Before you decide to buy VCEPrep of Huawei H19-404_V1.0 exam questions, you will have a free part of the questions and answers as a trial. So that you will know the quality of the VCEPrep of Huawei H19-404_V1.0 Exam Training materials. The Huawei H19-404_V1.0 exam of VCEPrep is the best choice for you.
| Section | Objectives |
|---|---|
| Topic 1: Network Security Design | - Campus security architecture considerations - Access control strategies |
| Topic 2: Switching and Routing in Campus Networks | - Layer 2 and Layer 3 design principles - VLAN and segmentation design |
| Topic 3: Campus Network Fundamentals | - Enterprise campus network architecture principles - Typical campus network deployment models |
| Topic 4: Presales Solution Design | - Customer requirement analysis - Solution proposal and design methodology |
| Topic 5: Huawei Campus Network Solutions | - CloudCampus solution architecture - iMaster NCE-Campus management platform |
| Topic 6: WLAN Planning and Design | - Capacity and performance design considerations - Wireless coverage planning |
>> Latest H19-404_V1.0 Study Guide <<
For the challenging Huawei H19-404_V1.0 exam, they make an effort to locate reputable and recent Huawei H19-404_V1.0 practice questions. The high anxiety and demanding workload the candidate must face being qualified for the Huawei H19-404_V1.0 Certification are more difficult than only passing the Huawei H19-404_V1.0 exam.
NEW QUESTION # 60
Which of the following encryption algorithms is used by WPA3?
Answer: D
Explanation:
The intended answer is AES-256. In certification material, this question normally refers to the enhanced WPA3-Enterprise 192-bit security suite, which uses the GCMP-256 data-protection algorithm based on AES-
256, together with stronger integrity and key-management components. AES-512 is not a standardized AES variant, and RC4 is the obsolete stream cipher associated with legacy WEP and TKIP-era protection rather than WPA3.
There is an important technical qualification: WPA3 is a family of certification modes, not one universal cipher suite. WPA3-Personal commonly uses Simultaneous Authentication of Equals for password- authenticated key establishment and requires CCMP-128, which is based on AES-128. WPA3-Enterprise 192- bit mode, however, uses AES-256 in GCM mode. Therefore, the original wording is broader than it should be.
A technically precise version would ask which algorithm is associated with the WPA3-Enterprise 192-bit security suite. Under the intended Huawei examination scope and the supplied single-choice options, option B is correct. That distinction is crucial when interpreting this simplified examination item.
NEW QUESTION # 61
Which of the following statements are true about traffic encryption on SD-WAN links?
Answer: A,B
Explanation:
Huawei SD-WAN allows encryption to be controlled by virtual network and by specific device relationships.
When encryption is enabled for a VN, the overlay data channels carrying that VN's traffic use IPsec protection across the relevant WAN links. This provides consistent isolation and confidentiality for the department or service represented by that VN.
Encryption can also be enabled between selected devices or sites. In that case, secure data channels are established for traffic exchanged between those specified endpoints, while other device relationships can continue using GRE without IPsec according to their policies.
Application-specific encryption, as described in option C, is not the supported control granularity. Application identification can influence intelligent traffic steering, QoS, and security-policy selection, but it does not mean that only the payload of a selected application is independently encrypted inside an otherwise unencrypted SD-WAN tunnel.
A transport network is an underlay WAN such as MPLS or the Internet. Enabling encryption is an overlay tunnel policy rather than a mechanism that encrypts all traffic belonging to an entire TN. Huawei distinguishes TNs as underlay networks and GRE or IPsec VPNs as overlay data channels. Therefore, only A and B are correct.
NEW QUESTION # 62
In hierarchical networking, which of the following devices is used for communication between different areas?
Answer: B
Explanation:
A border device, or more precisely a device at a border site, provides communication between different areas in a hierarchical SD-WAN topology. The hierarchical model divides a large WAN into multiple areas. Each area can independently use a hub-spoke or full-mesh topology, while selected border sites connect the local area to a centralized backbone area.
When a non-border site receives a route originating in another area, the route's next-hop site ID is changed to the border site in its own area. The local border device then forwards traffic toward the border site in the destination area or toward an interconnected hub site. Ordinary edge devices provide connectivity for their own sites but do not automatically perform cross-area transit.
Huawei describes border sites as members of both the level-2 area network and the level-1 backbone network.
These sites collectively implement interconnection between areas. Huawei further explains that inter-area routes point to border sites and recommends two border sites operating in active/standby mode for reliability.
Therefore, the correct answer is B.
NEW QUESTION # 63
Which of the following WLAN networking solutions is recommended when there are 15,000 wireless terminals on the customer network?
Answer: B
Explanation:
A network serving 15,000 wireless terminals is a large-scale WLAN and should use a standalone WAC solution. A dedicated WAC provides independent controller resources, scalable AP and user management, centralized WLAN policy control, and the ability to deploy controller redundancy without tying wireless- control capacity directly to a specific core-switch service card.
Huawei recommends a standalone WAC when the wireless network scale is large or when the wireless network is deployed independently over an existing wired campus. The WAC is typically connected to the aggregation or core layer in off-path mode, and VRRP hot standby can be used to improve reliability.
Native WAC solutions are valuable for unified wired and wireless management, authentication, forwarding, and policy enforcement. However, for a very large number of wireless terminals, the controller platform must be selected according to user, AP, traffic, and forwarding-capacity specifications. A standalone WAC allows the wireless control plane to be sized and expanded independently.
Option C provides the dedicated WAC together with the required core and aggregation or access infrastructure. Therefore, it is the recommended architecture for 15,000 wireless terminals.
NEW QUESTION # 64
Traffic can be forwarded directly between the two PRP ports of a PRP RedBox.
Answer: B
Explanation:
The statement is false. In Parallel Redundancy Protocol, LAN A and LAN B must remain two separate, failure-independent networks. A PRP RedBox connects a singly attached node or conventional network to both parallel LANs and behaves toward the PRP network like a doubly attached node. It duplicates outgoing frames and transmits one copy through each PRP port. For incoming traffic, it accepts the first valid copy and discards the later duplicate before forwarding the frame through its interlink port.
The RedBox must not operate as a normal bridge that directly forwards frames from its LAN A port to its LAN B port. Doing so would connect the two redundant LANs, potentially creating loops, duplicate propagation, broadcast amplification, and a common failure path. That would defeat the fundamental PRP requirement that failure or disruption in one LAN must not affect the other.
The original video contains the typing error "PPR RedBox"; the correct term is PRP RedBox , meaning Parallel Redundancy Protocol Redundancy Box. PRP topology requires two separate networks with no direct links between them, while the RedBox provides controlled redundant attachment for non-PRP devices.
NEW QUESTION # 65
......
For the recognition of skills and knowledge, more career opportunities, professional development, and higher salary potential, the H19-404_V1.0 certification exam is the proven way to achieve these tasks quickly. Overall, we can say that with the HCSE-Presales-Campus Network Planning and Design V1.0 (H19-404_V1.0) exam you can gain a competitive edge in your job search and advance your career in the tech industry. However, to pass the H19-404_V1.0 Exam you have to prepare well. For the quick H19-404_V1.0 exam preparation the H19-404_V1.0 Questions is the right choice.
H19-404_V1.0 Flexible Learning Mode: https://www.vceprep.com/H19-404_V1.0-latest-vce-prep.html