Huawei H35-581_V2.0시험을 어떻게 패스할가 고민그만하시고 DumpTOP의Huawei H35-581_V2.0시험대비덤프를 데려가 주세요. 가격이 착한데 비해 너무나 훌륭한 덤프품질과 높은 적중율은 DumpTOP가 아닌 다른곳에서 찾아볼수 없는 혜택입니다. Huawei H35-581_V2.0 덤프구매전 데모부터 다운받아 공부해보세요.
Huawei H35-581_V2.0 시험은 60개의 객관식 문제로 구성된 컴퓨터 기반 시험입니다. 시험은 감독 환경에서 진행되며, 후보자들은 시험을 완료하기 위해 120분의 시간이 주어집니다. 시험은 영어와 중국어로 제공되며, 합격 점수는 1000점 중 600점입니다.
우리의 덤프는 기존의 시험문제와 답과 시험문제분석 등입니다. DumpTOP에서 제공하는Huawei H35-581_V2.0시험자료의 문제와 답은 실제시험의 문제와 답과 아주 비슷합니다. DumpTOP는 여러분이 한번에Huawei H35-581_V2.0인증시험을 패스함을 보장 드립니다.
시험은 객관식 문제로 이루어져 있으며 컴퓨터 기반 형식으로 진행됩니다. 시험은 영어로 진행되며 약 2시간 동안 진행됩니다. 시험에 합격하려면 후보자는 1000점 중 최소 600점의 점수를 달성해야 합니다. 시험은 전 세계의 화웨이 공인 시험 센터에서 볼 수 있습니다.
Huawei H35-581_V2.0(HCIP-5G-RNP&RNO V2.0) 인증 시험은 5G 산업에서 경력을 발전시키고자 하는 전문가들에게 귀중한 자격증입니다. 이 시험은 5G 무선 네트워크 계획 및 최적화와 관련된 다양한 주제를 포괄하며, 후보자들의 이 분야에 대한 지식과 기술을 시험하는 것이 목적입니다. 이 인증을 취득하면 전문가들은 5G 네트워크 계획 및 최적화에 대한 전문성을 증명할 수 있으며, 5G 산업에서 도전적인 역할을 수행하는 데 잘 준비될 것입니다.
질문 # 31
In NSA networking, which procedure is initiated by a UE when a 5G cell change fails?
정답：B
설명：
The Secondary Cell Group (SCG) failure information procedure is initiated when a UE detects a qualifying failure associated with its NR secondary connection during Non-Standalone (NSA) operation.
In E-UTRA-NR Dual Connectivity (EN-DC), the LTE eNodeB functions as the Master Node, while the NR gNodeB provides secondary radio connectivity.
The NR Primary Secondary Cell (PSCell) serves as the principal serving cell within the SCG.
When a PSCell change fails, the UE may detect an SCG reconfiguration-with-synchronization failure or another relevant SCG failure condition.
Rather than immediately reestablishing the entire LTE master connection, the UE can report the SCG failure to the Master Node.
For EN-DC, the applicable reporting mechanism involves the SCGFailureInformationNR message transported using LTE RRC signaling.
The failure report can identify the failure type and provide available NR measurement information to assist diagnosis and recovery.
The Master Node may subsequently initiate SCG release, modification, or another appropriate recovery procedure.
Options A and B describe connection-establishment or reestablishment procedures rather than the specific reporting action required for an SCG failure.
Option C, MR, represents measurement reporting and is not the dedicated SCG failure notification mechanism.
Therefore, option D is correct.
Official Reference: 3GPP TS 36.331, Section 5.6.13a, NR SCG Failure Information ; TS 38.331, Section
5.7.3, SCG Failure Information .
Technical warning / qualification: The original options use RPC instead of the standardized abbreviation RRC . The wording has been preserved, but options A and B should be corrected before publication.
질문 # 32
Which of the following slot configurations has a relatively large E2E delay?
정답：D
설명：
Option A is the expected answer because its slot configuration creates a relatively long interval between uplink transmission opportunities, increasing the scheduling-related latency experienced by applicable traffic.
In Time Division Duplex (TDD) operation, uplink and downlink transmissions share the same carrier- frequency resources but occur in different time-domain intervals.
The configured slot pattern determines the distribution of downlink slots, uplink slots, and special slots.
In the 8:2 configuration, the sequence DDDDDDDSUU contains seven consecutive downlink slots, followed by a special slot and two uplink slots.
For 30 kHz subcarrier spacing, a normal slot lasts 0.5 ms, producing a 5 ms configuration period.
Consequently, uplink packets arriving shortly after the available uplink opportunities may experience substantial waiting time before the next usable uplink slot.
The other configurations provide more frequent uplink opportunities, which generally reduces waiting time for uplink transmissions and selected feedback procedures.
Such delays can influence uplink scheduling requests, HARQ timing, and application-level responsiveness.
However, actual end-to-end latency also depends on traffic direction, processing delays, network congestion, retransmissions, and transport-network conditions.
