes underground inspection , rough-in inspection , and final inspection as required inspections. An annual system test is not listed as one of the required permit inspections in that section, so Option D is the correct answer. This fits the M2 General Administration content area, which includes permit and inspection administration.


質問 # 22
Exhibit:

What hp is EF-2?

正解：D

解説：
Based on the equipment schedule shown in the exhibit, EF-2 is listed with a motor size of 1.5 horsepower .
Therefore, the correct answer is C .


質問 # 23
An equipment shutoff valve shall be in the same room and not more than how many feet away from the appliance?

正解：C

解説：
The IFGC requires the appliance shutoff valve to be located in the same room as the appliance and within
6 feet of the appliance . Therefore, the correct answer is A .


質問 # 24
Exhaust outlets that terminate at a temperature exceeding 600°F shall be designed as a:

正解：C

解説：
The IMC special exhaust provisions require exhaust outlets terminating at temperatures exceeding 600°F to be designed as a chimney , and the table language identifies this as a single-wall metal chimney . Therefore, Option D is correct.


質問 # 25
Given: A recirculating industrial direct-fired makeup air heater has a rated input of 200,000 Btu/h .
Ventilation air is supplied by separate mechanical means.
Outside ventilation air shall be provided to supply at least _____ CFM.

正解：A

解説：
The applicable provision requires direct-fired industrial air heaters to supply outside ventilation air at a rate of not less than 4 cfm per 1,000 Btu/h of rated input where ventilation air is provided by separate mechanical means. For 200,000 Btu/h , the required outside air is:
200,000 ÷ 1,000 = 200
200 × 4 = 800 cfm
So the correct answer is C


質問 # 26
......

M2学習教材の練習試験や模擬試験はみんなにとって重要です。今のリビジョン条件はM2試験に参加する良い機会です。したがって、レビュープランを調整するために、M2の各練習問題を要約することが不可欠です。今、私たちはM2実際試験を模擬するためにオンラインテストエンジンとWindowsソフトウェアを追加しました。

M2試験準備: https://www.certshiken.com/M2-shiken.html