100% Pass Quiz H35-831 - HCIE-Datacom-Carrier (Written) V1.0 Authoritative Valid Test Testking

Are you staying up for the H35-831 exam day and night? Do you have no free time to contact with your friends and families because of preparing for the exam? Are you tired of preparing for different kinds of exams? If your answer is yes, please buy our H35-831 Exam Questions, which is equipped with a high quality. We can make sure that our products have the ability to help you pass the exam and get the according H35-831 certification.

Huawei H35-831 Exam Syllabus Topics:

SectionWeightObjectives
High Reliability8%- Network redundancy mechanisms
- Fault detection and recovery
- Fast protection switching
IP Mobile Backhaul10%- Synchronization and timing
- 5G/4G backhaul architecture
- Service isolation and QoS
Tunnel Technologies15%- MPLS fundamentals
- TE and traffic engineering
- SR-MPLS and SRv6
Automatic O&M2%- Fault management
- Monitoring and analysis
Backbone Network Planning8%- Architecture design
- Scalability design
- Capacity and traffic planning
Network Orchestration & Automation2%- SDN and controller architecture
- iMaster NCE overview
Cloud Bearer Network8%- DC interconnect technologies
- Cloud service bearer requirements
- Cloud interconnection architecture
Multicast Protocols6%- Multicast QoS
- PIM-SM/SSM
- MSDP and anycast RP
VPN Technologies15%- EVPN and VXLAN
- VPN deployment and troubleshooting
- MPLS L3VPN
Advanced Routing Protocols15%- IS-IS advanced features
- Route control and fast convergence
- BGP and MP-BGP
- OSPF advanced features

>> H35-831 Valid Test Testking <<

Huawei H35-831 Exam Preview, Valid H35-831 Test Notes

In modern society, you cannot support yourself if you stop learning. That means you must work hard to learn useful knowledge in order to survive especially in your daily work. Our H35-831 study materials are filled with useful knowledge, which will broaden your horizons and update your skills. Lack of the knowledge cannot help you accomplish the tasks efficiently. If you are still in colleges, it is a good chance to learn the knowledge of the H35-831 Study Materials because you have much time.

Huawei HCIE-Datacom-Carrier (Written) V1.0 Sample Questions (Q58-Q63):

NEW QUESTION # 58
Which of the following statements about BGP RRs is incorrect?

Answer: D

Explanation:
Huawei Reference Verification:
Huawei defines a route reflector as an IBGP router that advertises eligible routes to other IBGP peers according to client and non-client relationships, reducing the need for a full mesh among all routers. A route reflector can itself operate as a client of a higher-level reflector, allowing hierarchies designed for large transport networks. The BGP protocol specifies loop-prevention information such as Originator ID and Cluster List but does not impose a universal maximum of three RR hierarchy levels. Hence B, which asserts a fixed three-level limit, is incorrect. The other statements describe common flat RR deployment rules, assuming route policies permit advertisement.
Technical Deep Dive:
B is incorrect. Ordinary IBGP split-horizon behavior prevents a route learned from one IBGP neighbor being readvertised to another ordinary IBGP neighbor. RRs relax this rule for their client relationships to reduce session count. An RR reflects client-learned routes to its clients and non-clients, and eligible non-client- learned routes to clients. Non-clients in a conventional flat RR model still require suitable full-mesh connectivity, and RRs in different flat clusters often maintain full-mesh IBGP sessions. Externally learned routes can be advertised to eligible IBGP clients and non-clients, subject to policy. More than three RR tiers are possible in the protocol, although excessive hierarchy can increase path-selection complexity and convergence time. Route-reflection loop prevention uses Originator ID and Cluster List. Thus three tiers may be a particular operator's design recommendation but not a universal technical limitation.
#######################################################


NEW QUESTION # 59
Which of the following statements is not correct regarding the traditional metro network architecture?

