SRAN-Radio-Network-Performance-Optimization최신시험, SRAN-Radio-Network-Performance-Optimization인증덤프샘플다운로드

Nokia SRAN-Radio-Network-Performance-Optimization 덤프의 PDF 버전과 Software 버전의 내용은 동일합니다. PDF버전은 프린트 가능한 버전으로서 단독구매하셔도 됩니다. Software 버전은 테스트용으로 PDF 버전 공부를 마친후 시험전에 실력테스트 가능합니다. Software 버전은 PDF버전의 보조용이기에 단독 판매하지 않습니다. 소프트웨어버전까지 필요하신 분은 PDF버전을 구입하실때 공동구매하셔야 합니다.

Nokia SRAN-Radio-Network-Performance-Optimization Exam Syllabus Topics:

SectionWeightObjectives
Advanced Optimization and SON Features10%- Self-Organizing Networks (SON) use cases and optimization
- Energy saving and advanced features
Quality of Service and Resource Management15%- QoS parameters, scheduling and admission control
- Radio resource management and optimization
SRAN Performance Optimization Fundamentals25%- Key performance indicators (KPIs) definition and measurement
- Network performance monitoring and analysis tools
- Performance optimization principles and methodology
Coverage and Capacity Optimization30%- Coverage analysis, tuning and optimization
- Capacity planning, load balancing and optimization
- Interference analysis and mitigation techniques
Mobility and Handover Optimization20%- Mobility robustness and optimization
- Handover parameters and algorithms
- Inter-RAT mobility and optimization

>> SRAN-Radio-Network-Performance-Optimization최신시험 <<

최신버전 SRAN-Radio-Network-Performance-Optimization최신시험 덤프는 MN: NCSS NPS - SRAN Radio Network Performance Optimization Certification Exam | GS40-NPS-SRPER-E-S03-2510 시험을 단번에 패스하는 필수자료

PassTIP에서 판매하고 있는 Nokia SRAN-Radio-Network-Performance-Optimization인증시험자료는 시중에서 가장 최신버전으로서 시험적중율이 100%에 가깝습니다. Nokia SRAN-Radio-Network-Performance-Optimization덤프자료를 항상 최신버전으로 보장해드리기 위해Nokia SRAN-Radio-Network-Performance-Optimization시험문제가 변경되면 덤프자료를 업데이트하도록 최선을 다하고 있습니다. PassTIP는 여러분이 자격증을 취득하는 길에서 없어서는 안되는 동반자로 되어드릴것을 약속해드립니다.

최신 MN: NCSS NPS - SRAN SRAN-Radio-Network-Performance-Optimization 무료샘플문제 (Q16-Q21):

질문 # 16
In NR SA Option 2, the UE is camped on an SA serving cell. An IRAT handover is triggered for a multi-QCI call, QCI 1 and QCI 6, due to weak coverage of the serving cell. What will happen to both QCIs during the IRAT handover toward LTE?

정답：C

설명：
The correct answer is D.
In 5G SA Option 2, NR works independently with the 5G Core, but interworking with LTE/EPC can be supported for mobility continuity. When IRAT handover toward LTE is triggered due to weak NR coverage, the goal is to preserve the active services during mobility.
For a multi-QCI service:
QCI 1 normally represents the voice bearer, such as VoLTE/IMS voice continuity after movement to LTE.
QCI 6 normally represents a non-GBR data bearer.
During a supported IRAT handover from NR SA to LTE, both the voice bearer and data bearer can be transferred to LTE, assuming proper interworking, bearer mapping, and LTE coverage availability.
Option C is incorrect because IRAT mobility from NR SA to LTE is supported in properly configured networks. Option A is incorrect because the voice bearer is the most critical bearer to preserve. Option B is also not the best answer because the data bearer does not necessarily need to be released during IRAT handover.
Therefore, the expected result is:
Both QCI 1 voice and QCI 6 data continue on LTE.


질문 # 17
What is the role of admission control in 5G networks ?

정답：D


질문 # 18
In a high-mobility network, the maximum cell size must be restricted to 33 km . Which PRACH format and restricted-set type should be used?

