ユーザーのプライバシー保護は、インターネット時代の永遠の問題です。多くの違法ウェブサイトはユーザーのプライバシーを第三者に販売するため、多くの購入者は奇妙なウェブサイトを信じることを嫌います。ただし、H35-581_V2.0学習エンジンH35-581_V2.0を購入する際に心配する必要はまったくありません。ユーザーの情報が私たちの評判を傷つけているため、ユーザーの情報を決して販売しないことを保証します。
| Section | Weight | Objectives |
|---|---|---|
| Topic 1: 5G Radio Network Planning | 10% | - Coverage and capacity planning - Parameter planning and configuration - Interference analysis and mitigation - Link budget calculation |
| Topic 2: 5G Radio Network In-depth Principles | 30% | - 5G NR protocol stack and signaling procedures - 5G NR air interface fundamentals - Massive MIMO and beamforming principles - 5G spectrum and frame structure |
| Topic 3: 5G Industry Applications & Private Network Solutions | 5% | - Vertical industry scenarios and KPI requirements - Private 5G network requirements and design |
| Topic 4: 5G RAN Feature Application | 35% | - Power control and load balancing - Energy saving and coverage enhancement features - Carrier aggregation and dual connectivity - Mobility management and handover optimization |
| Topic 5: 5G Radio Network Optimization | 20% | - Performance indicator analysis - Fault diagnosis and troubleshooting - Drive test and signaling tracing - Coverage, capacity, and quality optimization |
恐いHuaweiのH35-581_V2.0試験をどうやって合格することを心配していますか。心配することはないよ、JpshikenのHuaweiのH35-581_V2.0試験トレーニング資料がありますから。この資料を手に入れたら、全てのIT認証試験がたやすくなります。JpshikenのHuaweiのH35-581_V2.0試験トレーニング資料はHuaweiのH35-581_V2.0認定試験のリーダーです。
質問 # 54
A gNodeB can collect the causes of handover-preparation and handover-execution failures.
正解:B
解説:
The statement is true because 5G NR performance-management procedures support the collection of handover failure statistics, including information that identifies failures during both handover preparation and handover execution.
The handover procedure contains distinct preparation and execution phases.
During handover preparation , the source gNodeB coordinates with the target gNodeB or the core network to prepare the necessary radio and session resources.
Preparation can fail because of resource-admission restrictions, incompatible configuration, transport- signaling problems, or other procedural errors.
Applicable NGAP and XnAP handover failure messages include cause information that can be recorded for network performance analysis.
During handover execution , the UE attempts to access the target cell and complete the required radio- connection reconfiguration.
Execution failures can occur because of radio-link problems, random-access failures, timer expiration, or unsuccessful completion of the mobility procedure.
The gNodeB can collect relevant failure statistics through standardized performance measurements and applicable signaling or UE failure reports.
3GPP TS 28.552 defines separate counters for unsuccessful handover preparation and execution, including failure-cause-specific subcounters.
These measurements assist operators in distinguishing admission-control problems from radio-mobility and execution problems.
Therefore, option A is correct.
Official Reference: 3GPP TS 28.552, Sections 5.1.1.6.1.3 and 5.1.1.6.1.9, Number of Failed Handover Preparations and Executions ; TS 38.423, XnAP Handover Procedures .
質問 # 55
Which of the following statements regarding PDSCH allocation is incorrect?
正解:C
解説:
Option A is incorrect because conventional NR PDSCH resource-allocation type 1 assigns a contiguous set of Resource Blocks (RBs), rather than supporting both contiguous and discontinuous frequency-domain allocation.
In 5G NR, the gNodeB allocates PDSCH frequency-domain resources through Downlink Control Information (DCI), using the applicable resource-allocation type configured for the active Bandwidth Part (BWP).
Resource-allocation type 0 uses a bitmap to indicate the Resource Block Groups (RBGs) allocated to a UE.
Each RBG consists of one or more consecutive RBs, with its nominal size determined by the BWP size and configured RBG-size parameter.
Because the bitmap can identify separate RBGs, type 0 can represent contiguous or noncontiguous groups of allocated resources.
Resource-allocation type 1 uses a Resource Indication Value (RIV) to identify the starting RB and the number of consecutively allocated RBs.
This provides RB-level allocation granularity but does not permit arbitrary discontinuous allocation within the conventional type 1 representation.
Therefore, option B correctly identifies type 1 as RB-level allocation, while options C and D correctly describe the characteristics of type 0.
Only option A incorrectly attributes discontinuous allocation capability to conventional type 1.
Official Reference: 3GPP TS 38.214, Sections 5.1.2.2.1 and 5.1.2.2.2, Downlink Resource Allocation Types
0 and 1 .
質問 # 56
Which of the following channels or signals uses the same transmit power as the PUSCH?
