First-grade Huawei H12-351_V1.0 Study Materials and Realistic New H12-351_V1.0 Test Practice

The HCIE-WLAN (Written) V1.0 (H12-351_V1.0) actual questions we sell also come with a free demo. Spend no time, otherwise, you will pass on these fantastic opportunities. Start preparing for the Huawei H12-351_V1.0 exam by purchasing the most recent Huawei H12-351_V1.0 Exam Dumps. ExamcollectionPass also guarantees that it will provide your money back if in any case, you are unable to pass the H12-351_V1.0 exam but the terms and conditions are there that you must have to follow.

Huawei H12-351_V1.0 Exam Syllabus Topics:

Section	Weight	Objectives
Topic 1: WLAN Advanced Technologies and Solutions	15%	- Roaming and Location Services 1. Wi-Fi positioning and location technology 2. Layer 2 and Layer 3 fast roaming - WLAN and IoT Convergence 1. CloudCampus and smart campus solutions 2. IoT access over WLAN
Topic 2: WLAN Reliability and Radio Resource Management	20%	- Radio Resource Management 1. Admission control and load balancing 2. Interference detection and mitigation 3. Dynamic channel and power adjustment - WLAN Redundancy and Reliability 1. AC backup and load balancing 2. AP redundancy and fast failover 3. Mesh and WDS technologies
Topic 3: WLAN Security and Access Control	15%	- Authentication and Encryption 1. 802.1X, MAC, and Portal authentication 2. Certificate-based authentication 3. WPA/WPA2/WPA3 security - Security Defense 1. Access control and policy management 2. Anti-interference and anti-spoofing 3. Rogue AP detection and containment
Topic 4: WLAN O&M, Troubleshooting and Optimization	15%	- Troubleshooting and Optimization 1. Common fault analysis and resolution 2. RF optimization and network capacity tuning - Monitoring and Intelligent O&M 1. Fault diagnosis and alarm management 2. WLAN performance monitoring
Topic 5: WLAN Networking and Deployment	20%	- High-Density and Large-Scale Deployment 1. IPv6 support in WLAN 2. Power adjustment and coverage design 3. AP placement and channel planning - WLAN Networking Modes 1. Layer 3 and inter-subnet roaming 2. CloudCampus WLAN architecture 3. Direct connection and Layer 2 networking
Topic 6: WLAN Basic Principles and Architecture	15%	- Huawei WLAN Architecture 1. CAPWAP protocol 2. Fat AP vs Fit AP 3. WLAN AC and AP working mechanism - RF and 802.11 Protocol Fundamentals 1. 802.11 physical and MAC layer 2. Radio frequency characteristics 3. Frequency bands and channels

>> H12-351_V1.0 Study Materials <<

Pass-sure H12-351_V1.0 Study Materials bring you Latest-updated New H12-351_V1.0 Test Practice for Huawei HCIE-WLAN (Written) V1.0

Our H12-351_V1.0 exam questions are authoritatively certified. Our goal is to help you successfully pass relevant exam in an efficient learning style. Due to the quality and reasonable prices of our H12-351_V1.0 training materials, our competitiveness has always been a leader in the world. Our H12-351_V1.0 Learning Materials have a higher pass rate than other H12-351_V1.0 training materials, so we are confident to allow you to gain full results.

Huawei HCIE-WLAN (Written) V1.0 Sample Questions (Q19-Q24):

NEW QUESTION # 19
When a STA roams from API to AP2 at Layer 2, AP2 notifies its neighbors of from this STA is encapsulated in a tunnel and sent to API for forwarding.

A. True
B. False

Answer: B

Explanation:
Explanation
When a STA roams from AP1 to AP2 at Layer 2, AP2 notifies its neighbors of the MAC address learned from this STA. The MAC address is not encapsulated in a tunnel and sent to AP1 for forwarding. Instead, AP1 deletes the MAC address entry of the STA and releases the IP address lease.
References: https://support.huawei.com/enterprise/en/doc/EDOC1100058940/8a8f1c9b/layer-2-roaming

NEW QUESTION # 20
The display sync-configuration compare command is executed on the backup WAC in HSB to check wireless configuration synchronization. Based on the command output, which of the following statements are true?
(Select All that apply)

A. The configuration of vap-profile name 3 exists on the master WAC but not on the backup WAC.
B. This command is used to check whether the public configurations on two WACs are consistent after wireless configuration synchronization.
C. The configuration of vap-profile name 2 exists on the backup WAC but not on the master WAC.
D. The configuration of ssid-profile 2 exists on both the master and backup WACs.

Answer: A,B

Explanation:
Explanation
The display sync-configuration compare command is used to check whether the public configurations on two WACs are consistent after wireless configuration synchronization. The command output shows the differences between the configurations on the master and backup WACs. In this case, the configuration of vap-profile name 3 exists on the master WAC but not on the backup WAC.
References:
https://support.huawei.com/enterprise/en/doc/EDOC1100058940/8a8f1c9b/display-sync-configuration-compare

NEW QUESTION # 21
An engineer configures the following radio calibration commands on a Huawei WAC. Which of the following statements are true about these commands?

A. The engineer manually configures the Dynamic Channel Assignment (DCA) function.
B. The engineer manually configures the receive power control (RPC) function.
C. In the default AP group, the DCA function is enabled by default.
D. In the default AP group, the DBS function is enabled by default.
E. The engineer manually configures die dynamic bandwidth selection (DBS) function.
F. The engineer manually configures the transmit power control (TPC) function.

Answer: A,E

NEW QUESTION # 22
Which of the followings is not a roaming optimization solution?

A. 802.11r roaming
B. Proactive roaming
C. Fast roaming using PMK caching
D. Smart roaming

Answer: D

Explanation:
Explanation
Smart roaming is not a roaming optimization solution, but a feature that allows an AP to automatically adjust its transmit power based on signal strength and interference level. The other options are all roaming optimization solutions that can reduce roaming latency and packet loss.
References: https://support.huawei.com/enterprise/en/doc/EDOC1100058940/8a8f1c9b/smart-roaming

NEW QUESTION # 23
Which of the following statements about WLAN roaming and signal strength Is false?

A. In most cases, the signal strength of a STA should range from -45 dBm to -65 dBm.
B. STAs can roam between WACs in dual-link HSB mode.
C. Smart roaming can be enabled on the WAC to help ST As roam and associate with APs with better signals.
D. Generally, a STA roams when it detects that the signal strength is less than -75 dBm.

Answer: D

Explanation:
Explanation
B is false because generally, a STA roams when it detects that the signal strength is less than -70 dBm or -65 dBm, not -75 dBm.
References:
https://support.huawei.com/enterprise/en/doc/EDOC1100058940/8a8f1c9b/wlan-roaming-and-signal-strength

NEW QUESTION # 24
......

The H12-351_V1.0 certificate is the bridge between "professional" and "unprofessional", and it is one of the ways for students of various schools to successfully enter the society and embark on an ideal career. It is also one of the effective ways for people in the workplace to get more opportunities. But few people can achieve it for the limit of time or other matters. But with our H12-351_V1.0 Exam Questions, it is as easy as pie. Just buy our H12-351_V1.0 training guide, then you will know how high-effective it is!

New H12-351_V1.0 Test Practice: https://www.examcollectionpass.com/Huawei/H12-351_V1.0-practice-exam-dumps.html