2026 Latest ExamTorrent SRAN-Radio-Network-Performance-Optimization PDF Dumps and SRAN-Radio-Network-Performance-Optimization Exam Engine Free Share: https://drive.google.com/open?id=1I9TQ_XcpTLwUCHhZn_7Yvy9Lzse-msu6
There are many merits of our product on many aspects and we can guarantee the quality of our SRAN-Radio-Network-Performance-Optimization practice engine. Firstly, our experienced expert team compile them elaborately based on the real exam. Secondly, both the language and the content of our SRAN-Radio-Network-Performance-Optimization study materials are simple. The content emphasizes the focus and seizes the key to use refined SRAN-Radio-Network-Performance-Optimization Questions and answers to let the learners master the most important information by using the least practic. Three, we provide varied functions to help the learners learn our study materials and prepare for the exam.
| Section | Weight | Objectives |
|---|---|---|
| Topic 1: Radio Network Performance Monitoring | 20-25% | - Performance data collection and analysis - Threshold configuration and alerting - Real-time network monitoring techniques - KPI definition and measurement - Performance monitoring tools and dashboards |
| Topic 2: Radio Network Optimization Techniques | 25-30% | - Capacity optimization strategies - Load balancing techniques - Coverage optimization methods - Interference analysis and mitigation - Handover optimization - Parameter tuning best practices |
| Topic 3: Performance Troubleshooting | 20-25% | - Root cause analysis methodologies - Network failure identification and resolution - Common performance issues diagnosis - Optimization case studies - Troubleshooting tools utilization |
| Topic 4: SRAN Architecture and Fundamentals | 15-20% | - SRAN solution components and functions - Single RAN integration principles - SRAN network architecture overview - Radio access concepts and principles |
| Topic 5: SRAN Optimization Tools and Reports | 10-15% | - Configuration management for optimization - Nokia NetAct and performance tools - Report generation and interpretation - Automated optimization features |
>> Best SRAN-Radio-Network-Performance-Optimization Preparation Materials <<
Many students often start to study as the exam is approaching. Time is very valuable to these students, and for them, one extra hour of study may mean 3 points more on the test score. If you are one of these students, then SRAN-Radio-Network-Performance-Optimization exam tests are your best choice. Because students often purchase materials from the Internet, there is a problem that they need transport time, especially for those students who live in remote areas. When the materials arrive, they may just have a little time to read them before the exam. However, with SRAN-Radio-Network-Performance-Optimization Exam Questions, you will never encounter such problems, because our materials are distributed to customers through emails. After you have successfully paid, you can immediately receive SRAN-Radio-Network-Performance-Optimization test guide from our customer service staff, and then you can start learning immediately.
NEW QUESTION # 22
During an intra-gNB DU handover , what is the role of the RRC Reconfiguration message sent by the gNB- CU to the UE?
Answer: B
Explanation:
The correct answer is A .
During an intra-gNB DU handover , the UE is moved from one cell/DU resource to another under the same gNB-CU control. The gNB-CU coordinates the handover preparation and sends an RRC Reconfiguration message to the UE.
The role of this message is to provide the UE with the required handover command information, such as:
Target PCell configuration
Radio resource configuration
Mobility control information
Random access configuration, when needed
Measurement or reconfiguration-related information
After receiving the RRC Reconfiguration , the UE performs the handover execution procedure toward the target cell and later responds with RRC Reconfiguration Complete .
Option B is incorrect because admission control and source-cell scheduling suspension are internal network- side procedures, not the UE-facing role of the RRC Reconfiguration message.
Option C is not the best answer because user-plane resource transfer is handled between gNB-CU/gNB-DU functions, while dedicated preamble allocation may be part of the configuration but is not the main purpose of the message.
Option D is incorrect because RLC reestablishment and PDCP recovery are lower-layer/user-plane handling actions, not the primary purpose of the RRC Reconfiguration message.
Therefore, the correct role is:
It instructs the UE to perform handover to the target PCell and provides measurement/configuration information.
NEW QUESTION # 23
In a 5G cell , the following parameter has been modified: lowLatencyReservation = 15 .
Which percentage of UEs will be reallocated to a higher SR periodicity group whenever the threshold for moving to a higher SR periodicity group is reached?
Answer: A
Explanation:
The correct answer is C .
