DumpTOP 에서는 Fortinet NSE7_SSE_AR-26 시험에 대비한 고품질 Fortinet NSE7_SSE_AR-26덤프를 제공해 드립니다. Fortinet NSE7_SSE_AR-26덤프는 IT 업계 종사자들에 있어서 아주 중요한 인증시험이자 인기 자격증을 취득할수 있는 필수과목입니다. Fortinet NSE7_SSE_AR-26시험을 합격하여 자격증을 취득하시면 취업하는데 가산점이 될수 있고 급여 인상이나 이직에도 많을 도움을 드릴수 있습니다.
| Section | Objectives |
|---|---|
| Topic 1: Operations and Troubleshooting | - Log analysis - Monitoring and analytics - Troubleshooting deployment and connectivity - Centralized management |
| Topic 2: Integration | - FortiGate integration - Enterprise networking scenarios - SD-WAN integration |
| Topic 3: FortiSASE Architecture and Design | - Design secure internet access (SIA) - Design secure private access (SPA) - Design secure SaaS access (SSA) - Select appropriate deployment models |
| Topic 4: Policy and Security Services | - Web filtering - DNS filtering - Security policy design - Threat protection - Application control |
| Topic 5: Identity and Access | - Zero Trust Network Access (ZTNA) - Endpoint posture and compliance - Authentication and identity providers |
>> NSE7_SSE_AR-26시험패스 가능 덤프문제 <<
DumpTOP는 Fortinet인증관련덤프를 제공하는 최고의 업체입니다, 덤프들은 DumpTOP의 베터랑의 전문가들이 오랜 풍부한 경험과 NSE7_SSE_AR-26지식으로 만들어낸 최고의 제품입니다. 그리고 우리는 온라인무료 서비스도 제공되어 제일 빠른 시간에 소통 상담이 가능합니다.
질문 # 112
You plan a large SD-WAN deployment for a global company. You want to divide the network architecture into five geographical regions and install two hubs in each region for increased redundancy. You expect a significant amount of traffic within each region and limited traffic flow between spokes in different regions.
You plan to connect the small branch sites to only the closest hub in their regions and the large branch sites to the two hubs in the regions. Which statement about your plan is true? Choose one answer.
정답：D
설명：
The described design is a multi-region SD-WAN architecture, where: According to Fortinet's SD-WAN Architecture for Enterprise guidance, when deploying multiple ADVPN regions, eBGP is the recommended routing protocol between regions. Each region operates as an independent routing domain (typically iBGP within the region), while eBGP is used to exchange routes between regional hubs. This approach: This is explicitly documented in Fortinet guidance for "Using eBGP between regions with intra-region ADVPN", which confirms that the architecture described in the question is valid and recommended when eBGP is used between regions. Why the other options are incorrect: Therefore, the correct and documented conclusion is that the plan is possible and eBGP should be used as the routing protocol between regions, which corresponds to Answer A. A deployment should preserve the distinction between the physical or logical WAN underlay, the IPsec overlay and the SD-WAN zone that groups forwarding members. These layers can have different routing and security-policy requirements. The configured architecture must also allow the required traffic paths and failover behavior rather than assuming every available interface is interchangeable.
References: https://docs.fortinet.com/document/fortigate/7.6.0/sd-wan-sd-branch-architecture-for-mssps
/245549/overlay-network-designs
질문 # 113
Which two matching traffic criteria are available to steer traffic in SD-WAN rules?
정답：C,D
설명：
FortiGate SD-WAN uses traffic-classification criteria to identify application flows and apply appropriate forwarding strategies based on business priorities and link-performance requirements.
Option C is correct because application categories can be used to identify traffic belonging to defined application groups. This capability enables administrators to steer business-critical applications through preferred WAN paths while directing less-sensitive traffic through alternative links.
Application-aware SD-WAN rules can use FortiGuard application identification to make forwarding decisions without relying exclusively on destination IP addresses or transport ports.
Option D is correct because the Internet Service Database provides predefined classifications for cloud services and internet applications. FortiGate can use ISDB objects in SD-WAN service rules to steer traffic toward destinations associated with services such as Microsoft 365 and other cloud applications.
Option A is incorrect because physical interface type is not one of the application or destination matching criteria represented by this question. SD-WAN members identify eligible forwarding interfaces, which is distinct from the traffic-classification criteria.
Option B is incorrect because BGP attributes influence routing decisions and route selection but are not directly equivalent to the application and ISDB matching criteria used by these service rules.
