Our H19-404_V1.0 learning materials not only provide you with information, but also for you to develop the most suitable for your learning schedule, this is tailor-made for you, according to the timetable to study and review. I believe you can improve efficiency. Our H19-404_V1.0 exam prep will give you a complete after-sales experience. You can consult online no matter what problems you encounter. You can get help anywhere, anytime in our H19-404_V1.0 test material. H19-404_V1.0 test questions have very high quality services in addition to their high quality and efficiency.
| Section | Objectives |
|---|---|
| Topic 1: WLAN Planning and Design | - Wireless coverage planning - Capacity and performance design considerations |
| Topic 2: Huawei Campus Network Solutions | - CloudCampus solution architecture - iMaster NCE-Campus management platform |
| Topic 3: Campus Network Fundamentals | - Typical campus network deployment models - Enterprise campus network architecture principles |
| Topic 4: Presales Solution Design | - Customer requirement analysis - Solution proposal and design methodology |
| Topic 5: Network Security Design | - Campus security architecture considerations - Access control strategies |
| Topic 6: Switching and Routing in Campus Networks | - Layer 2 and Layer 3 design principles - VLAN and segmentation design |
Do you want to pass H19-404_V1.0 exam in a short time? H19-404_V1.0 dumps and answers from our ExamsLabs site are all created by the IT talents with more than 10-year experience in IT certification. The ExamsLabs site offers the most comprehensive certification standards and H19-404_V1.0 Study Guide. According to our end users of H19-404_V1.0 dumps, it indicates that the passing rate of H19-404_V1.0 exam is as high as 100%. If you have any questions about H19-404_V1.0 exam dump, we will answer you in first time.
NEW QUESTION # 55
Traffic can be forwarded directly between the two PRP ports of a PRP RedBox.
Answer: B
Explanation:
The statement is false. In Parallel Redundancy Protocol, LAN A and LAN B must remain two separate, failure-independent networks. A PRP RedBox connects a singly attached node or conventional network to both parallel LANs and behaves toward the PRP network like a doubly attached node. It duplicates outgoing frames and transmits one copy through each PRP port. For incoming traffic, it accepts the first valid copy and discards the later duplicate before forwarding the frame through its interlink port.
The RedBox must not operate as a normal bridge that directly forwards frames from its LAN A port to its LAN B port. Doing so would connect the two redundant LANs, potentially creating loops, duplicate propagation, broadcast amplification, and a common failure path. That would defeat the fundamental PRP requirement that failure or disruption in one LAN must not affect the other.
The original video contains the typing error "PPR RedBox"; the correct term is PRP RedBox , meaning Parallel Redundancy Protocol Redundancy Box. PRP topology requires two separate networks with no direct links between them, while the RedBox provides controlled redundant attachment for non-PRP devices.
NEW QUESTION # 56
Which of the following WLAN networking solutions is recommended when there are 15,000 wireless terminals on the customer network?
Answer: B
Explanation:
A network serving 15,000 wireless terminals is a large-scale WLAN and should use a standalone WAC solution. A dedicated WAC provides independent controller resources, scalable AP and user management, centralized WLAN policy control, and the ability to deploy controller redundancy without tying wireless- control capacity directly to a specific core-switch service card.
Huawei recommends a standalone WAC when the wireless network scale is large or when the wireless network is deployed independently over an existing wired campus. The WAC is typically connected to the aggregation or core layer in off-path mode, and VRRP hot standby can be used to improve reliability.
Native WAC solutions are valuable for unified wired and wireless management, authentication, forwarding, and policy enforcement. However, for a very large number of wireless terminals, the controller platform must be selected according to user, AP, traffic, and forwarding-capacity specifications. A standalone WAC allows the wireless control plane to be sized and expanded independently.
Option C provides the dedicated WAC together with the required core and aggregation or access infrastructure. Therefore, it is the recommended architecture for 15,000 wireless terminals.
NEW QUESTION # 57
Which of the following capabilities were introduced with Wi-Fi 7?
