2026 KoreaDumps 최신 H35-580_V2.0 PDF 버전 시험 문제집과 H35-580_V2.0 시험 문제 및 답변 무료 공유: https://drive.google.com/open?id=1Pa_RdxMsZj2unbNPn-gKBF-sIur6v-Sd
KoreaDumps의 Huawei인증 H35-580_V2.0덤프로 시험공부를 하신다면 고객님의 시간은 물론이고 거금을 들여 학원등록하지 않아도 되기에 금전상에서도 많은 절약을 해드리게 됩니다. Huawei인증 H35-580_V2.0덤프 구매의향이 있으시면 무료샘플을 우선 체험해보세요.
| Section | Objectives |
|---|---|
| 5G Performance and Troubleshooting | - Fault diagnosis and optimization methods - Drive test and data analysis |
| 5G Fundamentals | - 5G network architecture and key concepts - 5G NR principles and key technologies |
| Radio Network Optimization (RNO) | - Mobility optimization (handover, cell reselection) - KPI monitoring and analysis - Coverage and interference optimization |
| Radio Network Planning (RNP) | - Capacity planning and dimensioning - Coverage planning principles - Site selection and parameter planning |
>> H35-580_V2.0최신 업데이트 덤프자료 <<
IT업계에 종사하고 계시나요? 최근 유행하는Huawei인증 H35-580_V2.0 IT인증시험에 도전해볼 생각은 없으신지요? IT 인증자격증 취득 의향이 있으시면 저희. KoreaDumps의 Huawei인증 H35-580_V2.0덤프로 시험을 준비하시면 100%시험통과 가능합니다. KoreaDumps의 Huawei인증 H35-580_V2.0덤프는 착한 가격에 고품질을 지닌 최고,최신의 버전입니다. KoreaDumps덤프로 가볼가요?
질문 # 59
In NSA networking, which of the following methods can be used to support X2 interconnection between an eNodeB and a gNodeB?(Select All that Apply)
정답：A,D
설명：
Explanation
According to the 5G EN-DC Architecture and Interfaces, there are two methods that can be used to support X2 interconnection between an eNodeB and a gNodeB in NSA networking:
Interconnection through CI interfaces on the UMPT boards in different subracks: The UMPT is a universal main processing and transmission unit that provides main processing and transmission functions for a subrack. The UMPT has two CI interfaces that can be used for X2 interconnection with other base stations. The CI interfaces support CPRI, OBSAI, and eCPRI protocols and can use optical fibers or electrical cables for transmission. The CI interfaces can be configured as master or slave interfaces depending on the network topology.
IPRAN interconnection between subracks: IPRAN is an IP-based radio access network that uses IP transport technologies to carry base station traffic over Ethernet or MPLS networks. IPRAN can support X2 interconnection betweendifferent base stations by using IP routers or switches. IPRAN can provide flexible networking, high bandwidth, low latency, and high reliability for X2 interconnection.
The other two methods are not valid for X2 interconnection between an eNodeB and a gNodeB:
Interconnection via backplane in a subrack: This method is only applicable for X2 interconnection between two eNodeBs or two gNodeBs that are installed in the same subrack. The backplane is the internal bus that connects different boards within a subrack. The backplane supports CPRI, OBSAI, and eCPRI protocols and can provide high-speed data transmission between boards.
Interconnection through HEI interfaces on the UBBP boards in different subracks: This method is not supported by Huawei base stations. The HEI interface is a high-speed Ethernet interface that is used for data transmission between base stations and core networks or transport networks. The HEI interface supports S1, Xn, F1, E1, and N2 protocols and can use optical fibers or electrical cables for transmission. The HEI interface cannot be used for X2 interconnection between base stations.
Therefore, the correct answer is A and D.
질문 # 60
During uplink scheduling, what is the fixed value of the logical channel guaranteed rate?for each non-GBR logical channel?
정답：C
설명：
The default guaranteed bit rate for non-GBR logical channels is configured as 8 kbps to ensure basic service fairness.
질문 # 61
In RAN3.0, what is the minimum configuration of PDCCH bandwidth in a cell-specific BWP?
정답：A
설명：
The minimum configurable PDCCH bandwidth within a cell-specific BWP is 6 Resource Blocks.
질문 # 62
Under the same gNodeB, an NR TDD cell supports the same maximum number of RRC_CONNECTED UEs as an NR FDD cell.
정답：A
설명：
Explanation
According to the Radio Resource Control, the maximum number of RRC_CONNECTED UEs depends on the number of available C-RNTIs (Cell Radio Network Temporary Identifiers) in a cell. The number of C-RNTIs is limited by the size of the RNTI field in the DCI (Downlink Control Information) format. For NR TDD cells, the RNTI field size is 16 bits, which allows up to 65,536 C-RNTIs. For NR FDD cells, the RNTI field size is
14 bits, which allows up to 16,384 C-RNTIs. Therefore, an NR TDD cell can support more RRC_CONNECTED UEs than an NR FDD cell under the same gNodeB.
질문 # 63
In the Option 3X architecture, if the SgNB addition process is triggered, how many user plane tunnels will be established on the X2-U interface at most?
정답：D
설명：
During SgNB addition, up to three X2-U tunnels may be established depending on bearer configuration and split bearer requirements.
질문 # 64
......
KoreaDumps는 모든 IT관련 인증시험자료를 제공할 수 있는 사이트입니다. 우리KoreaDumps는 여러분들한테 최고 최신의 자료를 제공합니다. KoreaDumps을 선택함으로 여러분은 이미Huawei H35-580_V2.0시험을 패스하였습니다. 우리 자료로 여러분은 충분히Huawei H35-580_V2.0를 패스할 수 있습니다. 만약 시험에서 떨어지셨다면 우리는 백프로 환불은 약속합니다. 그리고 갱신이 된 최신자료를 보내드립니다. 하지만 이런사례는 거이 없었습니다.모두 한번에 패스하였기 때문이죠. KoreaDumps는 여러분이Huawei H35-580_V2.0인증시험 패스와 추후사업에 모두 도움이 되겠습니다. Pass4Tes의 선택이야말로 여러분의 현명한 선택이라고 볼수 있습니다. Pass4Tes선택으로 여러분은 시간도 절약하고 돈도 절약하는 일석이조의 득을 얻을수 있습니다. 또한 구매후 일년무료 업데이트버전을 바을수 있는 기회를 얻을수 있습니다.
H35-580_V2.0인증시험 인기 덤프자료: https://www.koreadumps.com/H35-580_V2.0_exam-braindumps.html
참고: KoreaDumps에서 Google Drive로 공유하는 무료 2026 Huawei H35-580_V2.0 시험 문제집이 있습니다: https://drive.google.com/open?id=1Pa_RdxMsZj2unbNPn-gKBF-sIur6v-Sd