Together, application-category and ISDB matching provide granular, application-aware steering.
References: FortiOS 7.6 Administration Guide - Internet Service and Application Control Steering; FortiManager - Application Categories in SD-WAN Rules.
질문 # 114
What is the primary purpose of thin-branch SD-WAN design in a FortiSASE architecture?
정답：A
설명：
Thin-branch designs use a lightweight FortiGate at the branch primarily for connectivity and local breakout decisions, while relying on FortiSASE cloud security services for deeper inspection, reducing the hardware and management footprint at each site.
질문 # 115
Refer to the exhibit. The administrator configured the IPsec tunnel VPN1 on a FortiGate device with the parameters shown in exhibit. Based on the configuration, which three conclusions can you draw about the characteristics and requirements of the VPN tunnel? (Choose three.)
Exhibit 1
정답：A,B,D
설명：
The phase 1 interface explicitly configures IKEv2, so a compatible peer must support that IKE version. With mode-cfg disabled, the overlay interface is not automatically assigned an address using IKE mode configuration, and the required interface addressing must be configured. The exchange-interface-ip capability exchanges configured FortiGate IPsec interface addresses, enabling user-defined overlay addressing. It is a Fortinet-specific integration and should not be assumed to interoperate with any third-party IPsec peer. The source candidate key incorrectly includes general third-party compatibility as if every configured Fortinet- specific mechanism were interoperable. Reference: FortiOS 7.6 CLI Reference - vpn ipsec phase1-interface, ike-version, mode-cfg, exchange-interface-ip. An operational review should distinguish the rule that matches the traffic from the interface that is ultimately selected. Valid forwarding also depends on destination route eligibility, current member state and the applicable SLA or quality-selection algorithm. A diagnostic showing configured members alone is not conclusive evidence that all those members will carry a particular flow.
References: https://docs.fortinet.com/document/fortigate/7.6.0/cli-reference/838040159/config-system-sdwan
질문 # 116
An administrator configures the performance service-level agreement (SLA) with the probe mode, Prefer Passive.
What are two observable impacts of this configuration? (Choose two.)
정답：A,B
설명：
FortiGate provides three primary SD-WAN health-monitoring modes: Active, Passive, and Prefer Passive.
Prefer Passive combines live-session measurements with active probes when sufficient application traffic is unavailable.
Option B is correct because FortiGate measures performance passively when qualifying TCP sessions traverse an SD-WAN member. It derives latency, jitter, and packet-loss measurements from actual TCP session behavior rather than relying exclusively on synthetic probes.
Option E is correct because passive measurements alone cannot reliably determine whether an otherwise idle interface is completely unreachable. In Prefer Passive mode, FortiGate uses active probing when no suitable TCP traffic has been observed for three continuous minutes. Active probes can then identify dead members.
Option A is incorrect because ordinary ICMP traffic does not provide the TCP session information required for this passive measurement mechanism.
Option C reverses the transition logic. The three-minute timer applies to the absence of TCP traffic before switching from passive to active monitoring. FortiGate returns to passive monitoring when eligible TCP traffic becomes available.
Option D is incorrect because enabling passive-wan-health-measurement disables automatic ASIC offloading for the affected firewall policy, allowing the CPU to observe the session characteristics necessary for passive measurement.
References: FortiOS 7.6 Administration Guide - Passive WAN Health Measurement and Performance SLA Overview; Fortinet Technical Tip - Different Types of Health Checks Used in SD-WAN.
질문 # 117
......
DumpTOP는 믿을 수 있는 사이트입니다. IT업계에서는 이미 많이 알려져 있습니다. 그리고 여러분에 신뢰를 드리기 위하여 Fortinet 인증NSE7_SSE_AR-26 관련자료의 일부분 문제와 답 등 샘플을 무료로 다운받아 체험해볼 수 있게 제공합니다. 아주 만족할 것이라고 믿습니다. DumpTOP제품에 대하여 아주 자신이 있습니다. Fortinet 인증NSE7_SSE_AR-26 도 여러분의 무용지물이 아닌 아주 중요한 자료가 되리라 믿습니다. 여러분께서는 아주 순조로이 시험을 패스하실 수 있을 것입니다.
NSE7_SSE_AR-26최신버전 덤프샘플 다운: https://www.dumptop.com/Fortinet/NSE7_SSE_AR-26-dump.html