Answer: C

Explanation:
Huawei Reference Verification:
Huawei carrier architectures distinguish subscriber service-edge functions, network transport, and backbone routing. Broadband gateways commonly supply subscriber service management, SRs provide VPN and business connectivity, OLTs aggregate optical subscribers, and CRs provide backbone connectivity. The logical routing design is independent of the physical interconnection design: simply connecting MSEs and SRs to a municipal CR does not determine that all three must belong to one AS. BGP autonomous-system membership is an operator-specific logical design choice. Consequently the common-AS assertion in C is inconsistent with the intended traditional metro-network diagram, though a shared AS could be a legitimate design in another topology.
Technical Deep Dive:
C is the intended incorrect statement. An MSE ordinarily provides HSI, VoIP, IPTV and subscriber management. The SR is a service-routing aggregation node commonly serving enterprise VPN connectivity; the CR aggregates and transports metro traffic toward the backbone; the OLT aggregates PON subscribers and uplinks to an MSE or suitable routing equipment. 4G backhaul and fixed services can share physical transport when traffic isolation, bandwidth engineering, and QoS are properly designed. What makes C problematic is treating a same-AS relationship as an intrinsic consequence of the MSE/SR/CR topology.
Devices connected by physical or logical links can exchange routes through EBGP across distinct autonomous systems, or they may use IBGP and an IGP within one AS. This question assumes a particular Huawei metro- AS deployment. Under that assumed deployment C is incorrect; outside it, the statement is not universally impossible. The architectural premise is essential to a rigorous interpretation.
#######################################################


NEW QUESTION # 60
The topology shown is a typical transport-network access-layer structure. Each core-network device is dual- homed to two CEs, and the CEs and PEs are interconnected in a square-loop topology. The access layer must carry voice and signaling services. Two VPN instances must be configured on each CE to isolate voice services from signaling services and provide security and QoS. Signaling services are transmitted in active
/standby mode, while voice services are transmitted in load-balancing mode. VRRP must be enabled between the two CEs to terminate signaling flows. From the perspectives of network robustness and architectural suitability, which statements about this topology are correct?

Exhibit 60.1 - Original topology/configuration figure
Select all that apply.

Answer: B,D

Explanation:
Huawei Reference Verification:
Huawei's square-loop carrier access design uses dual-homed CEs and redundant PEs to maintain voice and signaling service reachability during individual failures. Separate VPN instances protect service isolation and enable differentiated QoS. A CE-to-CE link must have sufficient engineered bandwidth to carry the traffic diverted to it during failure conditions; a conservative recommendation is capacity at least as large as the relevant CE-PE interconnection. Higher-volume media services can be mapped to GE and lower-volume signaling services to FE in the intended equipment layout. GE and FE ports cannot simply be mixed in one conventional Eth-Trunk, and choosing GE rather than POS for every CE-PE connection is not an unconditional rule. Thus C and D are the intended topology choices.
Technical Deep Dive:
C and D are the intended answers. The topology has two CEs connected to redundant PEs, with a square-loop design and separate voice/media and signaling VPN instances. VRRP provides active/standby gateway behavior for the signaling service, while voice media can use load-balanced forwarding according to service design. During a CE-PE failure the surviving CE-to-CE connection may carry diverted traffic; the inter-CE link should be sized to the expected failure-state traffic, and engineering it to at least the CE-PE bandwidth is a conservative design objective. GE has higher capacity and is suitable for voice/media concentration, while FE may suffice for the smaller signaling load. Option A incorrectly presents GE-only CE-PE transport as mandatory; POS may also carry routed transport services when appropriate. Option B incorrectly proposes mixing GE and FE links as Eth-Trunk members despite compatibility and rate requirements. QoS priorities and bandwidth reservations must also preserve low latency and low jitter for real-time services. Neither C nor D is a universal physical law: capacity and interface rates should match measured worst-case failure traffic and service requirements.


