さらに、Jpshiken F5CAB2ダンプの一部が現在無料で提供されています：https://drive.google.com/open?id=1kXWtmmXTjH6J5vgB5464CzSh6LLfRhi8
F5CAB2試験の準備中に常に楽観的な心を持ち続けている場合、F5CAB2試験に合格し、関連するF5CAB2認定を取得することは非常に簡単だと深く信じています。近い将来。もちろん、楽観的な心を保つ方法は多くの人が答えるのが非常に難しい質問であることも知っています。私たちに知られているように、意志があるところには方法があります。この分野の専門家であるため、F5CAB2試験問題の助けを借りて素晴らしい結果が得られると信じています。
| トピック | 出題範囲 |
|---|---|
| トピック 1 |
|
| トピック 2 |
|
| トピック 3 |
|
Jpshikenが提供したF5のF5CAB2トレーニング資料を利用したら、F5のF5CAB2認定試験に受かることはたやすくなります。Jpshikenがデザインしたトレーニングツールはあなたが一回で試験に合格することにヘルプを差し上げられます。 JpshikenのF5のF5CAB2トレーニング資料即ち問題と解答をダウンロードする限り、気楽に試験に受かることができるようになります。まだ困っていたら、我々の試用版を使ってみてください。ためらわずに速くあなたのショッピングカートに入れてください。でないと、絶対後悔しますよ。
質問 # 51
A development team needs to apply a software fix and troubleshoot one of its servers. The BIG-IP Administrator needs to immediately remove all connections from the BIG-IP system to the back-end server. The BIG-IP Administrator checks the virtual server configuration and finds that a persistence profile is assigned to it.
What should the BIG-IP Administrator do to meet this requirement? (Choose one answer)
正解：B
解説：
In BIG-IP traffic management, persistence profiles cause existing client connections (and subsequent requests) to be repeatedly sent to the same pool member. When persistence is enabled, simply preventing new connections is not sufficient if the requirement is to immediately remove all existing connections.
Key behavior of pool member states:
Forced Offline
Immediately removes the pool member from load balancing.
Terminates all existing connections, regardless of persistence.
Prevents new connections from being established.
This is the correct state when urgent maintenance or troubleshooting is required.
Disabled
Prevents new connections from being sent to the pool member.
Allows existing connections to continue, which is not acceptable when persistence is configured and connections must be cleared immediately.
Offline (non-forced)
Similar to Disabled behavior depending on context.
Does not guarantee immediate termination of existing connections.
Manually deleting connections via the command line
Is unnecessary and operationally inefficient.
BIG-IP already provides a supported mechanism (Forced Offline) to cleanly and immediately remove traffic.
Conclusion:
To immediately remove all existing connections, including those maintained by persistence, the BIG-IP Administrator must set the pool member to a Forced Offline state. This directly satisfies the requirement without additional manual steps.
質問 # 52
Which three iRule events are likely to be seen in iRules designed to select a pool for load balancing? (Choose three.)
正解：D、E、F
質問 # 53
What type of virtual server will have a destination IP address of 0.0.0.0 and listen on a specific VLAN for requests?
正解：A
解説：
In BIG-IP LTM, aWildcardvirtual server is defined by using a destination IP address of 0.0.0.0. These virtual servers are designed to handle traffic that does not match any more specific Virtual Server destination address.
* 0.0.0.0 Destination:This address acts as a "catch-all" for IP traffic.
* VLAN Specificity:While the destination address is generic, a Wildcard virtual server is typically restricted to a specificVLAN(such as the Internal VLAN) to process outbound traffic from backend servers.
* Service Ports:A wildcard virtual server can be configured for a specific port (e.g., 0.0.0.0:80) or for all ports (0.0.0.0:0).
* Data Plane Usage:It is commonly used for transparently intercepting outbound traffic for the purpose of Source NAT (SNAT), bandwidth shaping, or directing traffic to a gateway pool.
質問 # 54
A BIG-IP Administrator needs to connect a BIG-IP system to two upstream switches to provide external network resilience. The network engineer instructs the administrator to configure interface binding with LACP. Which configuration should the administrator use? (Choose one answer)
正解：D
解説：
In BIG-IP architecture, link aggregation and redundancy at Layer 2 are implemented using Trunks, not virtual servers or pools.
According to BIG-IP Administration Data Plane Concepts:
Interfaces are the physical network ports on the BIG-IP device
A Trunk is a logical grouping of multiple interfaces
Trunks can be configured to use LACP (Link Aggregation Control Protocol) to:
Provide link redundancy
Increase aggregate bandwidth
Allow automatic detection of link failures
VLANs are then assigned to the trunk, not directly to individual interfaces, once aggregation is in place Correct Design for the Scenario:
To connect BIG-IP to two upstream switches with LACP:
One physical interface from BIG-IP connects to Switch A
Another physical interface from BIG-IP connects to Switch B
Both interfaces are placed into the same trunk
LACP is enabled on the trunk and on the switches
This configuration allows:
Traffic to continue flowing if one interface or switch fails
Proper LACP negotiation between BIG-IP and the upstream switches
Clean separation of responsibilities (Layer 2 handled by trunking, Layer 4-7 by virtual servers) Why Option D Is Correct:
A Trunk containing an interface connected to each switch is exactly how BIG-IP implements LACP-based interface binding The trunk handles link state, load distribution, and failover at the data plane Why the Other Options Are Incorrect:
A & B - Virtual servers operate at Layers 4-7 and have nothing to do with physical link aggregation or LACP C - VLAN IDs and MAC addresses are not configured inside a trunk definition; trunks aggregate interfaces, and VLANs are applied to trunks Key Data Plane Concept Reinforced:
On BIG-IP systems, LACP is always configured on a Trunk, which aggregates physical interfaces to provide Layer 2 resiliency and bandwidth aggregation. Virtual servers and pools are not involved in physical interface binding.
質問 # 55
When using the setup utility to configure a redundant pair, you are asked to provide a "Failover Peer IP".
Which address is this?
正解：A
解説：
When establishing a redundant pair, each device must know where to send its health heartbeats and sync data.
* The Peer IP: The Failover Peer IP is the IP address belonging to the other BIG-IP device in the HA pair. This is typically a34 Self-IP on a dedicated "HA" or "Internal" VLAN, or the Management IP.
* Purpose: It identifies the destination for the "Heartbeat" (the "Are you alive?" check).
* Setup Context: During the initial setup, you tell Device A to look for Device B at its "Failover Peer IP," and you tell Device B to look for Device A at its respective "Failover Peer IP."
質問 # 56
......
誰もが私たちの人生の貴重を認識する必要があります。時間を無駄にすることはできないので、目標をまっすぐに達成するための良い方法が必要です。もちろん、最新のF5CAB2試験トレントが最適です。 F5CAB2試験の質問から、認定試験の知識だけでなく、質問に迅速かつ正確に回答する方法を学ぶことができることをお約束します。今、F5CAB2テストトレントのデモを無料でダウンロードして、すばらしい品質を確認できます。
F5CAB2学習資料: https://www.jpshiken.com/F5CAB2_shiken.html
ちなみに、Jpshiken F5CAB2の一部をクラウドストレージからダウンロードできます：https://drive.google.com/open?id=1kXWtmmXTjH6J5vgB5464CzSh6LLfRhi8