P.S. Free 2026 Fortinet NSEI_OTS_AR-7.6 dumps are available on Google Drive shared by PassTorrent: https://drive.google.com/open?id=1LULq-2e_ikdJOQ9AkWmbwpn7OczGuezi
The desktop Fortinet NSE I - OT Security 7.6 Architect (NSEI_OTS_AR-7.6) practice exam software helps its valued customer to be well aware of the pattern of the real NSEI_OTS_AR-7.6 exam. You can try a free Fortinet NSE I - OT Security 7.6 Architect (NSEI_OTS_AR-7.6) demo too. This Fortinet NSE I - OT Security 7.6 Architect (NSEI_OTS_AR-7.6) practice test is customizable and you can adjust its time and Fortinet PDF Questions. PassTorrent helps you in doing self-assessment so that you reduce your chances of failure in the examination of Fortinet NSE I - OT Security 7.6 Architect (NSEI_OTS_AR-7.6) certification.
| Section | Objectives |
|---|---|
| Network security | - Configure virtual patching - Configure automation - Configure security inspections for industrial protocols |
| Asset management | - Fortinet Security Fabric for an OT network - Explain OT standard and Fortinet compliance - Implement device detection on FortiGate and FortiNAC |
| Monitoring and risk assessment | - Create FortiAnalyzer event handlers - Perform risk assessment and management - Analyze security reports from FortiAnalyzer |
| Network access control | - Configure network segmentation schemas - Configure network access authentication - Explain OT Ethernet concepts |
>> New NSEI_OTS_AR-7.6 Test Camp <<
Once you enter into our interface, nothing will disturb your learning the NSEI_OTS_AR-7.6 training engine except the questions and answers. So all you attention will be concentrated on study. At the same time, each process is easy for you to understand. There will have small buttons on the NSEI_OTS_AR-7.6 Exam simulation to help you switch between the different pages. It does not matter whether you can operate the computers well. Our NSEI_OTS_AR-7.6 training engine will never make you confused.
NEW QUESTION # 35
Refer to the exhibit.
Which statement about this partial Asset Identity List page is correct? (Choose one answer)
Answer: C
Explanation:
Based on the OT Security 7.6 Architect study guide regarding the Asset Identity Center and Asset Management :
* Vulnerability Visibility : The Asset Identity List tab displays key metadata for IT and OT devices, including detected addresses, users, and a specific column for Vulnerabilities .
* Virtual Patching Feature : In the OT Security 7.6 architecture, the " Vulnerabilities " column is populated through the OT Security Service license, which includes " OT vulnerability correlation definitions & virtual patching signatures " .
* Correlation Mechanism : FortiGate extracts metadata from OT traffic and uses these signatures to identify known vulnerabilities on the assets. For these vulnerabilities to be identified and correlated in the Asset Identity Center as shown in the exhibit (displaying a count of 8 vulnerabilities), the Virtual Patching feature must be active.
* Architectural Implementation : Virtual patching is a critical component of the " Protection " layer in OT networks, allowing administrators to secure legacy or unpatchable PLCs and RTUs by blocking exploit attempts at the network level using IPS-based virtual patching signatures.
* Exhibit Analysis : The presence of identified vulnerabilities (the number " 8 " in the red shield) in the Asset Identity List confirms that the FortiGate is actively performing vulnerability correlation, which is the operational result of having a Virtual Patching security profile applied to the relevant firewall policy.
NEW QUESTION # 36
Refer to the exhibit.
Based on the information provided on the partial Event Monitor page shown in the exhibit, how was the attack detected? (Choose one answer)
Answer: B
Explanation:
The correct answer is D. Automatically by an event handler . The study guide explicitly states that "Event handlers generate events on FortiAnalyzer" and "FortiAnalyzer uses event handlers to filter all incoming logs. If the logs received match the conditions set in the event handlers, FortiAnalyzer generates an event." It also says "You can view all generated events on the Event Monitor page." This directly matches the exhibit, which is showing entries on the Event Monitor page. Therefore, the attack shown there was detected automatically through an event handler .
The guide also explains the detection flow: "FortiAnalyzer receives logs," "FortiAnalyzer parses logs," and "FortiAnalyzer generates an event if a rule is matched in an event handler." In addition, the Event Monitor view includes the Handler column, which identifies the event handler that generated the event. That is why the attack is not considered manually detected, and it is not primarily detected by a playbook or stitch.
Playbooks and stitches are used for subsequent automation actions, but the event appearing in Event Monitor is created by the event handler mechanism.
NEW QUESTION # 37
Refer to the exhibit.
Which statement about this partial Asset Identity List page is correct? (Choose one answer)
Answer: C
Explanation:
The correct answer is B. A firewall policy has a Virtual Patching security profile applied to it .