NEW QUESTION # 61
In the network shown, RTA is in AS 100 and forms an EBGP peer relationship with RTB. RTB, RTC, RTD, RTE, and RTF are in AS 200. RTB, RTD, and RTE are also in sub-AS 65001, RTC is also in sub-AS 65002, and RTF is also in sub-AS 65003.
1. RTA imports route 1.1.1.1/32. What is the route's AS_Path after RTF receives it?
2. RTC imports route 3.3.3.3/32. What is the route's AS_Path after RTA receives it?
3. RTC imports route 3.3.3.3/32. What is the route's AS_Path after RTE receives it?

Exhibit 29.1 - Original topology/configuration figure

Answer: B

Explanation:
Huawei Reference Verification:
Huawei BGP confederations divide a large public AS into internal member autonomous systems while presenting a single AS identifier to external neighbors. Across member-AS boundaries, the exporting member- AS number is included in an AS_CONFED_SEQUENCE segment, commonly displayed in parentheses.
Confederation path segments are removed when exporting the route outside the confederation and the confederation AS number is used instead. Internal IBGP sessions within one member-AS do not prepend a new member-AS segment. Applying these rules gives (65001) 100 at RTF, 200 at RTA, and (65002) at RTE:
option C.
Technical Deep Dive:
C is correct. The externally visible confederation is AS200, with internal member ASs 65001, 65002 and
65003. For the first prefix RTA in AS100 advertises 1.1.1.1/32 to RTB in member AS65001. When RTB advertises it to RTF in member AS65003, RTB's member number is prepended as a confederation sequence, producing `(65001) 100`. For the second prefix RTC in member AS65002 originates 3.3.3.3/32 and the route crosses to RTB. Exporting it from the confederation toward RTA strips internal confederation segments and exposes AS200, yielding `200`. For the third prefix RTC advertises to RTB, which is in member AS65001.
RTE shares member AS65001 with RTB, so the path remains `(65002)` at RTE. These rules are standardized in RFC 5065 and allow confederation members to retain internal policy flexibility while presenting one coherent AS externally.
#######################################################


NEW QUESTION # 62
In the ONAP framework, which of the following closed-loop automation processes is used to respond to changing network and service conditions?

Answer: D

Explanation:
Exact Extract - Huawei Training Material (Network Orchestration Technologies Overview, p.34):
"Closed-loop automation: responds to network or service conditions without intervention through design, creation, collection, analysis, detection, release, and response." Huawei Reference Verification:
The Huawei ONAP module defines a closed-loop sequence beginning with design-time modeling and creation, followed by collection, analysis, detection, publication and response. ONAP uses SDC for service design and DCAE for operational data gathering and analysis. Collected telemetry and events are analyzed, resulting abnormalities or policy conditions are detected, the outcome is published to policy/orchestration components, and an authorized controller executes remediation. The curriculum diagram explicitly places Analysis before Detect. Thus the exact intended sequence is Design > Create > Collect > Analyze > Detect > Publish > Respond, corresponding to B.
Technical Deep Dive:
B is correct. ONAP separates design-time and run-time actions. During Design, network resources, service templates and closed-loop policies are defined. Create instantiates the specified service and its required network functions. Collect gathers service alarms, metrics and events, with DCAE providing collection infrastructure. Analyze evaluates observations for trends and anomalies; Detect identifies actionable conditions according to rules and policies. Publish distributes the relevant findings to policy and orchestration components, and Respond triggers measures such as service reconfiguration, VNF recovery or path adjustment. The exact order is important: analytical processing precedes identifying and publishing actionable conditions in this curriculum description. An incomplete answer omitting Design, such as A, cannot describe the full lifecycle; C and D change the expected analytic order. Closed-loop operation is designed to reduce the delay between fault observation and corrective action while preserving policy-based control.
#######################################################


NEW QUESTION # 63
......

If you want to get satisfying result in Huawei H35-831 practice test, our online training materials will be the best way to success, which apply to any level of candidates. We guarantee the best deal considering the quality and price of H35-831 Braindumps Pdf that you won't find any better available. Our learning materials also contain detailed explanations expert for correct H35-831 test answers.

H35-831 Exam Preview: https://www.dumpexams.com/H35-831-real-answers.html