If you cannot complete the task efficiently, we really recommend using H35-581_V2.0 learning materials. Through the assessment of your specific situation, we will provide you with a reasonable schedule, and provide the extensible version of H35-581_V2.0 exam training you can quickly grasp more knowledge in a shorter time. In the same time, you will do more than the people around you. This is what you can do with H35-581_V2.0 Test Guide. Our H35-581_V2.0 learning guide is for you to improve your efficiency and complete the tasks with a higher quality. You will stand out from the crowd both in your studies and your work. The high quality of H35-581_V2.0 exam training is tested and you can be assured of choice.
| Section | Weight | Objectives |
|---|---|---|
| Topic 1: 5G Industry Applications & Private Network Solutions | 5% | - Vertical industry scenarios and KPI requirements - Private 5G network requirements and design |
| Topic 2: 5G Radio Network Optimization | 20% | - Coverage, capacity, and quality optimization - Drive test and signaling tracing - Performance indicator analysis - Fault diagnosis and troubleshooting |
| Topic 3: 5G Radio Network Planning | 10% | - Parameter planning and configuration - Interference analysis and mitigation - Link budget calculation - Coverage and capacity planning |
| Topic 4: 5G Radio Network In-depth Principles | 30% | - Massive MIMO and beamforming principles - 5G NR air interface fundamentals - 5G spectrum and frame structure - 5G NR protocol stack and signaling procedures |
| Topic 5: 5G RAN Feature Application | 35% | - Power control and load balancing - Energy saving and coverage enhancement features - Mobility management and handover optimization - Carrier aggregation and dual connectivity |
>> H35-581_V2.0 Sample Questions Pdf <<
There is not much disparity among these versions of H35-581_V2.0 simulating practice, but they do helpful to beef up your capacity and speed up you review process to master more knowledge about the H35-581_V2.0exam, so the review process will be unencumbered. Though the content of these three versions is the same, the displays of them are different. And you can try our H35-581_V2.0 Study Materials by free downloading the demos to know which one is your favorite.
NEW QUESTION # 45
Which of the following physical-layer processing procedures is dedicated to the DFT-S-OFDM waveform?
Answer: A
Explanation:
Transform precoding is the distinguishing physical-layer processing operation associated with Discrete Fourier Transform-spread Orthogonal Frequency Division Multiplexing (DFT-S-OFDM).
In 5G NR, uplink data transmission on the Physical Uplink Shared Channel (PUSCH) can use CP-OFDM or DFT-S-OFDM, subject to the applicable configuration.
DFT-S-OFDM introduces a Discrete Fourier Transform (DFT) operation into the symbol-processing chain before resource mapping and OFDM signal generation. This spreads modulation symbols across the allocated subcarriers.
A principal benefit is the reduction of Peak-to-Average Power Ratio (PAPR) compared with conventional CP- OFDM in typical operating conditions.
Lower PAPR enables the UE power amplifier to operate more efficiently, reducing the required amplifier back-off and potentially improving uplink coverage, particularly for power-limited terminals.
Scrambling, modulation, and layer mapping are not exclusive to DFT-S-OFDM. These operations also occur in other NR physical-layer processing chains.
By contrast, transform precoding provides the characteristic DFT-spreading operation associated with DFT-S- OFDM transmission.
Accordingly, option D is correct because it identifies the processing operation that distinguishes DFT-S- OFDM from conventional CP-OFDM.
Official Reference: 3GPP TS 38.211, Sections 6.3.1.1-6.3.1.4, PUSCH Scrambling, Modulation, Layer Mapping, and Transform Precoding ; TS 38.214, Section 6.1.3.
Technical warning / qualification: The original option states Transformer precoding . The standardized term is Transform precoding . The wording should be corrected in the published question bank.
NEW QUESTION # 46
Notification Control indicates whether the gNodeB must notify the core network when which of the following parameters can no longer be met?
Answer: C
Explanation:
The Guaranteed Flow Bit Rate (GFBR) is the correct answer because Notification Control enables the NG- RAN to notify the 5G Core when the guaranteed Quality of Service (QoS) requirements associated with a GBR QoS flow can no longer be fulfilled.
In the 5G QoS architecture, each QoS flow has a QoS profile containing parameters such as the 5G QoS Identifier (5QI), Allocation and Retention Priority (ARP), and additional bit-rate parameters where applicable.
For Guaranteed Bit Rate (GBR) QoS flows, GFBR specifies the bit rate that the network is expected to guarantee under the established QoS requirements.
When Notification Control is enabled, the NG-RAN evaluates whether the configured QoS characteristics remain achievable.
If the requested QoS profile cannot be satisfied, the NG-RAN can send a notification toward the Session Management Function (SMF) indicating that GFBR can no longer be guaranteed.
