참고: ExamPassdump에서 Google Drive로 공유하는 무료, 최신 CWNA-109 시험 문제집이 있습니다: https://drive.google.com/open?id=1iLKdv2liu1bh434bZgyLxAQz77SXTopI
여러분은 우리. ExamPassdump의CWNP CWNA-109시험자료 즉 덤프의 문제와 답만 있으시면CWNP CWNA-109인증시험을 아주 간단하게 패스하실 수 있습니다.그리고 관련 업계에서 여러분의 지위상승은 자연적 이로 이루어집니다. ExamPassdump의 덤프를 장바구니에 넣으세요. 그리고 ExamPassdump에서는 무료로 24시간 온라인상담이 있습니다.
| 주제 | 소개 |
|---|---|
| 주제 1 |
|
| 주제 2 |
|
| 주제 3 |
|
| 주제 4 |
|
| 주제 5 |
|
ExamPassdump는 저희 제품을 구매한 분들이 100%통과율을 보장해드리도록 최선을 다하고 있습니다. ExamPassdump를 선택한것은 시험패스와 자격증취득을 예약한것과 같습니다. ExamPassdump의 믿음직한 CWNP인증 CWNA-109덤프를 공부해보세요.
질문 # 151
You are troubleshooting a problem with a new 802.11ax AP. While the AP supports four spatial streams, most clients are only achieving maximum data rates of 150 Mbps. What is the likely cause?
정답：C
설명：
The scenario described suggests that while the Access Point (AP) is capable of 802.11ax (Wi-Fi 6) with four spatial streams, the clients are only achieving data rates typical of 802.11n (Wi-Fi 4) devices, which indicates that the clients are likely 802.11n devices. Here's why this is the most plausible explanation:
* 802.11n Limitations: Devices that adhere to the 802.11n standard have lower maximum data rates compared to 802.11ax devices due to differences in technology such as modulation, spatial streams, and channel bandwidth. An 802.11n device with a single spatial stream operating on a 20 MHz channel can achieve a maximum data rate of 72.2 Mbps. Even with two spatial streams under ideal conditions, this would only double to approximately 144.4 Mbps, which is close to the 150 Mbps mentioned.
* Spatial Stream Capability: The fact that the AP supports four spatial streams suggests it can achieve much higher data rates with 802.11ax clients that also support multiple spatial streams. However, if the clients are 802.11n devices, they may not be capable of using more than two spatial streams, and many earlier 802.11n devices were limited to just one.
The other options are less likely to be the primary cause based on the information provided:
* B. Two Stream 802.11ax Clients: If the clients were 802.11ax with only two spatial streams, they would likely achieve higher data rates than 150 Mbps due to the efficiency improvements in 802.11ax.
* C. Contention and D. Non-Wi-Fi Interference: While these could affect performance, they would not inherently limit clients to 150 Mbps,especially in the context of an 802.11ax environment where mechanisms to handle interference and contention are more advanced.
References:
* IEEE 802.11n-2009: Enhancements for Higher Throughput.
* CWNA Certified Wireless Network Administrator Official Study Guide: Exam PW0-105, by David D.
Coleman and David A. Westcott.
질문 # 152
You are troubleshooting a problem with interference from a non-802.11 device. Given that the device is not a WLAN device, you cannot use a protocol analyzer and have chosen to use a spectrum analyzer. You want to view the signal from the interfering device over time to see the activity that is generating.
What common spectrum analyzer view should you use for this analysis?
정답：B
설명：
The common spectrum analyzer view that you should use for this analysis is the Waterfall/Spectrogram view.
The Waterfall/Spectrogram view shows the signal from the interfering device over time on a three-dimensional graph. The x-axis represents frequency, the y-axis represents time, and the z-axis represents amplitude or power. The color of each pixel indicates the signal strength at a given frequency and time. The Waterfall/Spectrogram view can help you identify the characteristics of the interference source, such as its frequency range, duty cycle, modulation type, and pattern. References: [CWNP Certified Wireless Network Administrator Official Study Guide: ExamCWNA-109], page 524; [CWNA: Certified Wireless Network Administrator Official Study Guide: ExamCWNA-109], page 494.
질문 # 153
You are troubleshooting a client problem with a 2.4 GHz WLAN connection. The client is experiencing surprisingly low data rates during the work day. You analyze the workspace outside of business hours and detect a strong signal with a typical noise floor at the client location. During working hours, the user works with a laptop in the area and uses an external USB hard drive for continuous data access. The user also states that the laptop works as expected on her home network. The user working approximately 8 feet away from this client experiences no problems.
Based on this information, what is the likely cause of the problem?
