P.S.JPNTestがGoogle Driveで共有している無料の2026 International Code Council Fire-Inspector-IIダンプ：https://drive.google.com/open?id=1QpwdDAeL392_peqARcIfFtIW4wmR3O7w
Fire-Inspector-II試験問題の継続的な刷新により、当社は大きな市場シェアを占めています。強力な研究センターを構築し、Fire-Inspector-IIトレーニングガイドでより良い仕事をするために強力なチームを所有しています。これまで、Fire-Inspector-II学習教材に関する多くの特許を取得しています。一方で、当社International Code Councilは改修の恩恵を受けています。お客様は当社の製品を選択する可能性が高くなります。一方、私たちが投資したお金は有意義なものであり、Fire-Inspector-II試験の新しい学習スタイルを刷新するのに役立ちます。
| Section | Weight | Objectives |
|---|---|---|
| General Provisions for Fire Safety | 36% | - Fire protection systems - Building construction types and fire resistance ratings - Means of egress provisions - Fire safety requirements based on IFC |
| General Inspection Administration | 20% | - Documentation and reporting - Code enforcement processes - Inspection administration procedures |
| Occupancies | 27% | - Assembly, educational, healthcare, and other occupancy inspections - Occupancy classifications - Special occupancy requirements |
| Regulated Materials and Processes | 17% | - Hazardous materials inspection and handling - LP-gas and other regulated materials - Flammable and combustible liquids - Explosives and fireworks |
JPNTestの発展は弊社の商品を利用してIT認証試験に合格した人々から得た動力です。今日、我々があなたに提供するInternational Code CouncilのFire-Inspector-IIソフトは多くの受験生に検査されました。彼らにInternational Code CouncilのFire-Inspector-II試験に合格させました。弊社のホームページでソフトのデモをダウンロードして利用してみます。我々の商品はあなたの認可を得られると希望します。ご購入の後、我々はタイムリーにあなたにInternational Code CouncilのFire-Inspector-IIソフトの更新情報を提供して、あなたの備考過程をリラクスにします。
質問 # 54
Given: In automobile refinishing spray booths where drying by heat is done in the spray booth, the spray booth shall be equipped with interlocks between the spraying and drying apparatus and the ventilating system.
These interlocks shall be arranged to purge the spray vapors from the spray booth for a minimum period of __ minutes before the drying apparatus can be operated.
正解：A
解説：
In automobile refinishing spray booths where drying by heat occurs inside the same spray booth, fire codes require interlocks to prevent ignition hazards.
Before activating the drying apparatus, the ventilation system must purge the booth of spray vapors for at least
5 minutes to remove flammable concentrations.
Reference to Fire Inspector Documentation:
1. 2021 International Fire Code (IFC) - Section 2404.7.3 (Drying Operations in Spray Booths) IFC 2404.7.3 mandates that spray booths must have interlocks to purge vapors for a minimum of 5 minutes before activating the drying process.
This ensures that flammable vapors are removed before heat sources operate, reducing fire risks.
2. NFPA 33 - Standard for Spray Application Using Flammable or Combustible Materials (2021 Edition) - Section 15.4.6 NFPA 33, Section 15.4.6 confirms the requirement for a 5-minute ventilation purge cycle before heat drying.
Detailed Explanation of Answer Choices:
Option A (Incorrect): 2 minutes is insufficient for adequate vapor removal.
Option B (Incorrect): 3 minutes does not meet the minimum safety requirement.
Option C (Incorrect): 4 minutes is slightly below the code-mandated requirement.
Option D (Correct): 5 minutes is the minimum required purge time per IFC 2404.7.3 and NFPA 33.
Thus, the correct and verified answer is: D. 5.
質問 # 55
The maximum combined quantity of Class II and III liquids which may be stored in a flammable liquids storage cabinet is __ gallons.
正解：D
解説：
Reference to Flammable Liquids Storage Cabinet Requirements:
According to The International Fire Code (IFC 2021), Section 5704.3.2 and NFPA 30 (Flammable and Combustible Liquids Code), Section 9.5.3, the maximum amount of Class II and Class III liquids that can be stored in a flammable liquids storage cabinet is 120 gallons.
This limit ensures safe containment, fire protection, and reduced risk of liquid ignition or spillage.
Understanding Class II and III Liquids:
Class II liquids: Flash point between 100°F and 140°F (e.g., diesel fuel, kerosene).
Class III liquids: Flash point above 140°F (e.g., motor oil, cooking oils).
