私たちのH35-581_V2.0試験問題は、最も重要で効果的な報酬は、あなたが試験に合格させ、H35-581_V2.0認定試験資格書を得ることです。そしてそれは、すべての受験者が気になるものです。同時に、H35-581_V2.0でより実用的なスキルを得ることもでき、あなたの仕事の効率を向上させます。 私たちのH35-581_V2.0試験問題は信頼に値する商品です。
Huawei H35-581_V2.0認定試験を受ける資格を得るには、候補者は5Gワイヤレスネットワークの分野で少なくとも3年の経験が必要です。また、候補者は、ネットワークテクノロジー、プロトコル、標準、およびネットワーク計画、設計、展開、および最適化の経験を強く理解する必要があります。
H35-581_V2.0「HCIP-5G-RNP&RNO V2.0」はHuaweiの一つ認証試験として、もしHuawei認証試験に合格してIT業界にとても人気があってので、ますます多くの人がH35-581_V2.0試験に申し込んで、H35-581_V2.0試験は簡単ではなくて、時間とエネルギーがかかって用意しなければなりません。
世界がますますつながるにつれて、高速インターネットとモバイル接続の需要が急増しています。これにより、5Gテクノロジーの開発が急増しました。これは、これまで以上に速い速度、低下、およびより良い接続性を提供することを約束しています。 Huawei H35-581_V2.0認定試験は、電気通信業界における5Gテクノロジーの重要性の高まりの証です。
質問 # 61
During downlink data transmission, if a UE suddenly stops reporting CQI, which of the following issues will occur?
正解:B
解説:
CQI is part of the Channel State Information (CSI) reported by the UE to assist the gNodeB in downlink link adaptation.
The CQI value represents the estimated channel quality under configured reporting assumptions and helps determine an appropriate modulation order and coding rate.
When the UE stops reporting CQI, the scheduler loses an important source of updated radio-channel information.
In an implementation that retains the last valid channel-quality estimate, the scheduler may continue transmitting using the previously selected MCS.
However, this is not a universal requirement.
A gNodeB may also use HARQ acknowledgment statistics, observed decoding performance, configured fallback policies, or other available channel information to modify its scheduling decisions.
Consequently, downlink transmission does not necessarily stop, and a low-order MCS is not always selected.
The absence of fresh CQI can adversely affect link-adaptation accuracy and throughput, so option D is also not generally appropriate.
Option C therefore reflects the expected simplified behavior, but its use of the word always makes the statement technically overrestrictive.
Official Reference: 3GPP TS 38.214, Sections 5.1 and 5.2, PDSCH Procedures and CSI Reporting ; TS
38.321, HARQ Operation and MAC Procedures .
Technical warning / qualification: 3GPP does not mandate that an unchanged MCS must always be used after CQI reporting stops. The answer is valid only under a specific scheduler implementation or fallback policy. As written, the question has no universally guaranteed correct option.
質問 # 62
Which TA offsets may be configured for a 5G network operating in n41?
Select All that Apply
正解:A、B
解説:
Options B and C are correct because the standardized Timing Advance (TA) offset values applicable to an NR Frequency Range 1 (FR1) Time Division Duplex (TDD) deployment include 25600 T_c and 39936 T_c, depending on the coexistence scenario.
NR band n41 operates in FR1 using TDD.
Timing Advance enables the UE to adjust uplink transmission timing so that signals from different UEs arrive at the gNodeB within the required timing alignment.
In NR, the effective uplink timing relationship includes a timing-advance offset represented by N_TA,offset.
According to the standardized timing requirements:
Option B - 25600 T_c: This value applies to FR1 TDD operation without the relevant LTE-NR coexistence requirements. It is also the default FR1 offset in applicable configurations when no explicit n- TimingAdvanceOffset is provided.
Option C - 39936 T_c: This value applies to FR1 TDD operation involving LTE-NR coexistence.
Option A - 0 T_c: This value is associated with the specified FR1 FDD coexistence case, not the normal n41 TDD configurations represented by this question.
Option D - 51200 T_c: This is not one of the applicable standardized NR timing-advance offset values.
Therefore, B and C are correct.
Official Reference: 3GPP TS 38.533, Section 4.4.1.0.1, Table 4.4.1.0.1-2, Timing Advance Offset Values ; TS 38.213, Section 4.2, Transmission Timing Adjustments .
質問 # 63
How many consecutive symbols does each SSB occupy in the time domain?
正解:B
解説:
Each Synchronization Signal and Physical Broadcast Channel Block (SSB), formally identified as an SS
/PBCH block, occupies four consecutive Orthogonal Frequency Division Multiplexing (OFDM) symbols in the time domain.