The decisive clue in the exhibit is the Vulnerabilities column showing KEVs and device-specific vulnerability counts. The study guide explains the virtual patching workflow in this exact way: "FortiGate performs a lookup for device-specific vulnerabilities and mitigation rules in FortiGuard," then
"FortiGuard returns specific OT virtual patching signatures," and "FortiGate caches the signatures and mitigation rules that apply to each device." That is the same behavior reflected by the Asset Identity List showing vulnerability information per detected device.
The guide then states that "When traffic related to the vulnerable device reaches FortiGate, the firewall policy with the virtual patching profile applies." It also says "A virtual patching profile can be applied to firewall policies in any direction, protecting traffic from or to the vulnerable OT device." This directly links the per-device vulnerability visibility to a Virtual Patching profile enforced through firewall policy.
The other options do not match the exhibit. Antivirus is not described in the study guide as building a device- by-device vulnerability list, Application Control is used for OT protocol and message visibility, and IPS focuses on exploit detection and prevention. The Vulnerabilities/KEVs display is the indicator that FortiGate is using Virtual Patching logic for those OT devices.
NEW QUESTION # 38
Refer to the exhibits.
The Playbook Monitor dashboard and the analysis of the corresponding incident analysis are shown. You created the playbook with the objective of automatically attaching the report to the incident that was created.
Which two statements are correct? (Choose two answers)
Answer: A,B
Explanation:
The correct answers are C and D .
Option D is correct because the Playbook Monitor clearly shows the starter as On_Demand and the trigger as user(admin) . The study guide states that "ON_DEMAND: The playbook runs when an administrator manually starts it" and also notes that to run it manually, you select the playbook and click Run . This exactly matches the exhibit, so the playbook was manually triggered.
Option C is also correct. The study guide explains that "tasks run one after another" and that "if needed, the output of one task can be used by the tasks that follow it." It also gives an example where workflow logic matters, such as creating an incident and then attaching details to it. In the exhibit, the sequence shown is Attach_report , then Run_report , then Create_Incident , while the incident analysis shows no report attached . Since the report must exist and the incident must already be available before it can be attached properly, the task order is wrong and must be reordered.
Option B is incorrect because the monitor shows multiple tasks completed successfully, not only Create_Incident . Option A is not the best answer because the main problem demonstrated by the exhibits is not simply waiting time, but the incorrect workflow order. The playbook completed successfully, yet the report is still not attached, which indicates a design issue in the task sequence rather than just a delay.
NEW QUESTION # 39
Refer to the exhibit.
A firewall policy page is shown. To improve the security of your OT network, you have configured a Supervisor profile in the firewall policies, as shown in the exhibit. However, a supervisor is reporting that he cannot ping PLC-1. What are the two reasons? (Choose two answers)
Answer: A,D
Explanation:
The correct answers are A and C .
Option A is correct because the study guide explains that with active authentication , FortiGate prompts the user only when they use "an acceptable login protocol." It states: "When you use only active authentication, if all possible policies that could match the source IP address have authentication enabled, then the user will receive a login prompt (assuming they use an acceptable login protocol)." A direct ping to PLC-1 uses ICMP , which is not the kind of login protocol used to trigger user authentication.
So the supervisor must first authenticate through a protocol such as HTTPS or Telnet , then the ICMP traffic can match the authenticated policy.
Option C is also correct because the exhibit shows policy ID 8 greyed out, meaning it is not enabled. That policy appears above the Supervisor_access (9) policy and allows broader access to PLC-1 , whereas policy 9 is limited to ALL_ICMP . The study guide explains that "Because the user has not yet authenticated, the user group aspect of the traffic does not match" and FortiGate continues searching for another complete match. In this case, with policy 8 disabled, the supervisor is left with only the ICMP rule, which cannot be used to perform the initial login step needed for active authentication.
Option B is not supported by the exhibit. Option D is incorrect because auth-on-demand always would force authentication prompts more aggressively, but the core problem here is that the user is trying to start with ICMP and the broader policy that could permit the initial authenticated access is disabled.
NEW QUESTION # 40
......
The Fortinet world has become so competitive and challenging. To say updated and meet the challenges of the market you have to learn new in-demand skills and upgrade your knowledge. With the Fortinet NSEI_OTS_AR-7.6 Certification Exam everyone can do this job nicely and quickly. The Fortinet NSE I - OT Security 7.6 Architect (NSEI_OTS_AR-7.6) certification exam offers a great opportunity to validate the skills and knowledge.
Sample NSEI_OTS_AR-7.6 Test Online: https://www.passtorrent.com/NSEI_OTS_AR-7.6-latest-torrent.html
BTW, DOWNLOAD part of PassTorrent NSEI_OTS_AR-7.6 dumps from Cloud Storage: https://drive.google.com/open?id=1LULq-2e_ikdJOQ9AkWmbwpn7OczGuezi