While these liquids are less volatile than Class I liquids, they still pose a fire risk, requiring proper storage in approved cabinets.
Clarification of Incorrect Answer Choices:
A: 10 gallons # Incorrect
Too low; IFC and NFPA allow up to 120 gallons in storage cabinets.
B: 60 gallons # Incorrect
This is the maximum for Class I liquids, but Class II and III liquids are allowed up to 120 gallons.
D: 240 gallons # Incorrect
Exceeds the allowable limit per IFC 5704.3.2 and NFPA 30, which set the maximum at 120 gallons per cabinet.
Conclusion:
The correct and verified answer is C (120 gallons) as per IFC 5704.3.2 and NFPA 30, ensuring compliance with flammable liquids storage safety standards.
質問 # 56
Which of the following situations requires securing of an operational permit from the code official prior to commencing the related activity?
正解：D
解説：
IFC Section 105.6 lists activities requiring operational permits. For A, lumber storage exceeding 100,000 board feet (bd. ft.) indoors or outdoors requires a permit (Section 105.6.28, Lumber Yards), but local thresholds may be lower-85,000 bd. ft. is close to this limit and likely exceeds typical exempt amounts, triggering a permit in many jurisdictions. For B, IFC Table 3206.2 allows small quantities of combustible commodities like baled cotton (100 cu. ft. is minimal) without a permit unless part of a larger high-piled storage operation. For C, fruit ripening with CO2 (Section 105.6.13) requires a permit only for specific flammable gases, not CO2 alone, which is nonflammable. For D, organic coating production (Section
105.6.33) requires a permit only above 1 gallon per day, but 2 gallons is still small-scale and context- dependent-lumber storage is the clearer permit trigger here. Thus, A is the best answer.
Reference: IFC 2021, Section 105.6 (Required Operational Permits), Section 3206.2 (High-Piled Storage).
質問 # 57
A building occupied for aerosol storage shall be classified as which of the following occupancy classifications?
正解：D
解説：
IFC Section 3804.1 classifies aerosol storage as Group H (high-hazard) if flammable, fitting option A.
Options B and C are subgroups (H-2, H-3), while D (Group S-1) is for moderate-hazard storage, not applicable. This is consistent with the study guide's occupancy classifications.
References: Fire Inspector II Study Guide, IFC Section 3804.1.
質問 # 58
Refrigeration units or systems having a refrigerant circuit containing Group A1 refrigerant shall be provided with approved emergency signs, charts, and labels in accordance with NFPA 704 when the quantity exceeds
___ lb.
正解：B
解説：
Refrigeration systems and units are regulated under IFC 2021, Section 605 - Refrigeration Equipment, and the requirement for emergency signs, charts, and labels is tied to the NFPA 704 Hazardous Materials Identification System.
IFC 2021, Section 605.12.3 - Signage for Refrigeration Systems:
States that approved emergency signs, charts, and labels must be provided when the refrigerant quantity exceeds 220 pounds for Group A1 refrigerants.
Definition of Group A1 Refrigerants (Low Toxicity, Low Flammability):
Examples include R-134a, R-410A, and R-22, which are commonly used in commercial and industrial HVAC systems.
Why Other Options Are Incorrect?
A: 30 lb. - Too low; labeling requirements do not apply at this threshold.
B: 100 lb. - Incorrect; the IFC requirement specifies 220 lb.
C: 200 lb. - Close, but still below the 220 lb. threshold.
質問 # 59
......
教材をシミュレートするFire-Inspector-IIのページでは、サンプルの質問であるデモを提供しています。デモを提供する目的は、お客様にトピックの私たちの部分を理解してもらうことと、それが開かれたときの学習資料の形式は何ですか？私たちの考えでは、これら2つのことは、Fire-Inspector-II試験に関心のあるお客様が最も心配しているということです。製品ページにアクセスできるクリック可能なWebサイトであるソフトウェアを提供します。 Fire-Inspector-II試験でマークされた赤いボックスはデモです。 PDFバージョンを無料でダウンロードでき、3つの形式すべてをクリックして表示できます。
Fire-Inspector-II認定テキスト: https://www.jpntest.com/shiken/Fire-Inspector-II-mondaishu
ちなみに、JPNTest Fire-Inspector-IIの一部をクラウドストレージからダウンロードできます：https://drive.google.com/open?id=1QpwdDAeL392_peqARcIfFtIW4wmR3O7w