正解:A
解説:
In NR, SRS is transmitted by the UE to provide uplink channel-sounding information for scheduling, channel estimation, beam management, and MIMO-related procedures.
The SRS transmission-power calculation follows the uplink power-control principles specified in 3GPP TS
38.213.
These principles include configured target-power parameters, transmission bandwidth, estimated path loss, path-loss compensation, and applicable closed-loop adjustments.
Under certain configurations, SRS may share a power-control adjustment state with PUSCH. Under other configurations, separate adjustment states and SRS-specific parameters are used.
Consequently, SRS transmission power is related to the PUSCH power-control mechanism but is not necessarily numerically identical to PUSCH transmit power .
PRACH has its own random-access transmit-power and power-ramping procedures.
PUCCH uses a separate uplink power-control calculation, while PDSCH is a downlink physical channel.
The intended comparison therefore points toward SRS, represented incorrectly as SRC in the original choices.
Official Reference: 3GPP TS 38.213, Sections 7.1 and 7.3, PUSCH and SRS Transmit Power Control .
Technical warning / qualification: Replace option C, SRC , with SRS . The question should also state uses a related power-control mechanism rather than uses the same transmit power , because the latter is not universally correct.
質問 # 57
What is the broadcast periodicity of the MIB in 5G?
正解:B
解説:
The NR Master Information Block (MIB) has a nominal broadcast scheduling periodicity of 80 milliseconds, with repetitions transmitted within the applicable MIB scheduling period.
The MIB is an essential component of 5G NR system-information acquisition. It is carried on the Broadcast Channel (BCH), physically transmitted through the Physical Broadcast Channel (PBCH) within a Synchronization Signal/PBCH Block (SSB).
The MIB contains information required for the UE to acquire System Information Block 1 (SIB1), including essential system-frame and control-channel configuration parameters.
Its information elements include the system frame number components, subcarrier spacing indication, SSB subcarrier offset, and parameters associated with the initial PDCCH configuration.
A distinction must be made between the MIB's nominal 80 ms scheduling periodicity and the repetition periodicity associated with SSB transmission.
An SSB burst may repeat at intervals such as 5, 10, 20, 40, 80, or 160 ms, depending on the applicable configuration and operating procedure.
For typical deployments, the UE may therefore receive repeated PBCH transmissions more frequently than every 80 ms.
The question concerns the standardized nominal MIB scheduling period rather than the interval between every PBCH transmission.
Therefore, 80 ms is the correct answer.
Official Reference: 3GPP TS 38.331, Section 5.2.1.2, System Information Scheduling ; TS 38.212, Section
7.1, Broadcast Channel .
質問 # 58
Which of the following messages can carry NSSAI information?
Select All that Apply
正解:B、C
解説:
Options C and D are correct because Network Slice Selection Assistance Information (NSSAI) can be conveyed through both the NAS Registration Request and the NR RRCSetupComplete message.
In 5G, NSSAI enables the network to identify the network slices requested or supported for a particular UE.
Individual slices are represented by Single Network Slice Selection Assistance Information (S-NSSAI), comprising a Slice/Service Type (SST) and an optional Slice Differentiator (SD).
Option C - Registration Request: During 5G registration, the UE may include Requested NSSAI in its NAS Registration Request. This enables the Access and Mobility Management Function (AMF) to evaluate the requested slices against subscription information and network availability.
Option D - RRC Setup Complete: The NR RRCSetupComplete message includes an optional s-NSSAI- List information element. When supplied by the upper layers, this element can communicate S-NSSAI information during RRC connection establishment.
Options A and B are incorrect because RRCSetup and RRCSetupRequest do not contain the corresponding NSSAI information element.
The distinction is that the NAS Registration Request communicates slice information for core-network registration, whereas RRCSetupComplete can provide relevant slice assistance information through access- stratum signaling.
Therefore, C and D are the correct selections.
Official Reference: 3GPP TS 38.331, Section 6.2.2, RRCSetupComplete Message ; TS 24.501, Sections
4.6.2.3 and 8.2.6, Registration Request and Requested NSSAI .
質問 # 59
......
そんなに多くの人はHuawei H35-581_V2.0試験に合格できるのに興味がわきますか。人に引けをとりたくないあなたはHuawei H35-581_V2.0資格認定を取得したいですか。ここで、彼らはH35-581_V2.0試験にうまく合格できる秘訣は我々社の提供する質高いHuawei H35-581_V2.0問題集を利用したことだと教えます。弊社のHuawei H35-581_V2.0問題集を通して復習してから、真実的に自分の能力の向上を感じ、H35-581_V2.0資格認定を受け取ります。
H35-581_V2.0日本語版受験参考書: https://www.jpshiken.com/H35-581_V2.0_shiken.html