요즘 같은 인재가 많아지는 사회에도 많은 업계에서는 아직도 관련인재가 부족하다고 합니다.it업계에서도 이러한 상황입니다.Fortinet NSE7_SSE_AR-26시험은 it인증을 받을 수 있는 좋은 시험입니다. 그리고PassTIP는Fortinet NSE7_SSE_AR-26덤프를 제공하는 사이트입니다.
| Section | Objectives |
|---|---|
| Topic 1: Operations and Administration | - Management
|
| Topic 2: Deployment and Configuration | - FortiSASE deployment
|
| Topic 3: FortiSASE Architecture and Design | - SASE architecture concepts
|
| Topic 4: Security and Troubleshooting | - Security operations
|
>> NSE7_SSE_AR-26최신 인증시험 덤프데모 <<
많은 사이트에서Fortinet 인증NSE7_SSE_AR-26 인증시험대비자료를 제공하고 있습니다. 그중에서 PassTIP를 선택한 분들은Fortinet 인증NSE7_SSE_AR-26시험통과의 지름길에 오른것과 같습니다. PassTIP는 시험에서 불합격성적표를 받으시면 덤프비용을 환불하는 서비스를 제공해드려 아무런 걱정없이 시험에 도전하도록 힘이 되어드립니다. PassTIP덤프를 사용하여 시험에서 통과하신 분이 전해주신 희소식이 PassTIP 덤프품질을 증명해드립니다.
질문 # 107
The FortiGate devices are managed by FortiManager, and are configured for direct internet access (DIA). You confirm that DIA is working as expected for each branch, and check the SD-WAN zone configuration and firewall policies shown in the exhibits. Then, you use the SD-WAN overlay template to configure the IPsec overlay tunnels. You create the associated SD-WAN rules to connect existing branches to the company hub device and apply the changes on the branches. After those changes, users complain that they lost internet access. DIA is no longer working. Based on the exhibit, which statement best describes the possible root cause of this issue?
Exhibit 1
Exhibit 2
Exhibit 3
정답：C
설명：
The SD-WAN overlay template defines a zone for each underlay interface and moves the interfaces into those zones. This statement perfectly describes the likely sequence of events. The template, when applied, re- organizes the interfaces and zones, causing the existing firewall policy that relies on the old zone configuration to fail. This is the most plausible root cause. A deployment should preserve the distinction between the physical or logical WAN underlay, the IPsec overlay and the SD-WAN zone that groups forwarding members. These layers can have different routing and security-policy requirements. The configured architecture must also allow the required traffic paths and failover behavior rather than assuming every available interface is interchangeable. Before applying a topology change, review the interface dependencies, static and dynamic routing, security policies and provisioning templates. FortiGate can support multiple transport types, but routing and tunnel compatibility still determine whether the intended member is operationally eligible. In checking this outcome, an administrator should distinguish what the displayed exhibit proves from configuration prerequisites not visible in the screenshot. Routing eligibility, device role, rule matching, and software-version details should be verified before using the selected answer in a production decision. The referenced Fortinet documentation identifies the underlying feature and its supported configuration context.
References: https://docs.fortinet.com/document/fortimanager/7.6.6/administration-guide/224982/sd-wan- overlay-orchestration; https://docs.fortinet.com/document/fortigate/7.6.3/administration-guide/942095/sd-wan- members-and-zones
질문 # 108
You are planning a large SD-WAN deployment with approximately 1000 spokes and want to allow ADVPN between the spokes. Some remote sites use FortiSASE to connect to the company ' s SD-WAN hub. Which overlay routing configuration should you use?
정답：B
설명：
For a large-scale SD-WAN deployment (such as 1000 spokes) where ADVPN shortcut routing is required and some remote sites connect via FortiSASE, the recommended overlay routing configuration is BGP running on loopback interfaces, combined with dynamic BGP for ADVPN shortcut routing. This design leverages the scalability and resilience of BGP, allowing dynamic discovery and route exchange necessary for shortcut tunnels between spokes in ADVPN environments. Using loopback interfaces for BGP peering is considered best practice because it decouples routing protocol stability from physical link status, ensuring that if a physical underlay interface fails, the BGP session remains up as long as there's an alternate path. With dynamic BGP, each spoke can efficiently learn the routes to other spokes and dynamically establish shortcuts, which is critical at this scale. This method also integrates smoothly with FortiSASE for remote connectivity to the SD-WAN hub, providing flexibility and centralized management.References: A deployment should preserve the distinction between the physical or logical WAN underlay, the IPsec overlay and the SD-WAN zone that groups forwarding members. These layers can have different routing and security-policy requirements. The configured architecture must also allow the required traffic paths and failover behavior rather than assuming every available interface is interchangeable.
