P.S. Free 2026 Nokia SRAN-Radio-Network-Performance-Optimization dumps are available on Google Drive shared by Free4Dump: https://drive.google.com/open?id=1soXiM7tc1uLUBna-ZvhxGbCseJK1ODsN
You can try SRAN-Radio-Network-Performance-Optimization free demo before you decide to buy the full version practice test. SRAN-Radio-Network-Performance-Optimization exam dumps details are researched and produced by our Professional Certification Experts who are constantly using industry experience to produce precise, and logical. Free4Dump SRAN-Radio-Network-Performance-Optimization Exam Dumps will not only help you pass in one attempt, but also save your valuable time.
| Section | Objectives |
|---|---|
| Topic 1: LTE/NR Performance Optimization | - Optimization techniques
|
| Topic 2: Radio Network Performance Fundamentals | - Key performance indicators (KPIs)
|
| Topic 3: Troubleshooting and Performance Analysis | - Network issue identification and resolution
|
| Topic 4: RF Optimization Principles | - Coverage and capacity optimization
|
| Topic 5: SRAN Architecture Overview | - SRAN network structure and components
|
>> SRAN-Radio-Network-Performance-Optimization Valid Exam Question <<
As a high-standard company in the international market, every employee of our SRAN-Radio-Network-Performance-Optimization simulating exam regards protecting the interests of clients as the creed of the job. We know that if we want to make the company operate in the long term, respecting customers is what we must do. Many of our users of the SRAN-Radio-Network-Performance-Optimization Exam Materials are recommended by our previous customers and we will cherish this trust. OurSRAN-Radio-Network-Performance-Optimization practice guide is not only a product you purchase but also a friend who goes with you.
NEW QUESTION # 29
At which mark are all conditions fulfilled for energy saving , so the cell will be switched off? Refer to the image below.
Answer: B
Explanation:
The correct answer is B , which corresponds to mark C in the diagram.
In the diagram, the energy-saving process follows these stages:
Before mark B , the cell is entering the power-saving period, but the required load condition has not yet been satisfied for the required duration.
At mark B , the measured load has gone below the configured threshold, but the cell is not switched off immediately. The system must confirm that the load remains below the required threshold for the configured time.
At mark C , the load has stayed below the required threshold for the required duration, shown as 5 minutes in the diagram. At this point, all conditions are fulfilled, and the cell can be switched off. The diagram also shows the state becoming:
energySavingState = energySaving
Marks D and E are already inside or near the later part of the power-saving period. Mark E is associated with operator suspension/exit behavior, not the initial moment when all switch-off conditions are first fulfilled.
NEW QUESTION # 30
Consider that the UE is performing handover from LTE to NR with the help of features CB007742 / CB008731 . Referring to the picture below, at what stage can the handover be triggered from LTE to NR?
Answer: B
Explanation:
The correct answer is C: From Stage 3 .
In LTE-to-NR mobility, the handover or redirection decision is normally based on a combination of:
LTE serving-cell signal level becoming weak enough, and
NR neighbor-cell signal level becoming strong enough.
From the diagram:
In Stage 1 , LTE is still good and NR is still weak, so LTE-to-NR HO should not be triggered.
In Stage 2 , the NR neighbor signal is improving, but the required combined LTE/NR mobility condition is not yet fully satisfied.
In Stage 3 , the NR neighbor signal has crossed the required NR threshold, while the LTE serving-cell signal has degraded enough to justify moving the UE from LTE to NR. This is the first valid stage where LTE-to- NR HO can be triggered.
In Stage 4 , NR is already clearly strong, but the handover could already have been triggered earlier in Stage 3.
NEW QUESTION # 31
The CB009425 feature provides several enhancements to improve the transmission link budget for VoNR, offering a better customer experience. Which statements are correct regarding this feature?
Answer: G
Explanation:
The correct answer is D.
The feature is focused on improving VoNR link robustness and user experience, especially near the cell edge or in difficult RF conditions. VoNR is sensitive to packet loss, delay, and uplink coverage limitations.