정답：A
설명：
The likely cause of the problem is that the external hard drive is USB 3.0 and is causing a significant increase in the noise floor when in use. USB 3.0 devices are known to generate radio frequency interference (RFI) in the 2.4 GHz band due to their high data transfer rates and harmonics. This RFI can increase the noise floor and degrade the signal-to-noise ratio (SNR) of WLAN devices operating in the same band. This can result in lower data rates, reduced throughput, increased retransmissions, and poor performance. The problem may not occur outside of business hours or on the user's home network because of different usage patterns or environmental factors.
질문 # 154
A dual-band 802.11ac AP must be powered by PoE. As a class 4 device, what power level should be received at the AP?
정답：B
설명：
PoE has different standards that define different power levels for PSEs and PDs. The original standard, IEEE
802.3af, defines two classes of PSEs: Class 3 (15.4 W) and Class 4 (30 W). The newer standard, IEEE 802.3 at, also known as PoE+, defines four classes of PSEs: Class 0 (15.4 W), Class 1 (4 W), Class 2 (7 W), and Class 3 (12.95 W). The power level received at the PD is always lower than the power level provided by the PSE, due to cable resistance and power dissipation. The IEEE standards specify the minimum power level that must be received at the PD for each class of PSE. For a Class 4 PSE, the minimum power level received at the PD is 25.5 W910. References: CWNA-109 Study Guide, Chapter 7: Power over Ethernet (PoE), page
295; CWNA-109 Study Guide, Chapter 7: Power over Ethernet (PoE), page 289.
질문 # 155
You are reporting on the RF environment in your facility. The manager asks you to describe the noise floor noted in the report. Which of the following is the best explanation?
정답：A
설명：
The RF energy that exists in the environment from intentional and unintentional RF radiators that forms the baseline above which the intentional signal of your WLAN must exist is the best explanation of the noise floor noted in the report. The noise floor is a term that describes the level of background noise or interference in a wireless channel or band. The noise floor is measured in dBm (decibel-milliwatts) and it represents the minimum signal strength that can be detected or received by a wireless device. The noise floor is influenced by various factors, such as the sensitivity of the receiver, the antenna gain, the cable loss, and the ambient RF environment. The ambient RF environment consists of intentional and unintentional RF radiators that emit RF energy in the wireless spectrum. Intentional RF radiators are devices that are designed to transmit RF signals for communication purposes, such as Wi-Fi access points, Bluetooth devices, microwave ovens, or cordless phones. Unintentional RF radiators are devices that are not designed to transmit RF signals but generate electromagnetic radiation as a by-product of their operation, such as USB 3 devices, PC power supplies, or fluorescent lights. The noise floor affects WLAN performance and quality because it determines the minimum signal-to-noise ratio (SNR) that is required for a successful wireless transmission. SNR is the difference between the signal strength of the desired signal and the noise floor of the channel. SNR is also measured in dB and it indicates how much the signal stands out from the noise. A higher SNR means a better signal quality and a lower bit error rate. A lower SNR means a worse signal quality and a higher bit error rate. Therefore, to achieve a reliable WLAN connection, the intentional signal of your WLAN must exist above the noise floor by a certain margin that depends on the data rate and modulation scheme used. The other options are not accurate or complete explanations of the noise floor noted in the report. The noise caused by elevators, microwave ovens, and video transmitters is not the noise floor but rather examples of interference sources that contribute to the noise floor. The extra energy radiated by access points and client devices beyond that intended for the signal is not the noise floor but rather an example of spurious emissions that cause interference to other devices or channels. The energy radiated by flooring materials that causes interference in the 2.4 GHz and 5 GHz bands is not the noise floor but rather an example of attenuation or reflection that reduces or changes the direction of the signal. References: CWNA-109 Study Guide, Chapter 5: Radio Frequency Signal and Antenna Concepts, page 139
질문 # 156
......
어떻게CWNP인증CWNA-109시험을 패스하느냐 에는 여러 가지 방법이 있습니다. 하지만 여러분의 선택에 따라 보장도 또한 틀립니다. 우리ExamPassdump 에서는 아주 완벽한 학습가이드를 제공하며,CWNP인증CWNA-109시험은 아주 간편하게 패스하실 수 있습니다. ExamPassdump에서 제공되는 문제와 답은 모두 실제CWNP인증CWNA-109시험에서나 오는 문제들입니다. 일종의 기출문제입니다.때문에 우리ExamPassdump덤프의 보장 도와 정확도는 안심하셔도 좋습니다.무조건CWNP인증CWNA-109시험을 통과하게 만듭니다.우리ExamPassdump또한 끈임 없는 덤프갱신으로 페펙트한CWNP인증CWNA-109시험자료를 여러분들한테 선사하겠습니다.
CWNA-109인증시험 덤프문제: https://www.exampassdump.com/CWNA-109_valid-braindumps.html
참고: ExamPassdump에서 Google Drive로 공유하는 무료 2026 CWNP CWNA-109 시험 문제집이 있습니다: https://drive.google.com/open?id=1iLKdv2liu1bh434bZgyLxAQz77SXTopI