정답：B

설명：
The correct answer is Format 1 / Type B .
For PRACH planning, the selected preamble format must support the required cell radius. Format 0 is too short for a 33 km cell because it is typically suitable only up to around 14.5 km . Format 2 is also not suitable because its practical maximum cell radius is around 29.5 km , which is below the required 33 km . Therefore, a longer PRACH format is needed.
Because the scenario mentions high mobility , an unrestricted PRACH set is not preferred. High-mobility environments require a restricted set to handle Doppler effects and reduce ambiguity in PRACH preamble detection. Between the restricted-set options, Type B is the correct choice for this 33 km high-mobility case.
A matching Nokia-style question source also lists this exact scenario with Format 1 / Type B as option A.


질문 # 19
Consider that the UE is performing handover from LTE to NR with the help of features CB007742 / CB008731 . Referring to the picture below, at what stage can the handover be triggered from LTE to NR?

정답：A

설명：
The correct answer is C: From Stage 3 .
In LTE-to-NR mobility, the handover or redirection decision is normally based on a combination of:
LTE serving-cell signal level becoming weak enough, and
NR neighbor-cell signal level becoming strong enough.
From the diagram:
In Stage 1 , LTE is still good and NR is still weak, so LTE-to-NR HO should not be triggered.
In Stage 2 , the NR neighbor signal is improving, but the required combined LTE/NR mobility condition is not yet fully satisfied.
In Stage 3 , the NR neighbor signal has crossed the required NR threshold, while the LTE serving-cell signal has degraded enough to justify moving the UE from LTE to NR. This is the first valid stage where LTE-to- NR HO can be triggered.
In Stage 4 , NR is already clearly strong, but the handover could already have been triggered earlier in Stage 3.


질문 # 20
Single Network Slice Selection Assistance Information , or S-NSSAI , identifies a network slice. Which of the following statements are correct regarding NSSAI ? Refer to the diagram for basic information.

정답：C

설명：
The correct answer is D: A, B, C, and D .
In 5G network slicing, S-NSSAI identifies a single network slice. It is composed of:
SST , or Slice/Service Type
SD , or Slice Differentiator
Statement A is correct.
The combination of SST + SD can uniquely identify a slice. For example, two slices may both use SST 1 for eMBB/MBB-type service, but different SD values can separate them for different enterprises, tenants, or service groups.
Statement B is correct.
SST is mandatory. It is an 8-bit numeric field that indicates the expected slice/service behavior, such as eMBB, URLLC, or mMTC.
Statement C is correct.
SD is optional. It is a 24-bit field used to differentiate multiple slices that may share the same SST.
Statement D is correct.
SST may use standardized values, such as SST 1 for eMBB, SST 2 for URLLC, and SST 3 for mMTC/MIoT.
It may also use operator-specific or non-standardized values depending on deployment requirements.


질문 # 21
......

Nokia인증 SRAN-Radio-Network-Performance-Optimization시험은 등록하였는데 시험준비는 아직이라구요? Nokia인증 SRAN-Radio-Network-Performance-Optimization시험일이 다가오고 있는데 공부를 하지 않아 두려워 하고 계시는 분들은 이 글을 보는 순간 시험패스에 자신을 가지게 될것입니다. 시험준비 시간이 적다고 하여 패스할수 없는건 아닙니다. PassTIP의Nokia인증 SRAN-Radio-Network-Performance-Optimization덤프와의 근사한 만남이Nokia인증 SRAN-Radio-Network-Performance-Optimization패스에 화이팅을 불러드립니다. 덤프에 있는 문제만 공부하면 되기에 시험일이 며칠뒤라도 시험패스는 문제없습니다. 더는 공부하지 않은 자신을 원망하지 마시고 결단성있게PassTIP의Nokia인증 SRAN-Radio-Network-Performance-Optimization덤프로 시험패스에 고고싱하세요.

SRAN-Radio-Network-Performance-Optimization인증덤프 샘플 다운로드: https://www.passtip.net/SRAN-Radio-Network-Performance-Optimization-pass-exam.html