International Code Council M2 시험이 어렵다고해도 Pass4Test의 International Code Council M2시험잡이 덤프가 있는한 아무리 어려운 시험이라도 쉬워집니다. 어려운 시험이라 막무가내로 시험준비하지 마시고 문항수도 적고 모든 시험문제를 커버할수 있는International Code Council M2자료로 대비하세요. 가장 적은 투자로 가장 큰 득을 보실수 있습니다.
| Section | Objectives |
|---|---|
| Topic 1: Chimneys and Vents | - Connectors and Terminations
|
| Topic 2: Heating and Cooling Systems | - Cooling Systems
|
| Topic 3: Ventilation and Exhaust Systems | - Ventilation
|
| Topic 4: Materials and Specifications | - Approved Materials
|
| Topic 5: Combustion Air and Fuel Supply | - Fuel Supply Systems
|
| Topic 6: General Administration | - Code Scope and Administration
|
| Topic 7: Hydronic Piping and Refrigeration | - Refrigeration
|
| Topic 8: Duct Systems | - Air Distribution
|
International Code Council인증 M2시험은 등록하였는데 시험준비는 아직이라구요? International Code Council인증 M2시험일이 다가오고 있는데 공부를 하지 않아 두려워 하고 계시는 분들은 이 글을 보는 순간 시험패스에 자신을 가지게 될것입니다. 시험준비 시간이 적다고 하여 패스할수 없는건 아닙니다. Pass4Test의International Code Council인증 M2덤프와의 근사한 만남이International Code Council인증 M2패스에 화이팅을 불러드립니다. 덤프에 있는 문제만 공부하면 되기에 시험일이 며칠뒤라도 시험패스는 문제없습니다. 더는 공부하지 않은 자신을 원망하지 마시고 결단성있게Pass4Test의International Code Council인증 M2덤프로 시험패스에 고고싱하세요.
질문 # 15
Termination of vents for appliances listed for and installed outdoors that incorporate integral venting shall:
정답：A
설명：
For appliances listed for outdoor installation and incorporating integral venting , the IMC requires them to be installed in accordance with their listings and the manufacturer's installation instructions . That matches Option C exactly.
질문 # 16
ERV systems shall not be installed in which of the following except:
정답：D
설명：
The IMC prohibits energy recovery ventilation systems in several applications, including hazardous exhaust systems , smoke control systems , commercial kitchen exhaust systems , and clothes dryer exhaust systems . Equipment intended to assist with occupant evacuation falls under smoke-control/life-safety type applications and is not an allowed ERV use. By contrast, systems utilizing coil-type exchangers are the exception among the listed choices because they are not one of the prohibited applications in this question.
Therefore, Option A is correct.
질문 # 17
The minimum dimension for rectangular air ducts used to supply combustion air for natural draft systems is
_____ inches.
정답：B
설명：
The IMC combustion-air provisions require openings used for combustion air to have a minimum cross- sectional dimension of 3 inches . Where ducts are used, they must be of the same cross-sectional area as the openings to which they connect. That makes 3 inches the correct answer, so Option B is correct.
질문 # 18
For gas piping installations, which of the following is an acceptable joining method for polyethylene (PE) pipe?
정답：B
설명：
This item appears to use older or simplified exam wording . Current ICC language for polyethylene plastic piping identifies heat-fusion joints, electrofusion joints, and stab-type insert fittings as the named PE joining methods, not solvent cement or threaded couplings. Among the answer choices you provided, D.
Compression coupling is the only choice that aligns most closely with a mechanical fitting/joining approach for PE systems, while rubber cement, solvent cement, and threaded coupling do not match ICC PE joining practice. Because of that, D is the best answer from the listed options, but this question should be tied to the exact code cycle or source exam bank if you want absolute cycle-specific certainty
질문 # 19
The minimum rise required for a 10-foot run of vent connector is _____ inches.
정답：B
설명：
Vent connectors must be installed with a minimum rise of 1/4 inch per foot . For a 10-foot run, the required rise is:
10 × 1/4 inch = 2.5 inches .
That equals 2-1/2 inches , so Option D is correct.
질문 # 20
......
Pass4Test의 도움을 받겠다고 하면 우리는 무조건 최선을 다하여 한번에 패스하도록 도와드릴 것입니다. 또한 일년무료 업뎃서비스를 제공합니다. 중요한 건 덤프가 갱신이 되면 또 갱신버전도 여러분 메일로 보내드립니다. 망설이지 마십시오. 우리를 선택하는 동시에 여러분은M2시험고민을 하시지 않으셔도 됩니다.빨리 우리덤프를 장바구니에 넣으시죠.
M2최신버전 덤프샘플문제: https://www.pass4test.net/M2.html