Answer: A,B
Explanation:
The capabilities introduced with Wi-Fi 7 are 4096-QAM and channel bandwidth of up to 320 MHz. Wi-Fi 7, based on IEEE 802.11be Extremely High Throughput, doubles the maximum channel width available under Wi-Fi 6 and Wi-Fi 6E from 160 MHz to 320 MHz where sufficient regulatory spectrum is available. It also introduces 4096-QAM, encoding 12 bits per modulation symbol compared with 10 bits for Wi-Fi 6's 1024- QAM. This can increase peak spectral efficiency when the signal-to-noise ratio is sufficiently high.
The other options were available before Wi-Fi 7. Support for up to eight spatial streams existed in earlier IEEE 802.11 generations, and MU-MIMO was already supported before Wi-Fi 7, with major uplink and downlink enhancements delivered by Wi-Fi 6. The 6 GHz band was commercially introduced through Wi-Fi
6E. Huawei's material specifically describes Wi-Fi 6E as extending Wi-Fi 6 into the 6 GHz spectrum. Wi-Fi 7 continues using 6 GHz but did not introduce it. Therefore, only A and C are correct.
NEW QUESTION # 58
If multiple Internet links are available, these links cannot be prioritized and can only be load-balanced.
Answer: B
Explanation:
The statement is false because Huawei SD-WAN supports both priority-based link selection and load balancing. Multiple Internet or WAN links do not have to be treated equally. An administrator can define a preferred or primary link and designate another link as secondary or backup according to application requirements, link quality, cost, bandwidth, or operational policy.
For delay- and packet-loss-sensitive services such as voice and video, a higher-quality link can be configured as the primary path and another link as the backup. If the primary link no longer satisfies the configured SLA thresholds, traffic can be dynamically switched to a better path. Huawei's material explicitly describes primary and secondary link selection based on SLA and also presents load-balancing-based steering as a separate option.
Load balancing is useful when an enterprise wants to utilize the bandwidth of multiple links concurrently.
Priority-based active/standby forwarding is preferable when one provider offers better quality or when one circuit should be reserved for critical services. Intelligent traffic steering can additionally consider application priority and current bandwidth utilization. Therefore, multiple links can be prioritized, load-balanced, or used in a policy-controlled combination, making option B correct.
NEW QUESTION # 59
Which solution can be used when users need to centrally control and manage Internet access traffic but do not have the required security-processing capability?
Answer: A
Explanation:
Professional security devices should be deployed at the headquarters or another centralized Internet-access site. Under centralized Internet access, branch Internet traffic is first carried through the SD-WAN overlay to the centralized gateway. The headquarters security infrastructure then performs access control and security inspection before forwarding the traffic to the Internet.
This approach is appropriate when branch CPEs lack sufficient processing capacity or advanced security functions. A centralized firewall or dedicated security platform can provide intrusion prevention, antivirus inspection, URL filtering, application control, content security, and unified logging. It also allows the enterprise to enforce one consistent security policy instead of maintaining separate advanced configurations at every branch.
Deploying advanced security capabilities on each CPE, as proposed in option C, is a distributed local- breakout design and does not satisfy the stated limitation concerning security-processing capability. Third- party cloud security services can be used in some site-to-cloud or secure Internet-access architectures, but they are not the intended headquarters-based centralized solution in this question.
Huawei explicitly states that centralized Internet traffic is diverted to the centralized access site and that the firewall function is deployed there to secure Internet services. Therefore, option D is correct.
NEW QUESTION # 60
......
With the rapid development of computer, network, and semiconductor techniques, the market for people is becoming more and more hotly contested. Passing a H19-404_V1.0 exam to get a certificate will help you to look for a better job and get a higher salary. If you are tired of finding a high quality study material, we suggest that you should try our H19-404_V1.0 Exam Prep. Because our materials not only has better quality than any other same learn products, but also can guarantee that you can pass the H19-404_V1.0 exam with ease.
Test H19-404_V1.0 Tutorials: https://www.examslabs.com/Huawei/HCSP-Presales/best-H19-404_V1.0-exam-dumps.html