Passing a certification exam means opening up a new and fascination phase of your professional career. Prep4cram’s exam dumps enable you to meet the demands of the actual certification exam within days. Hence they are your real ally for establishing your career pathway and get your potential attested. If you want to check the quality of VNX301 certificate dumps, then go for free demo of the dumps and make sure that the quality of our questions and answers serve you the best. You are not required to pay any amount or getting registered with us for downloading free dumps.
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
You can download our VNX301 guide torrent immediately after you pay successfully. After you pay successfully you will receive the mails sent by our system in 10-15 minutes. Then you can click on the links and log in and you will use our software to learn our VNX301 prep torrent immediately. For the examinee the time is very valuable for them everyone hopes that they can gain high efficient learning and good marks. Not only our VNX301 Test Prep provide the best learning for them but also the purchase is convenient because the learners can immediately learn our VNX301 prep torrent after the purchase. So the using and the purchase are very fast and convenient for the learners.
NEW QUESTION # 11
You want to test a WAN circuit in a way that more closely simulates a single SCP or FTP file transfer. Which method should you use?
Answer: B
Explanation:
The correct answer is B . Versa documentation for internet speed tests explains that when you run an internet speed test from a Director node, it creates approximately 200 sessions . This is useful for measuring aggregate throughput, but it does not represent the behavior of a single application flow. The same documentation states that you can run a speed test with a single session from the device CLI, and that this is useful for simulating file transfer rates when using SCP or FTP .
Therefore, when the goal is to understand how a single file transfer behaves, the CLI-based single-session test is the best option. A default Director-based test may produce higher aggregate results because multiple sessions can use parallelism and better fill the pipe.
show interfaces brief is useful for interface status and addressing, but it does not measure file-transfer throughput. SLA latency is useful for path-quality monitoring, but latency alone does not show single- session TCP throughput.
NEW QUESTION # 12
Examine the exhibit below.
You are configuring Class of Service on a WAN-facing network interface, and you want to perform DSCP rewrite on the packets that are forwarded to the WAN.
However, you are not able to turn on DSCP rewrite.
Referring to the exhibit, what is the cause of this issue?
Answer: D
Explanation:
In the exhibit, the Add Associate Interface/Network window has Interface selected, and the interface name is set to vni-0/0 . The DSCP rewrite option is not available because rewrite behavior is intended to be applied at the network association level for the WAN network, not directly while associating only the physical
/logical interface. For WAN-facing CoS, the scheduler and shaping parameters can be attached to an interface, but DSCP rewrite policies are applied to remark traffic as it exits through a network context.
Versa SD-WAN design documentation explains that QoS rewrite rules rewrite packet QoS attributes as packets leave the VOS device, and that rewrite rules can modify IEEE 802.1p bits, IPv4 TOS/DSCP bits, and IPv6 traffic class bits. It also explains that a rewrite policy is commonly applied on a WAN network to remark traffic based on the forwarding class and loss priority assigned by QoS or App QoS policies. In the design example, Versa explicitly describes applying a QoS propagation or rewrite policy on the MPLS WAN network to remark traffic to a DSCP value. Therefore, the issue is the association type: it is set to Interface, not Network.
NEW QUESTION # 13
What are two features of the Stateful Firewall service in the Versa Operating System? (Choose two.)
Answer: A,D
Explanation:
The correct answers are A and D . Versa stateful firewall service includes classic firewall functions that track sessions and enforce traffic policy, and it can work with DoS policy enforcement. Versa's CLI guide includes Configuring DoS policies under the security configuration area, where DoS rules can match on source, destination, services, applications, URL category, IP version, DSCP, TTL, EtherType, and other packet or session attributes, and can then apply aggregate or classified DoS profiles. This validates DoS protection as a stateful firewall/security service capability.
Application-Level Gateways, or ALGs , are also associated with stateful firewall/NAT behavior because they inspect and assist protocol handling for applications that embed addressing or dynamic port information inside the payload or control channel. This is part of traditional stateful firewall service behavior rather than UTM content inspection.
NEW QUESTION # 14
A branch device has completed Stage 3 onboarding. Which set of tunnels or sessions should exist after the device becomes fully operational in the customer SD-WAN network?
Answer: A
Explanation:
The correct answer is A . In Versa Secure SD-WAN onboarding, the branch moves through three staging phases before becoming fully operational. Versa documentation states that in Stage 3 , Versa Director pushes the stage-three configuration to the branch device over the IKE session and reboots the branch. After this stage, the branch becomes fully operational and is part of the customer SD-WAN network. At this point, IKE and IPsec sessions are created between the branch and Controller , and VXLAN and ESP sessions are created between branch to branch .
This distinction is important because the Controller connection is used for SD-WAN control-plane functions, while branch-to-branch overlay communication uses tunnel encapsulation for data forwarding. The documentation also notes that branch-to-branch ESP is maintained using a lightweight DH key-pair proprietary protocol.
Options B, C, and D are incorrect. HTTPS to Director alone does not represent the complete SD-WAN operational tunnel state. BGP to Analytics is not the required operational tunnel set. GRE-only tunnels without IPsec do not match the Versa Stage 3 SD-WAN tunnel behavior described in the staging documentation.
NEW QUESTION # 15
Examine the exhibit below.
As an administrator of a Versa Secure SD-WAN deployment, you are asked to find the current bandwidth of each WAN circuit used for SD-WAN connectivity in a branch, but Versa Director is not displaying any information for the WAN circuits. In this scenario, what should be done to get the graph populated for all WAN circuits?
Answer: A
Explanation:
The correct answer is B . In the exhibit, Versa Director shows multiple branch interfaces and a Live Data column. To populate the bandwidth graph with current real-time statistics for all WAN circuits, Live Data must be selected for each WAN circuit that should be monitored. Versa documentation states that from a Director node, administrators can monitor VOS devices, provider organizations, tenants, events, and alarms. It also explains that Versa Director, together with Versa Analytics, can poll VOS devices in real time to provide visibility into what is happening on those devices and to assist with troubleshooting.
Because the requirement is to find the current bandwidth of each WAN circuit, simply refreshing the page is not enough. Refreshing only reloads the dashboard; it does not enable real-time polling for interfaces that are not selected. Selecting Live Data only for MPLS circuits would populate only MPLS- related data and would not satisfy the requirement for all WAN circuits. Unselecting and reselecting only the INET circuit affects only that one circuit. Therefore, the correct operational step is to enable Live Data for all WAN circuits shown in the branch interface dashboard.
NEW QUESTION # 16
......
It is known to us that the VNX301 exam has been increasingly significant for modern people in this highly competitive word, because the test certification can certify whether you have the competitive advantage in the global labor market or have the ability to handle the job in a certain area, especial when we enter into a newly computer era. Therefore our VNX301 practice torrent is tailor-designed for these learning groups, thus helping them pass the exam in a more productive and efficient way and achieve success in their workplace.
VNX301 Actual Exam: https://www.prep4cram.com/VNX301_exam-questions.html