Therefore, link-budget improvement features commonly target BLER behavior, transport block sizing, and MCS robustness.
Statement A is correct because minimizing Packet Loss Rate, or PLR, directly improves VoNR speech quality and reduces mute, clipping, or robotic voice effects.
Statement B is correct because VoNR bearers can use specific initial BLER targets. A more suitable BLER target helps the scheduler choose a more robust MCS for voice traffic.
Statement C is correct because a configurable uplink minimum TBS, or Transport Block Size, helps ensure that small VoNR packets are transmitted efficiently and reliably.
Statement D is correct because MCS downgrade control can improve robustness by selecting a more conservative modulation and coding scheme for VoNR DRBs when radio conditions require it.
Therefore, all listed enhancements are part of the VoNR link-budget improvement concept:
A, B, C, and D.
NEW QUESTION # 32
In NR SA Option 2, the UE is camped on an SA serving cell. An IRAT handover is triggered for a multi-QCI call, QCI 1 and QCI 6, due to weak coverage of the serving cell. What will happen to both QCIs during the IRAT handover toward LTE?
Answer: C
Explanation:
The correct answer is D.
In 5G SA Option 2, NR works independently with the 5G Core, but interworking with LTE/EPC can be supported for mobility continuity. When IRAT handover toward LTE is triggered due to weak NR coverage, the goal is to preserve the active services during mobility.
For a multi-QCI service:
QCI 1 normally represents the voice bearer, such as VoLTE/IMS voice continuity after movement to LTE.
QCI 6 normally represents a non-GBR data bearer.
During a supported IRAT handover from NR SA to LTE, both the voice bearer and data bearer can be transferred to LTE, assuming proper interworking, bearer mapping, and LTE coverage availability.
Option C is incorrect because IRAT mobility from NR SA to LTE is supported in properly configured networks. Option A is incorrect because the voice bearer is the most critical bearer to preserve. Option B is also not the best answer because the data bearer does not necessarily need to be released during IRAT handover.
Therefore, the expected result is:
Both QCI 1 voice and QCI 6 data continue on LTE.
NEW QUESTION # 33
Which of these is a software solution targeted to provide NPO projects access to rich datasets, modern data analysis and visualization tools, with a high level of automation capability?
Answer: B
Explanation:
The correct answer is D .
NPAS is the correct software solution in this context. A public technical source describes NPAS as providing access to rich datasets and modern data analysis and visualization tools , which matches the wording of the question closely.
In Nokia/NPO project context, this type of platform is used to support network planning and optimization activities by enabling data ingestion, analysis, visualization, and automation. This helps engineers work with large RAN datasets more efficiently during optimization, modernization, and performance-improvement projects.
The other options are not the best match:
GeoSynthesis is more associated with geospatial/planning-style use cases.
MantaRay SON is related to SON automation and optimization functions.
LTEPAT is more LTE-focused and does not match the described broad analytics platform role.
Therefore, the correct answer is:
NPAS.
NEW QUESTION # 34
......
Our SRAN-Radio-Network-Performance-Optimization study questions are suitable for a variety of levels of users, no matter you are in a kind of cultural level, even if you only have high cultural level, you can find in our SRAN-Radio-Network-Performance-Optimization training materials suitable for their own learning methods. So, for every user of our SRAN-Radio-Network-Performance-Optimization Study Materials are a great opportunity, a variety of types to choose from, more and more students also choose our SRAN-Radio-Network-Performance-Optimization test guide, then why are you hesitating? Just choose our MN: NCSS NPS - SRAN Radio Network Performance Optimization Certification Exam | GS40-NPS-SRPER-E-S03-2510 study questions!
Relevant SRAN-Radio-Network-Performance-Optimization Questions: https://www.free4dump.com/SRAN-Radio-Network-Performance-Optimization-braindumps-torrent.html
What's more, part of that Free4Dump SRAN-Radio-Network-Performance-Optimization dumps now are free: https://drive.google.com/open?id=1soXiM7tc1uLUBna-ZvhxGbCseJK1ODsN