In 5G uplink scheduling, SR , or Scheduling Request , is used by the UE to request uplink resources when it has data to send. SR periodicity affects uplink latency and PUCCH capacity: shorter SR periodicity gives lower latency but consumes more control-channel resources, while longer SR periodicity saves resources but increases delay.
The parameter lowLatencyReservation = 15 means 15% of the UE/resource share is reserved for the low- latency SR periodicity group. When the load threshold is reached, the remaining portion can be moved to a higher SR periodicity group.
Calculation:
100% # 15% = 85%
So the percentage of UEs that can be reallocated to a higher SR periodicity group is:
0.85 , or 85% .
NEW QUESTION # 24
At which mark are all conditions fulfilled for energy saving , so the cell will be switched off? Refer to the image below.
Answer: C
Explanation:
The correct answer is B , which corresponds to mark C in the diagram.
In the diagram, the energy-saving process follows these stages:
Before mark B , the cell is entering the power-saving period, but the required load condition has not yet been satisfied for the required duration.
At mark B , the measured load has gone below the configured threshold, but the cell is not switched off immediately. The system must confirm that the load remains below the required threshold for the configured time.
At mark C , the load has stayed below the required threshold for the required duration, shown as 5 minutes in the diagram. At this point, all conditions are fulfilled, and the cell can be switched off. The diagram also shows the state becoming:
energySavingState = energySaving
Marks D and E are already inside or near the later part of the power-saving period. Mark E is associated with operator suspension/exit behavior, not the initial moment when all switch-off conditions are first fulfilled.
NEW QUESTION # 25
Evaluate the impact of using MantaRay SON's centralized PCI optimization module compared to distributed SON implementations.
Answer: D
Explanation:
The correct answer is C .
A centralized SON approach has broader network-level visibility than a purely distributed implementation.
For PCI optimization , this is important because PCI conflicts, PCI confusion, and neighbor-related PCI issues are not always local to one cell. They may involve several neighboring cells, multiple layers, and sometimes multiple vendors.
Nokia positions MantaRay SON as a centralized, AI-powered network optimization and automation platform for improving RAN quality, efficiency, and customer experience. Nokia also describes MantaRay SON as supporting multi-supplier/non-real-time RIC functionality in the MantaRay SMO framework.
So compared with distributed SON, centralized PCI optimization can better analyze wider-area PCI relationships and resolve PCI problems across multi-vendor or multi-layer networks.
Therefore, the correct statement is:
Centralized PCI optimization can identify and resolve PCI issues across multi-vendor networks.
NEW QUESTION # 26
Identify the missing network components X, Y, and Z in the architecture diagram.
Answer: C
Explanation:
The correct answer is B .
In the 5G Core , component X is connected to:
N2 from NG-RAN
N11 toward SMF
N15 toward PCF
N26 toward the EPC mobility entity
These are typical interfaces of the AMF , or Access and Mobility Management Function . Therefore, X = AMF .
In the EPC , component Z is connected to:
S1-MME from eNB
S11 toward the gateway
N26 toward the 5GC AMF
These are typical interfaces of the MME , or Mobility Management Entity . Therefore, Z = MME .
Component Y is outside the core user-plane path and represents the external service network connected through N6/SGi , commonly shown as IMS in voice-service architecture diagrams. Therefore, Y = IMS .
So the correct mapping is:
X: AMF, Y: IMS, Z: MME.
NEW QUESTION # 27
......
We give customers the privileges to check the content of our SRAN-Radio-Network-Performance-Optimization real dumps before placing orders. Such high quality and low price traits of our SRAN-Radio-Network-Performance-Optimization guide materials make exam candidates reassured. The free demos of SRAN-Radio-Network-Performance-Optimization study quiz include a small part of the real questions and they exemplify the basic arrangement of our SRAN-Radio-Network-Performance-Optimization real test. They also convey an atmosphere of high quality and prudent attitude we make.
Flexible SRAN-Radio-Network-Performance-Optimization Learning Mode: https://www.examtorrent.com/SRAN-Radio-Network-Performance-Optimization-valid-vce-dumps.html
P.S. Free 2026 Nokia SRAN-Radio-Network-Performance-Optimization dumps are available on Google Drive shared by ExamTorrent: https://drive.google.com/open?id=1I9TQ_XcpTLwUCHhZn_7Yvy9Lzse-msu6