Therefore, option A is the best answer when comparing the scheduling-related latency implications of the listed TDD patterns.
Official Reference: 3GPP TS 38.213, Section 11.1, UE Procedures for Determining Slot Format ; TS
38.331, TDD-UL-DL-ConfigCommon and TDD-UL-DL-ConfigDedicated .
Technical warning / qualification: The comparison assumes similar operating conditions and emphasizes uplink opportunity waiting time. The slot pattern alone does not establish a universally highest end-to-end latency for every traffic flow.
질문 # 33
How many consecutive symbols does each SSB occupy in the time domain?
정답：D
설명：
Each Synchronization Signal and Physical Broadcast Channel Block (SSB), formally identified as an SS
/PBCH block, occupies four consecutive Orthogonal Frequency Division Multiplexing (OFDM) symbols in the time domain.
In 5G NR, the SSB provides essential information for initial cell search, synchronization, physical cell identity detection, and acquisition of broadcast system information.
According to 3GPP TS 38.211, Section 7.4.3.1, an SS/PBCH block occupies four consecutive OFDM symbols, numbered 0 through 3.
The SSB contains the Primary Synchronization Signal (PSS), Secondary Synchronization Signal (SSS), Physical Broadcast Channel (PBCH), and associated PBCH Demodulation Reference Signals (DM-RS).
The PSS enables the UE to detect a component of the physical cell identity and establish initial timing synchronization.
The SSS provides the remaining information required to determine the complete physical cell identity and assists synchronization.
The PBCH carries the Master Information Block (MIB), which provides essential configuration information for acquiring further system information.
In the frequency domain, each SSB spans 240 contiguous subcarriers.
Although multiple SSBs may be transmitted within an SSB burst set to support beam sweeping, the time- domain duration of an individual SSB remains exactly four consecutive OFDM symbols.
Official Reference: 3GPP TS 38.211, Section 7.4.3.1, Time-Frequency Structure of an SS/PBCH Block , Table 7.4.3.1-1.
질문 # 34
In an NSA access issue, which of the following can cause a UE not to report B1 measurement results?
Select All that Apply
정답：A,B,C,D
설명：
All four conditions can prevent a UE from generating or transmitting a valid B1 measurement report during Non-Standalone (NSA) E-UTRA-NR Dual Connectivity (EN-DC) access.
In NSA architecture, the LTE eNodeB acts as the Master Node and configures NR inter-RAT measurements to determine whether an eligible 5G NR cell can be added as a Secondary Node.
Event B1 is triggered when the measured quality of an inter-RAT neighboring cell exceeds the configured threshold, subject to hysteresis and time-to-trigger requirements.
Option A: Excessive received signal power may saturate the UE receiver, degrading synchronization-signal detection and preventing successful NR cell measurements.
Option B: If the LTE-side measurement configuration identifies a frequency that does not correspond to the intended NR SSB carrier, the UE may be unable to detect the target NR synchronization signals.
Option C: If the measured NR signal does not satisfy the configured B1 entry condition, the reporting event is not triggered.
Option D: An abnormal NR cell may fail to transmit the required synchronization signals correctly or provide measurable radio coverage, preventing a valid measurement result.
Therefore, all four conditions are plausible causes of missing B1 measurement reports.
Official Reference: 3GPP TS 36.331, Inter-RAT Measurement Reporting - Event B1 ; TS 38.533, Section
8.4.2, NR Inter-RAT Event-Triggered Reporting Requirements .
질문 # 35
Which of the following messages can carry NSSAI information?
Select All that Apply
정답：B,D
설명：
Options C and D are correct because Network Slice Selection Assistance Information (NSSAI) can be conveyed through both the NAS Registration Request and the NR RRCSetupComplete message.
In 5G, NSSAI enables the network to identify the network slices requested or supported for a particular UE.
Individual slices are represented by Single Network Slice Selection Assistance Information (S-NSSAI), comprising a Slice/Service Type (SST) and an optional Slice Differentiator (SD).
Option C - Registration Request: During 5G registration, the UE may include Requested NSSAI in its NAS Registration Request. This enables the Access and Mobility Management Function (AMF) to evaluate the requested slices against subscription information and network availability.
Option D - RRC Setup Complete: The NR RRCSetupComplete message includes an optional s-NSSAI- List information element. When supplied by the upper layers, this element can communicate S-NSSAI information during RRC connection establishment.
Options A and B are incorrect because RRCSetup and RRCSetupRequest do not contain the corresponding NSSAI information element.
The distinction is that the NAS Registration Request communicates slice information for core-network registration, whereas RRCSetupComplete can provide relevant slice assistance information through access- stratum signaling.
Therefore, C and D are the correct selections.
Official Reference: 3GPP TS 38.331, Section 6.2.2, RRCSetupComplete Message ; TS 24.501, Sections
4.6.2.3 and 8.2.6, Registration Request and Requested NSSAI .
질문 # 36
......
H35-581_V2.0인기시험덤프: https://www.dumptop.com/Huawei/H35-581_V2.0-dump.html