References: FortiSASE 25 Enterprise Administrator Study Guide (uploaded), PDF pages 10-11 and 61-65;
https://docs.fortinet.com/document/fortigate/7.6.0/sd-wan-sd-branch-architecture-for-mssps/245549/overlay-network-designs; https://docs.fortinet.com/document/fortigate/7.6.0/sd-wan-sd-branch-architecture-for-mssps
/778373/dynamic-bgp-on-loopback-dual-hub-region
질문 # 109
Refer to the exhibit. Which two conclusions can you draw from the output shown? (Choose two.)
Exhibit 1
정답：A,C
설명：
One SD-WAN rule is defined with application categories as the destination # The diagnose output shows application control matches such as Microsoft.Portal, Operational.Technology, and Social.Media, confirming that SD-WAN rules are using application categories as destinations. UDP traffic destined to the subnet
10.22.0.0/24 matches a policy route # The first entry (id=1) shows protocol=17 (UDP) with destination
10.22.0.0/24, confirming this traffic is handled by a policy route instead of an SD-WAN rule. FortiManager templates reduce repetitive work but must resolve to valid, device-specific configurations at installation time.
Device assignments, metadata mappings, ADOM scope, policy-package interfaces and provisioning order should be inspected together rather than troubleshooting any one object in isolation. A successful management connection does not guarantee a successful configuration installation. Review the installation preview and task log, then validate the resulting device configuration and operational diagnostics. This separates a deployment-time validation failure from a live tunnel, routing or SLA fault.
References: https://docs.fortinet.com/document/fortigate/7.6.3/administration-guide/144044
질문 # 110
An administrator is configuring SD-WAN to load balance their network traffic. Which two things should they consider when setting up SD-WAN? (Choose two.)
정답：A,C
설명：
SD-WAN load balancing in FortiOS 7.6 is not restricted to Best Quality rules. The Manual and Lowest Cost (SLA) modes provide documented multi-member load balancing behavior where applicable. Option A is correct because outbandwidth is one supported load-balancing algorithm for modes that permit traffic distribution; it uses outgoing bandwidth information to influence selection. Option C is correct because a Lowest Cost (SLA) rule can distribute eligible sessions among members meeting the required SLA targets when load balancing is enabled. Best Quality normally ranks links and selects the preferred member based on a quality metric, rather than using the conventional load-balance hash modes. This rules out B and D. A deployment may also have an out-of-SLA fallback policy, so the simple statement that only SLA-passing members are used should be read in the normal case where adequate SLA-eligible links exist. The administrator should verify that the selected SD-WAN members have routes to the destination and that the chosen algorithm is supported by the FortiOS version. This behavior is documented in the FortiOS 7.6 SD- WAN service and load-balancing configuration guidance.
References: https://docs.fortinet.com/document/fortigate/7.6.0/administration-guide/25967/equal-cost-multi- path
질문 # 111
An administrator wants to ensure that voice and video traffic receive priority treatment across the SD-WAN overlay used by FortiSASE. Which feature should be configured?
정답：A
설명：
Prioritizing real-time traffic such as voice and video requires traffic shaping policies combined with SD-WAN rules that reference application signatures, ensuring the correct QoS treatment and path selection for latency-sensitive applications.
질문 # 112
......
우리 PassTIP에서는 최고이자 최신의Fortinet 인증NSE7_SSE_AR-26덤프자료를 제공 함으로 여러분을 도와Fortinet 인증NSE7_SSE_AR-26인증자격증을 쉽게 취득할 수 있게 해드립니다.만약 아직도Fortinet 인증NSE7_SSE_AR-26시험패스를 위하여 고군분투하고 있다면 바로 우리 PassTIP를 선택함으로 여러분의 고민을 날려버릴수 있습니다.
NSE7_SSE_AR-26시험대비 최신 덤프자료: https://www.passtip.net/NSE7_SSE_AR-26-pass-exam.html