In 5G NR, the SSB provides essential information for initial cell search, synchronization, physical cell identity detection, and acquisition of broadcast system information.
According to 3GPP TS 38.211, Section 7.4.3.1, an SS/PBCH block occupies four consecutive OFDM symbols, numbered 0 through 3.
The SSB contains the Primary Synchronization Signal (PSS), Secondary Synchronization Signal (SSS), Physical Broadcast Channel (PBCH), and associated PBCH Demodulation Reference Signals (DM-RS).
The PSS enables the UE to detect a component of the physical cell identity and establish initial timing synchronization.
The SSS provides the remaining information required to determine the complete physical cell identity and assists synchronization.
The PBCH carries the Master Information Block (MIB), which provides essential configuration information for acquiring further system information.
In the frequency domain, each SSB spans 240 contiguous subcarriers.
Although multiple SSBs may be transmitted within an SSB burst set to support beam sweeping, the time- domain duration of an individual SSB remains exactly four consecutive OFDM symbols.
Official Reference: 3GPP TS 38.211, Section 7.4.3.1, Time-Frequency Structure of an SS/PBCH Block , Table 7.4.3.1-1.
質問 # 64
Which of the following link-budget parameters is unrelated to the frequency band?
正解:D
解説:
Interference margin is the expected answer because it represents an allowance for interference-related degradation rather than a direct propagation-loss component determined by the operating frequency band.
In 5G radio-network planning, the link budget estimates the maximum allowable propagation loss while maintaining the required received signal level and service performance.
The calculation considers parameters such as transmitter power, antenna gains, receiver sensitivity, feeder losses, penetration losses, fading margins, and interference assumptions.
Rain and snow fading is frequency dependent because precipitation-related electromagnetic attenuation varies with carrier frequency, particularly in higher-frequency operating bands.
Penetration loss also depends strongly on frequency and the characteristics of the materials through which the radio signal travels.
Concrete, glass, and other building materials can introduce substantially different attenuation at different operating frequencies.
Shadow fading margin accounts for slow variations in received signal power caused by environmental obstructions. Its statistical characteristics depend on the propagation scenario and can vary between frequency bands.
Interference margin , however, primarily accounts for degradation caused by neighboring transmissions, network loading, frequency reuse, antenna configurations, and resource-management behavior.
Although the actual interference environment can differ between frequency bands, interference margin is not an inherent frequency-dependent attenuation term.
Therefore, option D is the intended answer.
Official Reference: Huawei, 5G Wireless Network Planning Solution White Paper , Section 2.2.1, High- Precision 5G Propagation Model ; 3GPP TR 38.901, Study on Channel Model for Frequencies from 0.5 to
100 GHz .
Technical warning / qualification: Interference margin can indirectly depend on the operating band through deployment density, propagation, and spectrum conditions. The distinction concerns intrinsic propagation attenuation versus network-interference assumptions.
質問 # 65
Which of the following slot configurations has a relatively large E2E delay?
正解:A
解説:
Option A is the expected answer because its slot configuration creates a relatively long interval between uplink transmission opportunities, increasing the scheduling-related latency experienced by applicable traffic.
In Time Division Duplex (TDD) operation, uplink and downlink transmissions share the same carrier- frequency resources but occur in different time-domain intervals.
The configured slot pattern determines the distribution of downlink slots, uplink slots, and special slots.
In the 8:2 configuration, the sequence DDDDDDDSUU contains seven consecutive downlink slots, followed by a special slot and two uplink slots.
For 30 kHz subcarrier spacing, a normal slot lasts 0.5 ms, producing a 5 ms configuration period.
Consequently, uplink packets arriving shortly after the available uplink opportunities may experience substantial waiting time before the next usable uplink slot.
The other configurations provide more frequent uplink opportunities, which generally reduces waiting time for uplink transmissions and selected feedback procedures.
Such delays can influence uplink scheduling requests, HARQ timing, and application-level responsiveness.
However, actual end-to-end latency also depends on traffic direction, processing delays, network congestion, retransmissions, and transport-network conditions.
Therefore, option A is the best answer when comparing the scheduling-related latency implications of the listed TDD patterns.
Official Reference: 3GPP TS 38.213, Section 11.1, UE Procedures for Determining Slot Format ; TS
38.331, TDD-UL-DL-ConfigCommon and TDD-UL-DL-ConfigDedicated .
Technical warning / qualification: The comparison assumes similar operating conditions and emphasizes uplink opportunity waiting time. The slot pattern alone does not establish a universally highest end-to-end latency for every traffic flow.
質問 # 66
......
H35-581_V2.0専門知識: https://www.jptestking.com/H35-581_V2.0-exam.html