The standardized assessment may consider GFBR, Packet Delay Budget (PDB), and Packet Error Rate (PER).
The remaining parameters serve different purposes.
Session-AMBR limits aggregate bit rates for applicable non-GBR traffic within a PDU session.
UE-AMBR controls aggregate non-GBR traffic associated with the UE.
MFBR defines the maximum flow bit rate rather than the guaranteed flow bit rate.
Therefore, GFBR is the correct parameter.
Official Reference: 3GPP TS 23.501, Section 5.7.2.4, Notification Control .
NEW QUESTION # 47
For type 0 allocation, bitmaps are used to map resources, and this is applicable to downlink scheduling with a small amount of data because the minimum scheduling unit for this type is one RBG.
Answer: B
Explanation:
The statement is false in the intended examination context because resource allocation type 0 uses Resource Block Group (RBG) granularity, which is generally coarser than the individual Resource Block (RB) allocation granularity available through type 1.
In NR downlink scheduling, the gNodeB allocates Physical Downlink Shared Channel (PDSCH) resources according to the configured frequency-domain resource-allocation method.
According to 3GPP TS 38.214, type 0 allocation uses a bitmap in which each bit indicates whether a corresponding RBG is assigned to the scheduled UE.
An RBG normally contains multiple consecutive RBs, with its nominal size determined by the Bandwidth Part (BWP) size and the configured RBG-size parameter.
For example, standardized nominal RBG sizes include 2, 4, 8, and 16 RBs.
Type 0 supports flexible selection of adjacent or nonadjacent RBGs, making it useful for scheduling across separated frequency-domain resources.
However, it may allocate more bandwidth than necessary when only a small amount of data must be transmitted.
Type 1 allocation identifies a starting RB and a contiguous allocation length, permitting finer control of the assigned resource quantity.
Therefore, type 0 is not inherently preferable for small-data scheduling merely because its minimum normal allocation is one RBG.
Official Reference: 3GPP TS 38.214, Sections 5.1.2.2.1 and 5.1.2.2.2, Downlink Resource Allocation Types
0 and 1 .
Technical warning / qualification: Type 0 is not prohibited for small packets. The incorrect part is the conclusion that RBG-level granularity makes it particularly suitable for small-data scheduling.
NEW QUESTION # 48
Which of the following statements correctly compare LTE PCI with NR PCI?
Answer: B
NEW QUESTION # 49
Which of the following slot configurations has a relatively large E2E delay?
Answer: D
Explanation:
Option A is the expected answer because its slot configuration creates a relatively long interval between uplink transmission opportunities, increasing the scheduling-related latency experienced by applicable traffic.
In Time Division Duplex (TDD) operation, uplink and downlink transmissions share the same carrier- frequency resources but occur in different time-domain intervals.
The configured slot pattern determines the distribution of downlink slots, uplink slots, and special slots.
In the 8:2 configuration, the sequence DDDDDDDSUU contains seven consecutive downlink slots, followed by a special slot and two uplink slots.
For 30 kHz subcarrier spacing, a normal slot lasts 0.5 ms, producing a 5 ms configuration period.
Consequently, uplink packets arriving shortly after the available uplink opportunities may experience substantial waiting time before the next usable uplink slot.
The other configurations provide more frequent uplink opportunities, which generally reduces waiting time for uplink transmissions and selected feedback procedures.
Such delays can influence uplink scheduling requests, HARQ timing, and application-level responsiveness.
However, actual end-to-end latency also depends on traffic direction, processing delays, network congestion, retransmissions, and transport-network conditions.
Therefore, option A is the best answer when comparing the scheduling-related latency implications of the listed TDD patterns.
Official Reference: 3GPP TS 38.213, Section 11.1, UE Procedures for Determining Slot Format ; TS
38.331, TDD-UL-DL-ConfigCommon and TDD-UL-DL-ConfigDedicated .
Technical warning / qualification: The comparison assumes similar operating conditions and emphasizes uplink opportunity waiting time. The slot pattern alone does not establish a universally highest end-to-end latency for every traffic flow.
NEW QUESTION # 50
......
Professional ability is very important both for the students and for the in-service staff because it proves their practical ability in the area. Therefore choosing a certificate exam which boosts great values to attend is extremely important for them and the test H35-581_V2.0 certification is one of them. Passing the test certification can prove your outstanding major ability in some area and if you want to pass the H35-581_V2.0 test smoothly youβd better buy our H35-581_V2.0 test guide. And our H35-581_V2.0 exam questions boost the practice test software to test the clientsβ ability to answer the questions.
Exam H35-581_V2.0 Overview: https://www.pass4training.com/H35-581_V2.0-pass-exam-training.html